2004 Acura TL Manual transmission

The Vehicle Stability Assist system
helps to stabilize the vehicle during
cornering if the vehicle turns more
or less than desired. It also assists
you in maintaining traction while
accelerating on loose or slippery
road surf aces. It does this by
regulating the engine’s output, and
by selectively applying the brakes.
When VSA activates, you may notice
that the engine does not respond to
the accelerator in the same way it
does at other times.If the VSA system indicator comes
on while driving, pull to the side of
theroadwhenitissafe,andturnoff
the engine. Reset the system by
restarting the engine. If the VSA
system indicator stays on, or comes
back on while driving, have the VSA
system inspected by an Acura dealer.
The VSA system cannot enhance the
vehicle’s driving stability in all
situations and does not control your
vehicle’s entire braking system. It is
still your responsibility to drive and
corner at reasonable speeds and to
leave a sufficient margin of safety.
When VSA activates, you will see the
VSA Activation indicator blink.
In manual transmission models, if
the VSA system is of f and you
accelerate f rom a stop, the vehicle
may pull, and it may take extra effort
to return the steering wheel to
center. VSA A ctivation Indicator
VSA System Indicator
Vehicle Stability Assist (VSA) System
Driving190

This section explains why it is
important to keep your vehicle well
maintained and how to f ollow basic
maintenance saf ety precautions.
This section also includes
instructions on how to read the
maintenance messages in the Multi-
Inf ormation Display, a Maintenance
Record, and instructions f or simple
maintenance tasks you may want to
take care of yourself .
If you have the skills and tools to per-
f orm more complex maintenance
tasks on your Acura, you may want
to purchase the Service Manual. See
page f or inf ormation on how to
obtain a copy, or see your Acura
dealer.......................
Maintenance Saf ety .194
....................
Maintenance Minder . 195
....................
Maintenance Record .200
..............................
Fluid Locations .202
......
Engine Compartment Covers . 203
........................
Adding Engine Oil .204
.........
Changing the Oil and Filter . 205
..............................
Engine Coolant .207
....................
Windshield Washers .208
....
Automatic Transmission Fluid . 209
........
Manual Transmission Fluid . 210
................
Brake and Clutch Fluid . 211
....................
Power Steering Fluid . 212
....................................
Hood Latch .212
.............................................
Lights .213
.......................................
Seat Belts .218
.....................................
Floor Mats .218
.................................
Wiper Blades .219
...............................................
Tires .220
...................
Checking the Battery . 226
.............................
Vehicle Storage .227
269
Maintenance
Maint enance193

Fluid Locations
Maint enance202
ENGINE OIL
FILL CAP
ENGINE OIL DIPSTICK
(Orange loop)
WASHER FLUID
(Blue cap)
POWER STEERING
FLUID (Red cap)BRAKE FLUID
(Gray cap)
AUTOMATIC
TRANSMISSION
FLUID DIPSTICK
(Yellow loop)
ENGINE
COOLANT
RESERVOIR
RADIATOR CAP
CLUTCH FLUID
(Manual Transmission
only)

Check the f luid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground. Remove the check
bolt, and look f or transmission f luid
coming out of the bolt hole. If a small
amount of f luid drips out of the bolt
hole, reinstall the check bolt.If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stiffer shifting. Replace as
soon as it is convenient. If no f luid comes out, remove the
f iller bolt. Slowly add Honda Manual
Transmission Fluid (MTF) until it
starts to run out of the check bolt
hole. Let the f luid run out until it
stops, then reinstall the check bolt
and the f iller bolt.
The transmission should be drained
and ref illed with new f luid when this
service is shown on a maintenance
message in the Multi-Inf ormation
Display.
Manual T ransmission Fluid
Maint enance
Manual Transmission Fluid
210
CHECK BOLT
DRAIN BOLT FILLER BOLT

Check the brake f luid level in the
reservoirs monthly af ter removing
the engine compartment rear cover
(see page ).
Replace it every 3 years, independent
of mileage.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 f luid, f rom a sealed
container, as a temporary
replacement.The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected f or leaks or
worn brake pads.The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If it is not, add
brake f luid to bring it up to that level.
Use the same fluid specified for the
brake system.
A low f luid level can indicate a leak
in the clutch system. Have this
system inspected as soon as possible.
Brake f luid marked DOT 5 is not
compatible with your vehicle’s
braking system and can cause
extensive damage. Using any non-Honda brake f luid can
cause corrosion and decrease the lif e
of the system. Have the brake
system f lushed and ref illed with
Honda Heavy Duty Brake Fluid
DOT 3 as soon as possible. 203
Manual Transmission only
Brake and Clutch Fluid
Maint enance
Brake System
Clutch System
211
MAX
MIN MAX
MIN

The following chart shows the
recommended cold tire pressures f or
most normal driving conditions and
speed.Thecompactsparetirepressureis:
Because your tires have a low prof ile,
do not rely on a visual inspection to
determine whether the tires have the
proper air pressure.
Instead, we recommend that you use
a gauge to measure the air pressures
.Eventires
that are in good condition may loose
one to two psi (10 to 20 kPa, 0.1 to
0.2 kgf /cm
)parmonth.
Remember to check the spare tire at
thesametimeyoucheckallthe
other tires. Acura strongly recommends that you
not drive f aster than posted speed
limits and conditions allow. If you
decide it is saf e to drive at high
speeds (over 118 mph or 190 kph),
be sure to adjust the cold tire
pressuresasshownbelow.If youdo
not adjust the tire pressure,
excessive heat can build up and
cause sudden tire f ailure.
CONT INUED
Tire Size Cold Tire Pressure for
Normal Driving
Tire Size Cold Tire Pressure for Normal Driving Tire Size Cold Tire Pressure for
High Speed DrivingAutomatic Transmission Models
Manual Transmission Models All Models
Tires
Maint enance
Recommended T ire Pressures f orNormal Driving
Recommended T ire Pressures f orHigh Speed Driving
at least once a month
221
60 psi (420 kPa , 4.2 kgf/cm)
P235/45R17 93W
35 psi (240 kPa ,2.4 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm
)
P235/45R17 93W
235/45R17 93W P235/45R17 93W
235/45R17 93W 39 psi (270 kPa ,
2.7 kgf/cm
)
35 psi (240 kPa , 2.4 kgf/cm
)
32 psi (220 kPa ,
2.2 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm
)
Front:
Rear:
Front:
Rear:
Front:
Rear:
Using tires that are excessively
worn or improperly inflated can
cause a crash in which you can
be seriously hurt or killed.
Follow all instructions in this
owner’s manual regarding tire
inflation and maintenance.

If you need to park your vehicle f or
an extended period (more than one
month), there are several things you
should do to prepare it f or storage.
Proper preparation helps prevent
deterioration and makes it easier to
get your vehicle back on the road. If
possible, store your vehicle indoors.Fill the f uel tank.
Change the engine oil and f ilter.
Wash and dry the exterior
completely.
Cleantheinterior.Makesurethe
carpeting, floor mats, etc., are
completely dry. Block the rear wheels.
If the vehicle is to be stored f or a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
Leave one window open slightly (if
the vehicle is being stored
indoors).
Disconnect the battery.
Support the f ront wiper blade
arms with a f olded towel or rag so
they do not touch the windshield.
To minimize sticking, apply a
silicone spray lubricant to all door
and trunk seals. Also, apply a
vehiclebodywaxtothepainted
surfaces that mate with the door
and trunk seals.Cover the vehicle with a
‘‘breathable’’ cover, one made
f rom a porous material such as
cotton. Non-porous materials, such
as plastic sheeting, trap moisture,
which can damage the paint.
If possible, periodically run the
engine until it reaches f ull
operating temperature (the
cooling f an cycles twice).
Pref erably do this once a month.
Leave the parking brake off. Put
the transmission in Reverse
(6-speed manual) or Park
(automatic).
Vehicle Storage
Maint enance227

Use the compact spare tire as a
temporary replacement only. Get
your regular tire repaired or replaced
and put it back on your vehicle as
soon as you can.
Check the inf lation pressure of the
compact spare tire every time you
check the other tires. It should be
inf lated to:Follow these precautions:
Never exceed 50 mph (80 km/h).
This tire gives a harsher ride and
less traction on some road sur-
f aces. Use greater caution while
driving.
Do not mount snow chains on it.
Do not use your compact spare
tire on another vehicle unless it is
thesamemakeandmodel.
Turn of f the VSA system (see
page ).
Driving with the compact spare
tiremayactivatetheVSAsystem. Replace the tire when you can see
the tread wear indicator bars. The
replacement should be the same size
and design tire, mounted on the
same wheel. The spare tire is not
designed to be mounted on a regular
wheel, and the spare wheel is not
designed f or mounting a regular tire.
On models with manual
transmission, do not drive f or a
long period with the compact
spare tire mounted on a f ront
wheel; it will damage the limited
slip dif f erential. 191
Compact Spare Tire
T aking Care of t he Unexpect ed230
INDICATOR LOCATION MARK
TREAD WEAR INDICATOR BAR
(The M/T compact spare is shown.)
60 psi (420 kPa , 4.2 kgf/cm)