of the trailer lights and assure their proper functioning, a
heavy duty turn signal flasher can be installed as a
separate equipment item by your dealer.
WARNING!
The direct connection of hydraulic brake lines from
vehicle brake system to trailer system is not accept-
able. The extra load may cause brake failure and you
may be injured.
Heavy trailer towing also may require breakaway electric
trailer brakes, anti-sway devices or equalizing hitches for
safe operation. Such devices are commonly required by
state law.
For all trailer tow or heavy-duty applications it is
strongly recommended that the factory fill rear axle
lubricant be replaced with an SAE 75W-140 synthetic
gear lubricant. MopartSynthetic Gear Lubricant is of
this type.
Trailer Tow Wiring
The Trailer Tow Package includes a wiring harness
located at the rear underbody of the vehicle.
NOTE:Connect trailer lighting and brakes using fac-
tory harnesses only. Do not cut or splice wiring to the
brake circuits.
The electrical connections are all complete to the vehicle
but you must mate the harness to a trailer connector.
Refer to the following table for wire color and function.
Wire Color Function
Black Ground Wire
Blue Trailer Brake
Black/Orange Tail & Running Lamps
Red/Tan Battery
Dk. Green/Red Lt. Stop & Turn Signal
Brown/Red Rt. Stop & Turn Signal
Violet/Black Backup Lamps
200 STARTING AND OPERATING
Downshifting.......................... 151
Drive Belts............................ 230
Drive Shaft Universal Joints............... 235
Electrical Power Outlets................... 86
Electronic Power Distribution Center........ 252
Electronic Speed Control.................. 74
Emergency, In Case of
Freeing Vehicle When Stuck............. 167
Jacking............................. 211
Jump Starting........................ 215
Overheating......................... 239
Towing............................. 217
Emission Control System Maintenance....... 262
Emission Related Components............. 241
Engine
Air Cleaner.......................... 231
Air Cleaner Filter..................... 230
Block Heater......................... 146
Break-In Recommendations............... 52
Compartment.....................221,222
Coolant..........................238,259
Cooling............................ 237Exhaust Gas Caution................53,189
Fails to Start......................... 145
Flooded, Starting..................... 145
Fuel Requirements.................... 258
Oil ..........................226,258,259
Oil Selection......................... 258
Oil Synthetic......................... 229
Overheating......................... 239
Starting............................ 144
Temperature Gauge.................... 99
Entry System, Illuminated................. 12
Equipment Identification Plate............. 206
Exhaust Gas Caution..................53,237
Exhaust System......................53,236
Exterior Lighting........................ 68
Filters
Air Cleaner.......................... 230
Engine Fuel......................... 231
Engine Oil.......................229,259
Engine Oil Disposal................... 229
Flashers
Hazard Warning...................... 208
INDEX 291
10
