2004 JEEP GRAND CHEROKEE check transmission fluid

WARNING!
Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts and the
brake fluid catching fire.
Use only brake fluid that has been in a tightly closed
container to avoid contamination from foreign matter. Do
not allow petroleum base fluid to contaminate the brake
fluid as seal damage will result.
Automatic Transmission
Selection of Lubricant
It is important that the proper lubricant is used in the
transmission to assure optimum transmission perfor-
mance. Use only manufacturer's recommended transmis-
sion fluid, refer to Recommended Fluids, Lubricants, andGenuine Parts for correct fluid type. It is important that
the transmission fluid be maintained at the prescribed
level using the recommended fluid.
CAUTION!
Using a transmission fluid other than the manufac-
turer's recommended fluid may cause deterioration
in transmission shift quality and/or torque converter
shudder. Using a transmission fluid other than the
manufacturer's recommended fluid will result in
more frequent fluid and filter changes. Refer to
Recommended Fluids, Lubricants, and Genuine
Parts for correct fluid type.
Fluid Level Check ± 4.0L Engines (42RE)
This fluid level should be checked when the engine is
fully warmed up and the fluid in the transmission is
heated to its normal operating temperature. Operation of
MAINTAINING YOUR VEHICLE 277
7

the transmission with an improper fluid level will greatly
reduce the life of the transmission and of the fluid.
To check the automatic transmission fluid level properly,
the following procedure must be used:
1. The vehicle must be on level ground.
2. The engine should be running at curb idle speed for a
minimum of 60 seconds.
3. Fully apply parking brake.
4. Apply the brakes and shift the transmission into P
(Park).
5. The fluidMUSTbe checked with the transmission in
P (Park) to be sure that the fluid is accurate.
6. Wipe the dipstick clean and reinsert until seated.
Remove dipstick and note reading.At normal operating temperature (approximately 180É F
(82É C), the fluid level is correct if it is in the HOT region
(cross-hatched area) on the oil level indicator. The fluid
level indicator should be in the COLD region at 70É F (21É
C) fluid temperature.
If the fluid level is low, add sufficient fluid to bring to the
proper level. Refer to Recommended Fluids, Lubricants
and Genuine Parts for correct fluid type.
Fluid is added through the dipstick tube.
NOTE:To prevent dirt and water from entering the
transmission after checking or replenishing fluid, make
certain that the dipstick cap is properly reseated.
Fluid Level Check ± 4.7L Engines (5±45RFE)
Check the fluid level while the transmission is at normal
operating temperature 180ÉF (82ÉC). This occurs after at
278 MAINTAINING YOUR VEHICLE

least 15 miles (25 km) of driving. At normal operating
temperature the fluid cannot be held comfortably be-
tween the fingertips.
To check the automatic transmission fluid level properly,
the following procedure must be used:
1. Operate the engine at idle speed and normal operating
temperature.
2. The vehicle must be on level ground.
3. Fully apply the parking brake and press the brake
pedal.
4. Place the gear selector momentarily in each gear
position ending with the lever in P (Park).
5. Remove the dipstick, wipe it clean and reinsert it until
seated.
6. Remove the dipstick again and note the fluid level on
both sides. The fluid level should be between the ªHOTº(upper) reference holes on the dipstick at normal operat-
ing temperature. Verify that solid coating of oil is seen on
both sides of the dipstick. If the fluid is low, add as
required into the dipstick tube.Do not overfill.After
adding any quantity of oil through the oil fill tube, wait
a minimum of two (2) minutes for the oil to fully drain
into the transmission before rechecking the fluid level.
NOTE:If it is necessary to check the transmissionbelow
the operating temperature, the fluid level should be
between the two ªCOLDº (lower) holes on the dipstick
with the fluid at approximately 70ÉF (21ÉC) (room tem-
perature). If the fluid level is correctly established at
room temperature, it should be between the ªHOTº
(upper) reference holes when the transmission reaches
180ÉF (82ÉC). Remember it is best to check the level at the
normal operating temperature.
MAINTAINING YOUR VEHICLE 279
7

CAUTION!
Be aware that if the fluid temperature is below 50ÉF
(10ÉC) it may not register on the dipstick. Do not add
fluid until the temperature is elevated enough to
produce an accurate reading.
7. Check for leaks. Release parking brake.
To prevent dirt and water from entering the transmission
after checking or replenishing fluid, make certain that the
dipstick cap is properly reseated. It is normal for the
dipstick cap to spring back slightly from its fully seated
position, as long as its seal remains engaged in the
dipstick tube.
Special Additives
The manufacturer recommends against the addition of
any additives to the transmission. Exception to this
policy is the use of special dyes to aid in detecting fluid
leaks.
Transfer Case
Fluid Level Check
Inspect the transfer case for fluid leaks. If a fluid leak is
found, the transfer case fluid level can be checked by
removing the filler plug located on the back side of the
transfer case. The fluid level should be at the bottom edge
of the filler plug hole when the vehicle is in a level
position.
Adding Fluid
Add fluid at the filler hole until it runs out of the hole
when the vehicle is in a level position.
280 MAINTAINING YOUR VEHICLE

Once a Month
²Check the tire pressure and look for unusual wear or
damage.
²Inspect the battery and clean and tighten the terminals
as required.
²Check the fluid levels of the coolant reservoir, brake
master cylinder, and transmission, and add as needed.
²Check all lights and all other electrical items for correct
operation.At Each Oil Change
²Change the engine oil filter.
²Inspect the exhaust system.
²Inspect brake hoses.
²Check the coolant level, hoses, and clamps.
²Rotate the tires at each oil change interval shown on
Schedule ªAº 6,000 miles (10 000 km) or every other
interval shown on Schedule ªBº 6,000 miles (10 000
km).
²After completion of off-road operation, the underside
of the vehicle should be thoroughly inspected. Exam-
ine threaded fasteners for looseness.
298 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Adding Washer Fluid..................... 171
Adjustable Pedals........................ 84
Air Cleaner, Engine...................... 264
Air Conditioner Maintenance............... 265
Air Conditioning........................ 164
Air Conditioning Refrigerant............... 266
Air Conditioning System.................. 164
Air Filter.............................. 264
Air Pressure, Tires....................... 212
Airbag................................ 35
Airbag Deployment....................... 42
Airbag Light.......................44,52,129
Airbag Maintenance....................... 43
Alarm................................ 23
Alarm, Panic............................ 21
Alarm System........................... 23
Alignment and Balance................... 217
Alterations/Modifications, Vehicle............. 8
Antenna, Satellite Radio................... 155Antifreeze (Engine Coolant)................ 291
Anti-Lock Brake System................... 197
Anti-Lock Warning Light.................. 133
Anti-Theft System........................ 23
Appearance Care........................ 281
Arming Theft System...................... 23
Automatic Dimming Mirror................. 60
Automatic Door Locks..................... 19
Automatic Headlights..................... 77
Automatic Temperature Control............. 167
Automatic Transmission................179,277
Adding Fluid......................278,279
Fluid and Filter Changes................. 277
Fluid Level Check...................277,278
Fluid Type........................... 277
Gear Ranges.......................... 181
Overdrive........................... 182
Shifting............................. 179
Special Additives...................... 280
328 INDEX

Filters
Air Cleaner.......................... 264
Engine Fuel.......................... 263
Finish Care............................ 282
Flashers.............................. 236
Hazard Warning....................... 236
Turn Signal.......................... 129
Flat Tire Changing....................... 240
Flipper Glass, Tailgate..................... 15
Flooded Engine Starting................... 177
Fluid Capacities......................... 291
Fluid Leaks............................. 53
Fluid Level Checks
Automatic Transmission...............277,278
Engine Oil........................... 256
Power Steering........................ 266
Fog Lights............................. 79
Four Wheel Drive
Operation........................... 186Four-Way Hazard Flasher.................. 236
Freeing A Stuck Vehicle................... 186
Front Axle............................. 281
Fuel................................. 221
Filler Cap............................ 224
Filler Door........................... 224
Filter............................... 263
Gasoline............................ 221
Gauge.............................. 133
Light............................... 134
Materials Added....................... 224
Octane Rating........................ 221
Requirements......................... 291
Tank Capacity........................ 291
Fuel System Caution..................... 225
Fuses................................ 286
Garage Door Opener..................... 106
GasCap .............................. 224
INDEX 333
10