2004 NISSAN MURANO driver seat adjustment

Forward and backwardPull the lever up while you slide the seat forward
or backward to the desired position. Release the
lever to lock the seat in position.
RecliningTo recline the seatback, pull the lever up and
lean back. To bring the seatback forward again,
pull the lever and move your body forward. The
seatback moves forward.
The reclining feature allows adjustment of the
seatback for occupants of different sizes to help
obtain proper seat belt fit. (See “Precautions on
seat belt usage” later in this section.) The seat-
back may also be reclined to allow occupants to
rest when the vehicle is parked.
FRONT POWER SEAT
ADJUSTMENT
WARNING

Do not adjust the driver’s seat while
driving so full attention may be given
to vehicle operation.

Do not leave children unattended in-
side the vehicle. They could unknow-
ingly activate switches or controls.
Unattended children could become
involved in serious accidents.Operating tips
The seat motor has an auto-reset overload
protection circuit. If the motor stops during
operation, wait 30 seconds, then reactivate
the switch.

Do not operate the power support seat
for a long period of time when the engine is
off. This will discharge the battery.
See “Automatic drive positioner” in the “3. Pre-
driving checks and adjustments” for automatic
seat positioner operation.
SSS0179Seats, restraints and supplemental air bag systems
1-3


04.4.5/Z50-D/V5.0


Forward and backwardMoving the switch forward or backward will slide
the seat forward or backward to the desired
position.
RecliningMove the recline switch backward until the
desired angle is obtained. To bring the seatback
forward again, move the switch forward and
move your body forward. The seatback will move
forward.
The reclining feature allows adjustment of the
seatback for occupants of different sizes to help
obtain proper seat belt fit. (See “Precautions on
seat belt usage” later in this section.) The seat-
back may also be reclined to allow occupants to
rest when the vehicle is parked.
Seat lifter (if so equipped for driver’s
seat)Push the front or rear end of the switch up or
down to adjust the angle and height of the seat.
SSS0148
SSS0166
1-4
Seats, restraints and supplemental air bag systems


04.4.5/Z50-D/V5.0


Lumbar support (if so equipped for
driver’s seat)The lumbar support feature provides lower back
support to the driver. Push each side of the
switch to adjust the seat lumbar area.
REAR SEAT ADJUSTMENT
Folding1. Secure the seat belt at the belt hooks on the
side wall. See “Seat belt hook” later in this
section.
2. Secure the center seat belt and tongues into
the retractor base. See “Stowing rear center
seat belt” later in this section.
3. Put the seat belt buckles into the seat cush-
ion.
See “Storing rear seat belt buckles” later in
this section.4. Remove the head restraints.
5. After closing the tonneau subcover (if so
equipped) from each rear seatback, pull the
strap on the rear seat
Aor pull the lever
B
beside the cargo area and fold the seatback.
6. When returning the seatbacks, be sure to
install the head restraints and attach the rear
center seat belt connector.
WARNING

Never allow anyone to ride in the
cargo area or on the rear seat when it
is in the fold-down position. Use of
these areas by passengers without
proper restraints could result in seri-
ous injury in an accident or sudden
stop.

It is extremely dangerous to ride in a
cargo area inside of a vehicle. In a
collision, people riding in these areas
are more likely to be seriously in-
jured or killed.

Do not allow people to ride in any
area of your vehicle that is not
equipped with seats and seat belts.
SSS0280
SSS0226Seats, restraints and supplemental air bag systems
1-5


04.4.5/Z50-D/V5.0


WARNING

Always have the doors locked while
driving. Along with the use of seat
belts, this provides greater safety in
the event of an accident by helping to
prevent persons from being thrown
from the vehicle. This also helps keep
children and others from uninten-
tionally opening the doors, and will
help keep out intruders.

Before opening any door, always
look for and avoid oncoming traffic.

Do not leave children unattended in-
side the vehicle. They could unknow-
ingly activate switches or controls.
Unattended children could become
involved in serious accidents.
LOCKING WITH KEY
PowerThe power door lock system allows you to lock
or unlock all doors simultaneously.

Turning the driver’s door key to the front of
the vehicle will lock all doors (including the
back door) and fuel filler lid.

Turning the driver’s door key one time to the
rear of the vehicle will unlock the driver’s
door. From that position, returning the key to
neutral (where the key can only be removed
and inserted) and turning it to the rear againwithin 5 seconds will unlock all doors and fuel
filler lid.
Opening and closing front windowsTurn the driver’s door key to the unlock position
and hold for about 1 second, the front windows
will begin to lower.
To stop opening, turn the key to the neutral
position.
To close the front windows with the door key
cylinder, turn the key to the lock position and
hold for about 1 second.
To stop closing, turn the key to the neutral
position.
In the event of a hand in the way, or other
obstruction, the auto reverse function will acti-
vate.
SPA1575
DOORS
Pre-driving checks and adjustments
3-3


04.4.5/Z50-D/V5.0


ignition switch is in the ACC or ON position.
Move the switch to right
A
or left
B
to select
the right or left outside mirror, then adjust the
mirror to the desired position by pushing the
button
C.
Foldable outside mirrorsFold the outside mirror by pushing it toward the
rear of the vehicle.The automatic drive positioner system has two
features:

Entry/exit function

Memory storage
ENTRY/EXIT FUNCTIONThis system is designed so that the driver’s seat,
pedals (Brake, Accelerator) and outside mirrors
will automatically move when the selector lever is
in the P (Park) position. This allows the driver to
get into and out of the driver’s seat more easily.
The driver’s seat will slide backward:

When the key is removed from the ignition
switch.

When the driver’s door is opened with the
key turned to LOCK.

When the key is turned from ACC to LOCK
with the driver’s door open while the selector
lever is in the P (Park) position.
The driver’s seat will return to the previous
position:

When the key is inserted into the ignition
switch.

When the driver’s door is closed with the key
turned to LOCK.

When the key is turned from ACC to ON
MPA0008
AUTOMATIC DRIVE POSITIONER
(if so equipped)
3-16
Pre-driving checks and adjustments


04.4.5/Z50-D/V5.0


while the selector lever is in the P (Park)
position.
The entry/exit feature can be adjusted or can-
celed. See “Display screen, heater, air condi-
tioner and audio systems” section of this manual.
MEMORY STORAGETwo positions for the driver’s seat, pedals (Brake
and Accelerator) and outside mirrors can be
stored in the automatic drive positioner memory.
Follow these procedures to use the memory
system.
1. Set the selector lever to the P (Park) position.
2. Turn the ignition ON.
3. Adjust the driver’s seat, pedals (Brake and
Accelerator) and outside mirrors to the de-
sired positions by manually operating each
adjusting switch. For additional information,
see “Seats” in the “Safety — Seats, seat beltsand supplemental air bags” section and
“Pedal position adjustment” and “Outside
mirrors” earlier in this section.
During this step, do not turn the ignition to
any positions other than ON.
4. Push the SET switch and, within 5 seconds,
push the memory switch (1 or 2) fully for at
least 1 second.
The indicator light for the pushed memory
switch will come on and stay on for approxi-
mately 5 seconds after pushing the switch.
After the indicator light goes off, the selected
positions are stored in the selected memory
(1 or 2).
If memory is stored in the same memory switch,
the previous memory will be deleted.
Linking a keyfobto a stored memory
positionA keyfobcan be linked to a stored memory
position with the following procedure.
1. Follow the steps for storing a memory posi-
tion.
2. While the indicator light for the memory
switch being set is illuminated for 5 seconds,
press the unlock button on the keyfob. The
indicator light will blink. After the indicator
SPA1584
Pre-driving checks and adjustments
3-17


04.4.5/Z50-D/V5.0


light goes off, the keyfobis linked to that
memory setting.
With the key removed from the ignition switch,
press the unlock button on the keyfob. The
driver’s seat, pedals (Brake and Accelerator)
and outside mirrors will move to the memorized
position.
Confirming memory storage
Turn the ignition ON and push the SET
switch. If the main memory has not been
stored, the indicator light will come on for
approximately 0.5 seconds. When the
memory has stored the position, the indicator
light will stay on for approximately 5 seconds.

If the battery cable is disconnected, or if the
fuse blows, the memory will be canceled. In
such a case, reset the desired positions
using the following procedures.
1. Open and close the driver’s door more than
two times with the ignition key in the LOCK
position.
2. Reset the desired position using the previous
procedure.Selecting the memorized position1. Set the sift selector lever to the P (Park)
position.2. Turn the ignition ON.
3. Push the memory switch (1 or 2) fully for at
least 1 second.
The driver’s seat, pedals (Brake and Accel-
erator) and outside mirrors will move to the
memorized position with the indicator light
flashing, and then the light will stay on for
approximately 5 seconds.
SYSTEM OPERATIONThe automatic drive positioner system will not
work or will stop operating under the following
conditions:

when the vehicle speed is above 4 MPH (7
km/h).

when any two or more of the memory
switches are simultaneously pushed while
the automatic drive positioner is operating.

when the adjusting switch for the driver’s
seat is turned on while the automatic drive
positioner is operating.

when the memory switch (1 or 2) is not
pushed for at least 1 second.

when the seat has been already moved to the
memorized position.

when no seat position is stored in the
memory switch.
3-18
Pre-driving checks and adjustments


04.4.5/Z50-D/V5.0


R
Radio, Car phone or CB radio .............................. 4-33
Readiness for inspection/maintenance (I/M) test (US
only) .............................................................................. 9-23
Rear center seat belt................................................ 1-29
Rear door lock, Child safety rear door lock.......... 3-4
Rear light ..................................................................... 2-37
Rear power point....................................................... 2-27
Rear seat adjustment .................................................. 1-5
Rear window and outside mirror defroster
switch ........................................................................... 2-19
Rear window wiper and washer switch .............. 2-19
Recorders, Event data ............................................. 9-24
Registering your vehicle in another country ....... 9-10
Remote keyless entry system ................................... 3-5
Reporting safety defects (US only) ...................... 9-23
S
Safety
Child seat belts ................................................... 1-24
Reporting safety defects (US only)................ 9-23
Towing safety....................................................... 9-19
Safety chain ................................................................ 9-20
Seat
Belt warning light................................................ 1-22
Belt warning light and chime ........................... 2-11
Seat adjustment
Front power seat adjustment ............................. 1-3
Front seat adjustment .......................................... 1-2
Rear seat adjustment ........................................... 1-5Seat belt(s)
Child safety .......................................................... 1-24
Infants and small children ................................. 1-24
Injured persons.................................................... 1-25
Larger children .................................................... 1-24
Pre-tensioner seat belt system ....................... 1-19
Precautions on seat belt usage ...................... 1-22
Pregnant women ................................................. 1-25
Rear center seat belt ......................................... 1-29
Seat belt cleaning ................................................. 7-4
Seat belt extenders ............................................ 1-31
Seat belt hook ..................................................... 1-28
Seat belt maintenance ...................................... 1-32
Seat belts ............................................................. 1-22
Shoulder belt height adjustment..................... 1-28
Three-point type with retractor ....................... 1-25
Seat(s)
Driver-side memory ............................................ 3-16
Heated seats........................................................ 2-26
Seats ........................................................................ 1-2
Security system, Vehicle security system ........... 2-16
Security systems (Nissan Vehicle Immobilizer
System), Engine start ............................................... 2-17
Security systems (See vehicle security
system) ......................................................................... 2-16
Servicing air conditioner .............................. 4-16, 4-20
Shift lock release ........................................... 5-13, 5-17
Shifting, CVT (Continuously Variable
Transmission) ............................................................. 5-10
Shoulder belt height adjustment ........................... 1-28
Spare tire..................................................................... 8-35
Spark plugs................................................................. 8-16
Speedometer ................................................................ 2-4Starting
Before starting the engine .................................. 5-9
Jump starting .......................................................... 6-8
Precautions when starting and driving ............ 5-2
Push starting ........................................................ 6-10
Starting the engine............................................. 5-10
Steering
Power steering fluid ........................................... 8-12
Power steering system ...................................... 5-27
Tilting steering wheel......................................... 3-13
Steering switch for audio control.......................... 4-32
Storage ........................................................................ 2-28
Sun shade ................................................................... 2-36
Sun visors ................................................................... 3-14
Sunroof ........................................................................ 2-35
Automatic sunroof .............................................. 2-35
Supplemental air bag warning labels................... 1-20
Supplemental air bag warning light .......... 1-20, 2-12
Supplemental restraint system ................................. 1-9
Precautions on supplemental restraint
system ...................................................................... 1-9
Switch
Autolight switch .................................................. 2-21
AWD lock switch operations........................... 5-23
Fog light switch................................................... 2-24
Hazard warning flasher switch ........................ 2-25
Headlight aiming control ................................... 2-23
Headlight switch ................................................. 2-20
Ignition switch ........................................................ 5-8
Power door lock switch....................................... 3-4
Rear window and outside mirror defroster
switch..................................................................... 2-19
Turn signal switch .............................................. 2-24
Vehicle dynamic control (VDC) off switch ... 2-27


04.4.5/Z50-D/V5.0

10-5