2004 ISUZU TF SERIES Fuel sensor

ELECTRICAL-BODY AND CHASSIS 8A-31
FUSE AND SLOW BLOW FUSE LOCATION (RELAY AND FUSE BOX)
RELAY & FUSE BOX
RHD

FUSE 
ENGINE MODEL
FUSE NO. C24SE 6VE1 4JA1-TC / 4JH1-TC4JA1-L
EB-1 15A ECM 20A ECM 10A ECM 
EB-2 
10A ECM (B) 10A RR FOG 
EB-3 15A FRT FOG
10A TCM 15A FRT FOG 
EB-4 10A ACG (S) 15A FRT FOG  10A ACG (S)
EB-5 10A ILLUMI  10A ILLUMI & TAIL-RH10A ILLUMI
EB-6 10A TAIL  10A TAIL-LH 10A TAIL
EB-7 10A H/LIGHT-RH  10A H/LIGHT RH-LOW10A H/LIGHT RH
EB-8 10A H/LIGHT-LH  10A H/LIGHT LH-LOW10A H/LIGHT LH
EB-9 20A FUEL PUMP 10A O2 SENSOR 10A TRA ILER 
EB-10 10A O2 SENSOR 20A FUEL PUMP 10A AC G (S) 
EB-11 
10A H/LIGHT RH-HIGH 
EB-12 
10A H/LIGHT LH-HIGH
EB-13 10A A/C 
 
EB-14 10A 4WD
10A 4WD  
EB-15 10A HORN   
EB-16 15A HAZARD 10A HAZARD  

SLOW BLOW FUSE
ENGINE MODEL
FUSE NO. C24SE 6VE1 4JA1-TC / 4JH1-TC4JA1-L
SBF-1 100A MAIN 
80A MAIN 
SBF-2  
20A COND, FAN 
SBF-3  
60A GLOW 20A COND, FAN
SBF-4 20A COND, FAN 
30A ECM 50A GLOW
SBF-5 40A IG 1   
SBF-6 
40A ABS-1  
SBF-7 
30A ABS-2  
SBF-8 30A BLOWER   
SBF-9 50A IG 2

8A-32 ELECTRICAL-BODY AND CHASSIS
FUSE AND SLOW BLOW FUSE LOCATION (RELAY AND FUSE BOX)
RELAY & FUSE BOX
LHD

FUSE  Saudi Arabia
ENGINE MODEL
FUSE NO. C24SE 6VE1 4JA1-TC / 4JH1-TC4JA1-L
EB-1 15A ECM 20A ECM 10A ECM 
EB-2 
10A ECM (B) 10A RR FOG 
EB-3 15A FRT FOG
10A TCM 15A FRT FOG 
EB-4 10A ACG (S) 15A FRT FOG  10A ACG (S)
EB-5 10A ILLUMI & TAIL-RH  10A ILLUMI & TAIL-RH 
EB-6 10A TAIL-LH  10A TAIL-LH

EB-7 10A H/LIGHT-RH 10A H/LIGHT-RH
10A H/LIGHT-RH-LOW
 10A H/LIGHT RH-LOW
10A H/LIGHT-RH-LOW
EB-8 10A H/LIGHT-LH 10A H/LIGHT-LH
10A H/LIGHT-LH-LOW
 10A H/LIGHT LH-LOW
10A H/LIGHT-LH-LOW
EB-9 20A FUEL PUMP 10A O2 SENSOR 10A TRA ILER 
EB-10 10A O2 SENSOR 20A FUEL PUMP 10A AC G (S) 
EB-11
10A H/LIGHT-RH-HIGH
10A H/LIGHT RH-HIGH 
EB-12 10A H/LIGHT-LH-HIGH
10A H/LIGHT LH-HIGH 
EB-13 10A A/C 
 
EB-14 10A 4WD
10A 4WD  
EB-15 10A HORN   
EB-16 15A HAZARD 10A HAZARD  
SLOW BLOW FUSE
ENGINE MODEL
FUSE NO. C24SE 6VE1 4JA1-TC / 4JH1-TC4JA1-L
SBF-1 100A MAIN 
80A MAIN 
SBF-2  
20A COND, FAN 
SBF-3  
60A GLOW 20A COND, FAN
SBF-4 20A COND, FAN 
30A ECM 50A GLOW
SBF-5 40A IG 1   
SBF-6 
40A ABS-1  
SBF-7 
30A ABS-2  
SBF-8 30A BLOWER   
SBF-9 50A IG 2

8A-264 ELECTRICAL-BODY AND CHASSIS
Installation

Rubber Seal
Be absolutely sure that the fuel tank unit rubber seal is
correctly seated.



Connector
Be absolutely sure that the fuel tank unit connector is securely
connected.
This will prevent a poor contact and an open circuit.



VEHICLE SPEED SENSOR (INSTALLED
ON THE TRANSMISSION)
Removal
1. Disconnect the connector.
2. Remove the vehicle speed sensor body by rotating it.







Installation
To Install, follow the removal steps in the reverse order, noting
the following point.
Tighten the vehicle speed sensor to the specified torque.
Vehicle Speed Sensor Tightening Torque Nm (kgfm/lb.ft)
25  4.9 (2.5  0.5/18  3.6)

8A-278 ELECTRICAL-BODY AND CHASSIS
Low Fuel Indicator Light Inspection
1. Disconnect the fuel tank unit wire connector.
2. Turn the key switch on. Check that the bulb lights.
If operation is not correct, remove and check the bulb or circuit.
or If check whether low fuel turns on fuel input (B-24) at the
time of open and key on.
 meter is check at low fuel
140R300006





Check level sensor operation
1. Remove the fuel tank unit.
2.
Apply battery voltage between terminal (B) and (C) through
a 1.12 watt bulb. Check that the bulb lights.
Note:
It will take a short time for the bulb light.
3. Submerge the sensor in fuel. Check that the bulb goes out.
If operation is not correct, replace the fuel tank unit.

BRAKE SYSTEM WARNING LIGHT
The brake system warning light comes on while the parking
brake is set and the engine run position.
Note:
The parking brake indicator light circuit is designed to
prevent driving of the vehicle with the parking brake on.
It does not indicate the condition of the parking brake
system.



The parking brake switch is in parallel with the brake fluid
switch.



The brake system warning light also comes on when reservoir
brake fluid level falls below the specified limit with the parking
brake released and the engine run position.

8A-428 ELECTRICAL-BODY AND CHASSIS


No. Connector face No. Connector face
E-1
(4JH1-TC)
White Oil pressure switch E-10
SilverEngine ground
E-2
(C24SE)
(6VE1)


Magnetic clutch E-11
(6VE1)

Neutral switch
E-3
(4JH1-TC)
Black
Magnetic clutch AC COMP E-11
(4JH1-TC)
Natural
green
Neutral switch
E-4
~
E-5 NOT USED E-12
(6VE1)

Neutral switch
E-6
(C24SE)
(6VE1)


(6VE1) Fuel injector (C24SE) E-12
(4JH1-TC)
Natural
green
Neutral switch
E-6
(4JH1-TC)

Injector pump E-13
~
E-17 NOT USED
E-7
(C24SE)
(6VE1)


(6VE1) Fuel injector (C24SE) E-18
(C24SE)

Ignition coil
E-8
(C24SE)
(6VE1)


(6VE1) Fuel injector (C24SE) E-19
(4JH1-TC)
Blue Thermo meter unit
E-9
(C24SE)
(6VE1)


(6VE1) Fuel injector (C24SE) E-20
~
E-21 NOT USED
E-9
(4JH1-TC)
Gray T.D.C sensor E-22
(4JH1-TC)
BrownTPS 1 main

ELECTRICAL-BODY AND CHASSIS 8A-429


No. Connector face No. Connector face
E-23
(4JH1-TC)
Gray TPS 2 main E-44
Gray Vehicle speed sensor
E-24
~
E-29 NOT USED E-45
(4JH1-TC)
Gray 2WD-4WD switch
E-30
(4JH1-TC)
Gray A/T speed sensor E-46
(4JH1-TC)
BrownH-L neutral switch
E-31
(4JH1-TC)
Gray Turbine sensor E-47
~
E-48 NOT USED
E-32
~
E-34 NOT USED E-49
(4JH1-TC)
Glow plug
E-35
(4JH1-TC)
(C24SE)
Black Motor actuator E-50

NOT USED
E-36
~
E-40 NOT USED E-51
(6VE1)
Fuel injector
E-41
(4JH1-TC)
Black Coolant temp sensor E-51
(4JH1-TC)
BlackInhibiter switch
E-42
Natural
green
Backup lamp switch E-52
(6VE1)
Fuel injector
E-43
Natural
green
Backup lamp switch E-53
(6VE1)
Ignition coil

8A-432 ELECTRICAL-BODY AND CHASSIS


No. Connector face No. Connector face
F-1
White
Fuel filter


F-2
White
Fuel pump & sensor


F-3
NOT USED


F-4
Gray
ABS sensor


F-5
Gray
Rear combination lamp-RH


F-6
Gray
Rear combination lamp-LH


F-7
Gray
License plate lamp


F-8
Black
Rear fog light – RH


F-9
Black
Rear fog light - LH

6C – 20 FUEL SYSTEM

7. Power Steering Pump Bracket


6C-4 8. Throttle Position Sensor Harness Connector
(4JA1TC/4JH1TC only)
Disconnect the harness connector from the throttle
position sensor.

9. Oil Level Gauge
10. Fuel Pipe
1) Disconnect the fuel hoses from the fuel filter or priming
pump.
2) Disconnect the fuel hoses from the injection pump.

11. Fuel Filter Assembly (Except EURO III model)
6C-5
12. Fuel Filter Bracket (Except EURO III model)
13. Leak Off Hose
Disconnect the leak off hose at the injection pump.
14. Injection Pipe Clip
15. Injection Pipe
1) Loosen the injection pipe sleeve nuts at the delivery
valve side and the injection nozzle side.
Note:
Do not apply excessive force to the injection pipes.
2) Loosen the injection pipe clip.
3) Remove the injection pipes.
Note:
Plug the delivery holder ports with the caps to prevent
the entry of foreign material.

16. Intake Manifold
1) Remove the EGR valve from the intake manifold and
EGR pipe.
2) Loosen the intake rubber hoses clip.
3) Loosen the intake manifold bolts and nuts.
17. Injection Pump Cover (4JA1TC/4JH1TC only)