2004 INFINITI QX56 Air

BL-170
BODY REPAIR
Revision: August 20072004 QX56
Body SealingEIS0 02 U6
DESCRIPTION
The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these
areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of
sealant and not to allow other unaffected parts to come into contact with the sealant.
LIIA1439E

BODY REPAIR
BL-171
C
D
E
F
G
H
J
K
L
MA
B
BL
Revision: August 20072004 QX56
WIIA0278E

BL-172
BODY REPAIR
Revision: August 20072004 QX56
LIIA0912E

BODY REPAIR
BL-173
C
D
E
F
G
H
J
K
L
MA
B
BL
Revision: August 20072004 QX56
Body ConstructionEIS002U7
BODY CONSTRUCTION
LIIA1113E

BL-174
BODY REPAIR
Revision: August 20072004 QX56
Body AlignmentEIS0 02 U8
BODY CENTER MARKS
A mark has been placed on each part of the body to indicate the vehicle center. When repairing parts dam-
aged by an accident which might affect the vehicle frame (members, pillars, etc.), more accurate and effective
repair will be possible by using these marks together with body alignment specifications.
LIIA1440E

BODY REPAIR
BL-175
C
D
E
F
G
H
J
K
L
MA
B
BL
Revision: August 20072004 QX56
PANEL PARTS MATCHING MARKS
A mark has been placed on each body panel to indicate the parts matching positions. When repairing parts
damaged by an accident which might affect the vehicle structure (members, pillars, etc.), more accurate and
effective repair will be possible by using these marks together with body alignment specifications.
WIIA0284E

BL-176
BODY REPAIR
Revision: August 20072004 QX56
DESCRIPTION

All dimensions indicated in the figures are actual.

When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge
itself to make sure there is no free play.

When a measuring tape is used, check to be sure there is no elongation, twisting or bending.

Measurements should be taken at the center of the mounting holes.

An asterisk (*) following the value at the measuring point indicates that the measuring point on the other
side is symmetrically the same value.

The coordinates of the measurement points are the distances measured from the standard line of "X", "Y"
and "Z".
LIIA1506E

BODY REPAIR
BL-177
C
D
E
F
G
H
J
K
L
MA
B
BL
Revision: August 20072004 QX56
ENGINE COMPARTMENT
MEASUREMENT
WIIA0551E