Page 21 of 162
219Status indicators
ABS warning light, 
national-market 
specification 1 
ABS warning light, 
national-market 
specification 2
ABS warning light, 
national-market 
specification 3
Telltale light, right turn 
indicator
Warning indicatorsWarnings are displayed by 
means of symbols in the multi-
function display. In some 
cases, an additional general 
warning light lights up red or 
yellow. A number of warnings 
may be issued simultaneously. 
     
        
        Page 22 of 162
Status indicators220
Overview
The following table lists the possible warnings and pages with additional information.      
    
Light Symbol Meaning Explanations
Ignition key not authorised. (
b 22)
Low-beam headlight, high-beam 
headlight, parking light or turn signal 
lamp defective. (b 24)
Defective lamp. (b 24)
yellow Fuel reserve reached. (b 22)
yellow Fault in engine electronics. (b 23)
yellowRear light or brake light lamp 
defective. (b 24)
red Coolant temperature too high. (b 22)
red Engine oil pressure too low. (b 23) 
     
        
        Page 23 of 162
221Status indicators
red Battery is no longer being charged. (
b 24)
red Brake switch defective. (b 25)
1 flash per 
second ABS starting-off test not completed. (b 25)
4 flashes per 
second ABS self-diagnosis not completed.  (b 26)
redRelay for ABS warning light 
defective. (b 26)
red1 flash per 
second ABS function not available.  (b 26)
red4 flashes per 
second  ABS in residual braking function.  (b 27)
1 red flash 
per second1 flash per 
second  Insufficient brake fluid.  (b 27)
4 red flashes 
per second4 flashes per 
second  A number of ABS faults. (b 28) Light Symbol Meaning Explanations 
     
        
        Page 24 of 162

Status indicators222
Electronic immobiliser 
(EWS)
 EWS symbol is 
displayed.
The key being used is not 
authorised for starting, or 
communication between the 
key and engine electronics is 
disrupted.
• Remove any other vehicle 
keys located near the igni-
tion key (
b 30)
.
• Use the replacement key.
• It is best to have the defec-
tive key replaced by an 
authorised BMW motorcycle 
dealer (
b 32).
Fuel reserve
General warning light 
lights up yellow.
Fuel reserve symbol is 
displayed and flashes 
10 times.The fuel tank contains a fuel 
reserve of a maximum of 
4 litres. The Tripmaster indi-
cates the estimated residual 
operating range (
b 34).
Lack of fuel could result 
in the engine cutting out 
unexpectedly and this could 
therefore cause a dangerous 
road situation. 
Do not run the fuel tank dry.c
A lack of fuel could result 
in misfiring and this in 
turn could damage the catalyt-
ic converter.
Do not run the fuel tank dry.c
•Refuel.
Coolant temperature
General warning light 
lights up red.
Coolant temperature 
indicator flashes 10 times.
Coolant temperature too high.
Continuing to ride when 
the engine is overheated 
could result in engine damage.
It is essential that the 
measures given below are 
observed.c
• Check coolant level, top up if 
necessary.
• If possible, ride in the part-
load range to cool down the 
engine.
• In traffic jams, switch off the 
engine, but keep the ignition 
on so that the radiator fan 
continues to operate. 
     
        
        Page 25 of 162

223Status indicators
Engine electronics
General warning light 
lights up yellow.
Engine electronics 
symbol is displayed.
Fault in the engine electronics.
In exceptional cases, the 
engine stops and can no 
longer be started. Otherwise, 
the engine runs in emergency 
operating mode. 
You can continue to ride, but 
bear in mind that the usual 
engine output is not available.
• Have the fault remedied as 
soon as possible by a spe-
cialist workshop, preferably 
an authorised BMW motor-
cycle dealer. 
Engine oil pressure
General warning light lights 
up red.
Engine oil pressure symbol 
is displayed.
Insufficient engine oil pressure.
The "engine oil pressure" warn-
ing indicates that there is no oil 
pressure or that the oil pressure 
in the lubricating oil circuit is too 
low; under no circumstances is it 
to be regarded as fulfilling the 
function of an oil gauge. Once 
the oil pressure has built up 
1 – 2 seconds after the engine 
start, the warning indicator must 
go out.
If the "engine oil pressure" warn-
ing is displayed while the motor-
cycle is being ridden, take 
account of the traffic situation 
and:• Disengage the gear.
• Press the kill switch.
•Bring the motorcycle safely 
to a halt.
• Check the engine oil level.
Alongside an insufficient 
engine oil level, other 
problems in the engine can 
lead to the "engine oil pres-
sure" warning. Continuing to 
ride in these cases can cause 
engine damage.
If the "engine oil pressure" 
warning is issued, do not con-
tinue to ride, even though the 
engine oil level might be 
correct.c
• Have the fault remedied by a 
specialist workshop, prefer-
ably an authorised 
BMW motorcycle dealer. 
     
        
        Page 26 of 162

Status indicators224
Battery charge current
General warning light 
lights up red.
Battery charge current 
symbol is displayed.
The battery is no longer being 
charged. You can only con-
tinue to ride until the battery is 
discharged. 
A discharged battery 
could result in the engine 
cutting out unexpectedly and 
this could therefore cause a 
dangerous road situation.
If possible, do not continue to 
ride.c
• Have the fault remedied as 
soon as possible by a spe-
cialist workshop, preferably 
an authorised BMW motor-
cycle dealer.
Defective lamp
In the event of a lamp fail-
ure, there can be prob-
lems seeing and being seen.  
Defective lamps should be 
replaced as soon as possi-
ble.c
General warning light 
lights up yellow.
Defective lamp symbol 
with arrow pointing to the 
rear is displayed.
Rear light or brake light lamp 
defective.
• Replace bulbs (
b 108).
Defective lamp symbol 
with arrow pointing to the 
front is displayed.
Low-beam headlight, high-
beam headlight, parking light 
or turn indicator defective.• Replace bulbs 
(
b 106-110).
Defective lamp symbol 
with two arrows is 
displayed.
A combination of the lamp 
defects described previously 
has occurred. 
• Replace bulbs 
(b 106-110). 
     
        
        Page 27 of 162

225Status indicators
ABS warning 
indicators  The ABS warning light is 
shown in one of the following 
three variants depending on 
the country: 
ABS warnings are indicated by 
a combination of the general 
warning light and the ABS 
warning light. Both warning 
lights can light up continuously 
or flash once or 4 times per 
second.
General warning light
General warning light 
lights up red. 
Brake switch defective or 
incorrectly adjusted. BMW 
Integral ABS detects the 
driver’s request for braking by 
the pressure build-up from the 
brake lever. There may be an 
unusual response from the 
brake. You can continue to 
ride. However, bear in mind 
that the brake may respond in 
a manner to which you are not 
accustomed.
There is a defect in the 
brake system that can 
lead to abnormal braking effi-
ciency. 
Brake carefully and safely. 
Avoid braking sharply.c• Have the fault remedied as 
soon as possible by a spe-
cialist workshop, preferably 
an authorised BMW motor-
cycle dealer.
ABS warning light
ABS warning light flashes 
once per second.
ABS function not available as 
starting-off test (
b 58)
 is not 
complete.
You can continue to ride. To 
prevent the wheels from 
locking:
• Do not use emergency brak-
ing until the starting-off test 
has been completed.
Without the ABS func-
tion, the wheels could 
lock under braking.
Brake carefully and safely. 
Avoid braking sharply.c 
     
        
        Page 28 of 162

Status indicators226
ABS warning light flashes 
4 times per second.
Only residual braking function 
available in both brake cir-
cuits, as self-diagnosis (
b 54)
 
not complete.
You can continue to ride. 
However, bear in mind that 
neither the ABS function nor 
the braking power assistance 
is available before the self-
diagnosis has been 
completed. 
Without the ABS func-
tion, wheels could lock 
under braking; without braking 
power assistance, considera-
bly greater force is required to 
brake. 
Brake carefully and safely. 
Avoid braking sharply.c• When circumstances permit, 
avoid pressing the brake 
lever until the self-diagnosis 
has been completed.
General warning light and 
ABS warning light
General warning light 
lights up red. 
ABS warning light lights 
up.
The relay for control of the 
ABS warning indicators is 
defective. No ABS faults can 
be displayed. 
You can continue to ride, but 
bear in mind that any ABS 
faults that might occur can no 
longer be displayed. ABS warning display 
does not function. 
Brake carefully and safely. 
Avoid braking sharply.c
• Have the fault remedied as 
soon as possible by a spe-
cialist workshop, preferably 
an authorised BMW motor-
cycle dealer.
General warning light 
lights up red. 
ABS warning light flashes 
once per second.
ABS function (
b 71) unavaila-
ble in at least one brake 
circuit.
You can continue to ride. 
H o w e v e r ,  b e a r  i n  m i n d  t h a t  t h e  
ABS function is not available.