2004 Peugeot Partner VU Dag ECU

14YOUR PARTNER AT A GLANCE
OPENING THE BONNET Inside the vehicle:Pull the con-
trol on the left-hand side, under the fascia panel. Outside the vehicle: Lift the control, raise thebonnet and secure thestrut to keep the bonnetopen.
FILLING WITH FUEL This operation must be carried out with
the engine switched off.
 Insert the key then turn it to the left.
 Remove the cap.
An indication shows which type of fuel to use.
When you fill your tank, do not continue after the third cut-off of the pump. This could cause a malfunction. The capacity of the tank is approximately 55 litres for petrol engines and 60 litres for Diesel engines. Note: the right-hand sliding side door cannot be opened while the fuel
tank cap is removed.
Low fuel level warning light From the time this light comes on, you have enough fuel left to cover approximately 30 miles (50 km) .
7069
22-12-2003

YOUR PARTNER IN DETAIL
54
22-12-2003
MULTIFUNCTION PASSENGER SEAT*
To fold the seat back: Pull the control
1upwards and tilt the seat back.
This provides a flat surface, recesses for drinks and a strap for retaining documents.
To fold the seat fully: Pull the control 2upwards and tilt the whole seat.
It is not necessary to remove the head restraint.This provides access to a box which enables you to store objects so that they cannot be seen from outside the vehicle or to wedge long objects passed through the roof flap. If your vehicle is not fitted with a load blocking partition, it can accommodate long objects (up to 2.10 m). These must be placed on the front edge of the instrument panel and secured using the rear bar of the boot or using the lashing rings.
* According to destination.

YOUR PARTNER IN DETAIL55
22-12-2003
LASHING RINGS Use the 6 lashing rings on the lug- gage compartment floor to secureyour loads.
You can use suitable load retainers (half-height partitions, grille, etc.)
supplied by your PEUGEOT dealer.
For greater safety, always
ensure that the
loads transported are
stowed securely.

YOUR PARTNER IN DETAIL57
CHILD SEATS RECOMMENDED BY PEUGEOT
PEUGEOT offers a complete range of child seats which are secured using the seat belt:
Group 0+: from birth to 13 kg L1 - "Britax Babysure": installed in the rear-facing position in the front and in the rear using a three-point seat belt. In the front, it is compulsory to disarm the passenger air bag and the vehicle's seat must be adjusted to the intermediate longitudinal position.
Group 1: from 9 to 18 kg L2 - "Ršmer Prince": installed in the rear using a two or three-point seat belt. For the safety of your child, it is imperative that the restraining cushion is used.
Group 2: from 15 to 25 kg L3 - "Ršmer Vario'': installed in the rear using a two or three-point seat belt.
22-12-2003

YOUR PARTNER IN DETAIL
58
22-12-2003
Groups 2 and 3: from 15 to 36 kg
L4 - "Recaro Start'': installed in the rear using a three-point seat belt. The height and width at the shoulders and length of the seat cushion must be adjusted according to the age and build of your child. L5 - "Klippan Optima": installed in the rear using a three-point seat belt. From the age of 6 years (approximately 22 kg), the booster is used on its own.
Groups 1, 2 and 3: from 9 to 36 kg L6 - "Kiddy Life": installed in the rear using a three-point seat belt.The height and width at the shoulders and the length of the seat cushion must be adjusted according to the age and build of your child.
For the safety of young children (from 9 to 18 kg), PEUGEOT recommends use of the restraining cushion.
Never leave one or more children alone and unsu-pervised in a vehicle. Never leave a child or an
animal in a vehicle which is exposed to the sun and has thewindows closed.
To protect your young children from the sun, fit blinds on the rearwindows. Never leave the keys within reach of children inside the vehi-cle. Observe strictly the recommen- dations for assembling andsecuring the child seat as shownin the child seat instructions.
To prevent the doors from opening
accidentally, use the child lock*. Also, do not open the rear windows more than a third*.
* According to model.
Disarm the passenger air bag when installing a "rearwards facing" child seat on the front passenger seat. Otherwise, the child would risk beingkilled or seriously injured were the air bag to inflate.

YOUR PARTNER IN DETAIL59
SUMMARY TABLE FOR THE INSTALLATION OF CHILD SEATS In accordance with European regulations (Directive 2000/3), the table below indicates the options for the installation of child seats secured using the seat belt and universally approved (child seats which can be installed in all vehicles using a seatbelt), in accordance with the weight of the child and the seat in the vehicle:
U : seat suitable for the installation of a child seat secured using the seat belt and "universally" approved. "Rear facing" and "forward facing" child seats.
(a) Group 0 : from birth to 10 kg.
(b) The rules for transporting children on the front passenger seat are specific to each country. Consult the legislation in for ce
in your country. Regulation weight group
Seat
Weight below 13 kg Weight from 9 to 18 kg Weight from 15 to 25 kg Weight from 22 to 36 kg
(groups 0 (a) and 0+) (group 1) (group 2) (group 3) From birth to 1 year From 1 to 3 years From 3 to 6 years From 6 to 10 years approx. approx. approx. approx.
Front passenger seat (b) UU UU
22-12-2003

22-12-2003
YOUR PARTNER IN DETAIL
68
REAR ROOF FLAP
To open the rear flap:
Ð pull the lever A,
Ð lift the rear flap,
Ð pass the point of resistance to secure it using the retaining struts B.
To close the rear flap:
Ð check that the support bar is secured correctly,
Ð lower the rear flap to lock it. LONG LOAD SUPPORT BAR
A support bar is provided for transporting long loads, after opening the rear roof flap. Fold back the support bar by lifting the lever
C.
Support it to the door pillar. Support the long loads to be transported.Reposition the support bar with one hand.
Ensure that it is secured correctly. Notes:
Ð the side openings Dcan be used as hooking points.
Ð the rear bumper has been strengthened to serve as a footrest on entering the vehicle.
Never drive without the support bar in place. The rear doors only lock when the support bar is installed.When the rear roof flap is open, take care when driving under over- hangs of limited height.
Use a regulation device when a load protrudes from your vehicle by more thanone metre. Never rest a load directly on the rear doors.

YOUR PARTNER IN DETAIL69
22-12-2003
OPENING THE BONNET Inside the vehicle:
pull the handle on
the left-hand side, under the fascia. Outside the vehicle: lift the catch
and raise the bonnet. BONNET STRUT Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is locked.