GENERAL INFORMATION
Installation of accessories
EB24A-E
Before fitting any accessories, please con-
sult your authorized MITSUBISHI dealer.
(1) The installation of accessories, op-
tional parts, etc., should only be car-
ried out within the limits prescribed by
law in your country, and in accord-
ance with the guidelines and warn-
ings contained within the documents
accompanying this vehicle.
Only MITSUBISHI approved acces-
sories should be fitted to your vehicle.
(2) Improper installation of electrical
parts could cause fire, please refer to
the Modification/Alteration to the elec-
trical or fuel systems section within
this manual.
(3) When using a communication system
such as a cellular phone or a radio set
inside the vehicle, a separate external
antenna must be fitted. When a
cellular phone or a radio set is used
by using an internal antenna alone, it
may interfere with the vehicle’s elec-
trical system and adversely affect
safe operation of the vehicle.
(4) Tyres and wheels which do not meet
specifications must not be used.
Refer to the “Specification” section for
information regarding wheel and tyre
sizes.Consider also that there basically exists
no liability on the part of the appraiser
or the official. Only in the case of parts
(MITSUBISHI original replacement or ex-
change parts as well as MITSUBISHI
accessories) that are recommended and
released by an authorized MITSUBISHI
dealer and that are attached or installed
by an authorized MITSUBISHI dealer can
you assume, that optimal safety has been
provided. The same also pertains to modi-
fications of MITSUBISHI vehicles with re-
spect to the production specifications. For
your own safety, in such cases as well,
you should only undertake modifications
according to the recommendations of an
authorized MITSUBISHI dealer. (5) Do not fail to read all relative instruc-
tions before first putting into service
the attachment or installation of
accessories, parts or other modifica-
tions to the vehicle!
Important points!
Due to the large number of accessory and
replacement parts of different manufac-
turers in the market, it is not possible, not
only for MITSUBISHI, but also for an au-
thorized MITSUBISHI dealer, to check
whether the attachment or installation of
such parts affects the driving safety of
your MITSUBISHI-vehicle.
Even when such parts are officially au-
thorized, for example by a general opera-
tors “permit” (an appraisal for the part) or
through the execution of the part in an offi-
cially approved manner of construction, or
when a single operation permit following
the attachment or installation of such
parts, it cannot be deduced from that
alone, that the driving safety of your vehi-
cles has not been affected.
1-14
01engL2_240082_4 22-01-2004 12:58 Page 1-14
FOR PLEASANT DRIVING
UKW/MW/LW electronic tuning radio with
tape player*
EH30E-E
The audio system can be used when the ignition key is in the “ON”
or “ACC” position.
NOTE
(1) To listen to the audio system while the engine is stopped, turn
the ignition key to the “ACC” position.
(2) When a cellular phone is used inside the vehicle, noise may
be produced from the audio equipment. This does not mean
that something is wrong with the audio equipment. In such a
case, use the cellular phone at a place as far as possible from
the audio equipment.(3) A CD player or a CD autochanger can be connected to this
audio system.
The CD player or the CD autochanger can be operated by
the switch of the audio body. Refer to “To listen to a CD” on
page 6-14.
(4) In case of misuse (entry of a foreign object or water, smoke or
odor, etc.), immediately turn off the audio system and have it
checked at an authorized MITSUBISHI dealer. Never try to
repair it by yourself. Avoid continuous usage without inspec-
tion by a qualified person.
6-2
06engL2_240082_4 22-01-2004 13:07 Page 6-2
10-30
OMRON Corporation
6368 NENJO-ZAKA OKUSA
KOMAKI-CITY
AICHI
485-0802 JAPAN
PHONE: +81-0568-78-6170
FAX: +81-0568-78-6179
DECLARATION of CONFORMITY
We, OMRON Corporation, ELECTRONICS COMPONENTS COMPANY of the above
address, hereby declare, at our sole responsibility, that the following product conforms to the
Essential Requirements of the Radio and Telecommunications Terminal Equipment Directive
1999/5/EC in accordance with the tests conducted to the appropriate requirements of the relevant
standards, as listed herewith.
Product : Keyless Entry System for Vehicle
Model/ Type Number : G8D-407M-A* forTransmitter
G8D-410M-B* for Receiver
G8D-520M-A* forTransmitter
G8C-500M *, G8D-581M-B* for Receiver
(*=Numerical value or alphabet)
Directive and Standards used : Radio :EN 300 220-1 V.1.2.1: 1997
EMC : ETS 300 683: 1997, 95/54/EC & ISO 7637-1:1990
Safety: EN 60065: 1998
Year of affixing CE marking : 2001
Signature :
Name : Takao Matsui
Position : General Manager
Date : 11, JAN. 2001
0891
10engL2_240082_4 22-01-2004 13:14 Page 10-30
