2004 CHEVROLET CAVALIER coolant temperature

[x] Cancel search: coolant temperature

Page 83 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual 2. If it does not start, wait about 15 seconds and
try again to start the engine by turning the
ignition key to START. Wait about 15 seconds
between each try.
When your engine has run about 10 seconds

Page 84 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual To Use the Engine Coolant Heater
1. Turn off the engine.
2. Open the hood and unwrap the electrical cord. The
electrical cord is located in front of the engine
coolant surge tank on the passenger’s

Page 99 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual Instrument Panel Overview...............................3-2
Hazard Warning Flashers................................3-4
Other Warning Devices...................................3-5
Horn.................

Page 126 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual Enhanced Traction System
Active Light
When your Enhanced Traction System is limiting wheel
spin, this light will come on. Slippery road conditions
may exist if the Enhanced Traction System active ligh

Page 127 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual Low Coolant Warning Light
This light comes on
brie�y when you turn
your ignition on.
If this light comes on and stays on, the coolant level in
your vehicle is low. If the light is on along with an
ove

Page 131 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual Passlock®Warning Light
This light will come on brie�y when you turn the key
to START.
If the light �ashes, the Passlock
®system has entered a
tamper mode. If the vehicle fails to start, seePasslock

Page 208 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual Driving on Grades
Notice:Do not tow on steep continuous grades
exceeding 6 miles (9.6 km). Extended, higher
than normal engine and transaxle temperatures may
result and damage your vehicle. Frequent s

Page 230 of 354

CHEVROLET CAVALIER 2004 3.G Owners Manual When to Check and What to Use
Refer to the Maintenance
Schedule to determine
how often you should
check the �uid level in your
master cylinder reservoir
and for the proper
�uid. SeePart B: Owner
Check
Page:   1-8 9-16 next >