2004 Peugeot Partner VP lights

22-12-2003
3YOUR PARTNER AT A GLANCE
1 -Speaker (tweeter).
2 - Windscreen demisting vents.
3 - Controls:- Electric windows.
- Demisting of rear door
windows or tailgate.
- Air conditioning.
- ASR/ESP.
4 - Central locking button.
5 - Multifunction display or clock.
6 - Hazard lights button.
7 - Central adjustable heating/ventilation vents.
8 - Lights and direction indica-tors stalk.
9 - Cruise control.
10 - Instrument panel.
11 - Driver's air bag.Horn. 12 -
Windscreen wash-wipe stalk.
13 - Audio equipment steeringwheel control.
14 - Steering lock and ignition.
15 - Fuse box.
16 - Passenger air bag disar-ming control*.
17 - Steering wheel adjustmentcontrol.
18 - Passenger's electric mirrorcontrol.
19 - Headlamp height adjustment.
20 - Heated seats control.
21 - Handbrake.
22 - 12 V accessories socket.
23 - Removable ashtray.
24 - Lighter.
25 - Storage.
26 - Gear lever. 27 -
Heating/air conditioningcontrols.
28 - Audio RB3 or RD3.
29 - Lower glove box.
30 - Upper glove box or passenger air bag.
31 - Bonnet release.
32 - Side adjustableheating/ventilation vents.
33 - Side window demistingvents.
* According to country.

22-12-2003
4THE KEYS The keys allow you to switch on the ignition and operate thepassenger air bag disarmingswitch, as well as to indepen-dently operate the locks on thedoors and the fuel filler cap. Central locking From the front doors, the keys allow you to lock and unlock thedoors and tailgate. If one of the doors or the tailgate is open, it is impossible to opera-te the central locking. The remote control performs the same functions at a distance. The remote control Locking Press button
Ato lock the vehicle.
This is confirmed by fixed lighting of the direction indicators forapproximately two seconds. Unlocking Press button Bto unlock the
vehicle. This is confirmed by rapid flashing of the direction indicators. Locating the vehicle
To locate your vehicle, previous- ly locked, in a car park:  press button A, the courtesy
lights come on and the direc- tion indicators flash for a fewseconds. STARTING
STOP position (S):
the ignition is off.
1st notch, Accessories position (A):
the ignition is off but the acces- sories can be used. 2nd notch, Running position (M): the ignition is on. Starting position (D):
operates the starter.YOUR PARTNER AT A GLANCE
63

5YOUR PARTNER AT A GLANCE
22-12-2003
STEERING WHEEL
STALKS LIGHTING
Front and rear lights (ring A)Lights off Side lights
Dipped beam / Main beam
Vehicles fitted with a rear fog lamp (ring B)
Turn the ring forwards.
Vehicles fitted withfront fog lamps and arear fog lamp (ring B)
Front fog lamps (1st turn of thering forwards). Front fog lamps and rear fog lamp (2nd turn of the ring forwards).
To switch off: turn the ring rear- wards.
WINDSCREEN WIPERS Front 2 Rapid wipe (heavy rain).
1 Normal wipe (moderate rain).
I Intermittent wipe.
0 Off.
Single wipe.
Windscreen wash-wipe:pull the stalk towardsyou. Rear
Off Intermittent Wash- wipe wipe
73
74

22-12-2003
SERVICE INDICATOR This is a visual reminder of when the
next service is due. This service is tobe carried out according to themanufacturer's servicing schedule. Operation As soon as the ignition is switched on and for 5 seconds, the spannersymbolising ''service operation'' is lit.The trip recorder display shows thedistance remaining (in round figures)before the next service. Example:4,800 miles/km remain
before the next service is due. When the ignition comes on and for 5 seconds the display indicates: 5 seconds after the ignition is swit- ched on, the total distance recorderresumes normal operation and thedisplay shows the total or trip dis-tances. The distance remaining before thenext service is less than 500 miles(1,000 km). Example:
400 miles (900 km)
remain before the next service is due. When switching on the ignition and for 5 seconds, the display shows: 5 seconds after the ignition is swit- ched on, the total distance recorderresumes normal operation and thesymbol remains lit. This indicates that a service should
be carried out shortly. The displayshows the total or trip distances. The service is overdue. Each time the ignition is switched on and for 5 seconds, the symbol andthe excess distance flash. Example:
the service is overdue by
300 miles/km. The service should be
carried out very shortly. When the ignition is switched on and for 5 seconds, the display shows: 5 seconds after the ignition is swit- ched on, the total distance recorderresumes normal operation and the
symbol remains lit. The displayshows the total or trip distances. Note: the service spanner lights if
the two-year interval has been exceeded (see "PEUGEOTServicing" section).
PEUGEOT SERVICING
20

22-12-2003
PEUGEOT SERVICING25
A AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
Level
Operations Description of operation1st serviceA C Intermediate
DRAIN/REFILL- Engine oil- Bleed fuel filter (diesel)- Oil filter- Petrol filter* (according to engine)REPLACE- Diesel filter or element (according to engine)- Air filter element- Spark plugs (petrol)- Engine oil (check + top-up)- Manual gearbox oil (check + top-up)- Battery (check + top-up) if cap is removableLEVEL- Screen wash (check + top-up)- Coolant (check + top-up)- Brake fluid (check + top-up)- Power steering fluid (check + top up according to specification)- Operation of lights and indicators- Condition of glass, headlamp and light lenses and mirrors- Horn- Windscreen washer jets- Condition of wiper blades- Condition and tension of the ancillary drive belts- Handbrake- Condition of hydraulic circuits (hoses and covers)CHECK- Condition of rubber boots and gaiters- Brake pads - Play in hubs, link rods, ball joints, flexible mountings- Shock absorbers- Rear drum brake lining wear- Condition and pressure of tyres (including spare wheel)- Emission control check as per current legislation (petrol)- Smoke opacity (diesel)- Passenger compartment filter (according to specification) - Visual check of the whole vehicle
SERVICE*- Courtesy vehicleROAD TEST
: All driving conditions.: Arduous conditions. * According to destination.

Handbrake, low brake fluid level andElectronic BrakeForce Distribution
system fault warning light
Linked to the central (STOP) war- ning light. This indicates one of the following:
- that the handbrake is applied or not fully released,
- an excessive drop in brake fluid level (if the warning light remains on even when the handbrake isreleased),
- a fault in the Electronic Brake Force Distribution system, if lit at
the same time as the ABS war-ning light.
You must stop.
Consult a PEUGEOT dealer.
INSTRUMENTS ANDCONTROLS
A permanently lit warning light or one flashing, with the engine run-ning, indicates an operating faultof the unit concerned. The illumi-nation of certain warning lightsmay be accompanied by anaudible signal and a message on
the multifunction display. Do notignore this warning: consult aPEUGEOT dealer as soon as pos-sible.
If the central STOP warning light comes on when you are driving,
stop your vehicle immediately,where it is safe to do so.
Anti-lock brakingsystem (ABS) warninglight
This comes on for a few secondseach time the ignition is switchedon. If the warning light remains on or comes on above 8 mph (12 km/h),
this indicates an ABS malfunction.
However, the vehicle retains conven- tional servo-assisted braking. Lighting of this warning light, accom- panied by an audible signal, indi-
cates an ABS fault.
Consult a PEUGEOT dealer.
Diesel engine low coolant level warninglight
Linked to the central (STOP) war-ning light.
You must stop.
Wait for the engine to cool before topping up the level. The cooling circuit is pressurised.In the event of breakdown and to prevent any risk of burns , unscrew
the cap by two turns to allow thepressure to drop. When the pressure has dropped, remove the cap and top up the level.
Consult a PEUGEOT dealer.
Central (STOP) warning light
Linked to the warning lights:
- "engine oil pressure and tempera- ture'',
- "low coolant level'',
- "handbrake'',
- "low brake fluid level'',
- "electronic brake force distribution system fault''.
Linked with the "coolant tempera-
ture" indicator.
You must stop if the light flashes with the engine running.
Consult a PEUGEOT dealer.
Engine oil pressureand temperaturewarning light
Linked to the central (STOP) war-ning light.
You must stop.
This warning light indicates one ofthe following:
- insufficient oil pressure,
- a lack of oil in the lubrication cir- cuit. Top up the level.
- an oil temperature which is too high. The warning light is acom-
panied by an audible signal. Tolower the oil temperature, reduceyour speed.
Consult a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS 29
22-12-2003

22-12-2003
Total distance recorder Briefly pressing button 1alternates
between the total and trip distance displays.
To reset the trip recorder to zero, when it is displayed press button 1
until zeros appear. Lighting rheostat With the lights on, press the button to vary the intensity of the lighting ofthe instruments and controls. Whenthe lighting reaches the minimum (ormaximum) setting, release the but-ton then press it again to increase(or reduce) the brightness. As soon as the lighting is of the required brightness, release the button.
INSTRUMENTS AND CONTROLS
32

YOUR PARTNER IN DETAIL63
THE KEYS The keys allow you to switch on the ignition and operate the passengerair bag disarming switch as well as toindependently operate the locks onthe doors and the fuel filler cap. Central locking From the front doors, the keys allow you to lock and unlock the doors andtailgate. If one of the doors or the tailgate is open, the central locking does notwork. The remote control performs the same functions at a distance.The remote control Locking Press button
Ato lock the vehicle.
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. Unlocking Press button Bto unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. Note: if the vehicle is locked and
unlocking is activated inadvertently, unless the doors are opened within30 seconds, the vehicle will lock
automatically. Locating your vehicle
To locate your vehicle, if you have locked it, in a car park:  press button A, the courtesy
lights come on and the direction indicators flash for a fewseconds.
Changing the battery of the remote control The information "battery flat" is given by an audible signal accompanied by the message "Remote control
battery flat" on the screen.
To change the battery, unclip thecasing using a coin at the ring (CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,re-programme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately for a
few seconds.
 Switch off the ignition and remo- ve the remote control key from
the ignition lock. The remotecontrol is now working again.
22-12-2003