2004 Lexus ES330 Destination Input and Route Guidance / LEXUS 2004 ES330 OWNER'S MANUAL (OM33633U)

ELECTRICAL COMPONENTS
432
ADDING WASHER FLUIDIf the washer tank becomes nearly empty, add washer
fluid.
You may use plain water as washer fluid. However, in cold
areas where temperatures range below the freezing point, use
washer fluid containing antifreeze. This product is available at
your Lexus dealer and most auto parts stores. Follow the
manufacturer's directions for how much to mix with water.
NOTICE
Do not use engine antifreeze or any other substitute
because it may damage your vehicle's paint.
Do not fill washer fluid over the NORMALº level.

ELECTRICAL COMPONENTS
433
CHECKING THE HEADLIGHT AIM
(vehicles with discharge headlight)

1Vertical movement adjusting bolt 1
2Vertical movement adjusting bolt 2
Before checking the headlight aim:
1. Be sure that the body around the headlight is not deformed.
2. Park the vehicle on a level spot.
3. The driver gets into the driver's seat and puts the vehicle in
a state readying for a driving (with a full tank).
4. Bounce the vehicle several times.
Adjusting the vertical aiming
1. Turn the vertical movement adjusting bolt 1 in either
direction using a Phillips-head screwdriver. At this time, keep
the turning direction and number of turns in mind.

ELECTRICAL COMPONENTS
434
2. Turn the vertical movement adjusting bolt 2 the same
number of turns and in the same direction as step 1 using a
Phillips-head screwdriver.
REPLACING LIGHT BULBS
The illustration on the following pages show the locations of
light bulbs. If it is necessary to replace a bulb, take your vehicle
to your Lexus dealer as soon as possible. Use bulbs with the
bulb numbers and wattage ratings given in the table.
CAUTION
To prevent burning yourself, do not replace the light
bulbs while they are hot.
Halogen bulbs have pressurized gas inside and
require special handling. They can burst or shatter if
scratched or dropped. Hold a bulb only by its plastic
or metal case. Do not touch the glass part of a bulb
with bare hands.
Vehicles with discharge headlights Ð
Do not touch the high voltage socket when the
headlight turns on. 20000 V is momentarily
generated and may cause severe injury by electric
shock.
Do not disassemble, repair or take apart the headlight
bulbs, connector, power supply circuits and rotated
components. Or you may be injured by electric
shocks. Call your dealer when the headlights fail to
work or have to be replaced or disposed of.

ELECTRICAL COMPONENTS
435
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights such as headlights may
temporarily fog up when the lens becomes wet in the rain or in
a car wash. This is not a problem because the fogging is
caused by the temperature difference between the outside and
inside of the lens, just like the windshield fogged up in the rain.
However, if there is a large drop of water on the inside of the
lens, or if there is water pooled inside the light, contact your
Lexus dealer.LIGHT LOCATION

ELECTRICAL COMPONENTS
436
Light Bulbs Bulb No. W Type
1Headlights (high beam) 9005 60 A
2Headlights (low beam)
Discharge bulbs
Halogen bulbs---
---35
55B
C
3Parking lights --- 5 E
4Front side marker lights 194 3.8 E
5Fog lights --- 55 D
6Front turn signal lights --- 21 E

ELECTRICAL COMPONENTS
437
Light Bulbs Bulb No. W Type
7High mounted stoplight 7440 21 E
8Rear turn signal lights --- 21 E
9Rear side marker lights --- 5 E
10Stop/tail lights 744 21/5 E
11Back-up lights 921 18 E
12License plate lights --- 5 E
13Tail lights 168 5 E

ELECTRICAL COMPONENTS
438
Light Bulbs Bulb No. W Type
14Vanity lights --- 5 G
15Interior light --- 8 G
16Door courtesy lights 168 5 E
17Glove box light --- 1.4 E
18Personal lights --- 8 F

ELECTRICAL COMPONENTS
439
Light Bulbs Bulb No. W Type
19Trunk light --- 3 G
A: HB3 halogen bulbs
B: D2R discharge bulbs
C: H7 halogen bulbs
D: H3 halogen bulbs
E: Wedge base bulbs
F: Single end bulbs
G: Double end bulbs