88
WIRING
88 - 17
Diagnostic – Failure interpretation
DF003
PRESENT
CONTINUATION
CC.1 – CC.0
RECOMMENDATIONS Nothing to notice
Block the computer by means of the CLIP t ester (see “Blocking UCE a irbag”)
Set the contact off and dismount the two attachment screws of the airbag on the steering wheel.
Check the condition of the airbag releasing lines.
Only CLIP tester is to be used for measuring the isolation in point C2 of the airbag circuit (using
cable A of the 30 pins adapter).
If value resulted is not correct, replace the control under steering wheel.
Reconnect the rotating contact of the control under steering wheel, disconnect the computer
connector and connect in its place the 30 pins adapter B40.
Only CLIP tester is to be used for measuring the resistance of the driver’s airbag releasing line,
using cable A of the 30 pins adapter.
If value resulted is not correct, check the 30 pins connector (pins 10 and 11) and replace the
front wiring if necessary. AFT ER Connect UCE airbag and driver’s airbag then set the contact on.
INT ERVENT ION Erase by means of the CLIP tester the failures memorized by UCE
airbag, then turn the contact off.
Perform again a checking by means of the CLIP tester; in case of failure
absence, unblock the computer.
Destroy the airbag pillow, if you are replacing it (see “Destroying
procedure”)
vnx.su
