2004 Acura RL audio

The XM satellites are in orbit over
the equator; therefore, objects south
of the vehicle may cause satellite
reception interruptions. To help
compensate f or this, ground-based
repeaters are placed in major
metropolitan areas.
Satellite signals are more likely to be
blocked by tall buildings and
mountains the f arther north you
travel from the equator.
Audio System
Comf ort and Convenience Feat ures176
SATELLITEGROUND
REPEATER
Signal may be
blocked by
mountains or
large obstacles
to the south.

Depending on where you drive, you
may experience reception problems.
Interf erence can be caused by any of
these conditions:Driving on the south side of an
east/west mountain road If your XM Radio service has expired
or you purchased your car f rom a
previous owner, you can listen to a
sampling of the broadcasts available
on XM Satellite Radio. With the
ignition switch in the ACCESSORY
(I) or ON (II) position, push the
PWR/VOL knob to turn on the audio
system and press the SAT Radio
button. A variety of music types and
styles will play.
Driving on the north side of a
large commercial truck on an
east/west road
Driving in tunnels
Driving on a road beside a vertical
wall, steep clif f or hill to the south
of you
Driving on the lower level of a
multi-tiered road
Driving on a single lane road
alongside dense trees taller than
50 f t. (15 m) to the south of you
There may be other geographic
situations that could af f ect satellite
radio reception.As required by the FCC: Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
CONT INUED
Audio System
Comf ort and Convenience Feat ures
Receiving Satellite Radio Service
177

Two controls f or the audio system
are mounted in the steering wheel
hub. These let you control basic
f unctions without removing your
hand f rom the wheel.
If you decide to purchase XM
Satellite Radio service, contact XM
Radio at www.xmradio.com, or at
1-800-852-9696. You will need to give
them your radio I.D. number and
your credit card number. To get your
radio I.D. number, turn the TUNE
knob until ‘‘0’’ appears in the display.
Your I.D. will appear in the display.
After you’ve registered with XM
Radio, keep your audio system in the
SAT Radio mode while you await
activation. This should take about 30
minutes.
While awaiting activation, make sure
your vehicle remains in an open area
with good reception. Once your
audio system is activated, ‘‘category’’
or ‘‘CH’’ will appear in the display
andyou’llbeabletolistentoXM
Radio broadcasts. XM Radio will
continue to send an activation signal
to your vehicle for at least 12 hours
from activation request. If the
service has not been activated after
36 hours, contact XM Radio.
Audio System
Comf ort and Convenience Feat ures
Remote Audio Controls
178
AUDIO/CH
BUTTON

ÛÝ
The top and bottom buttons adjust
thevolumeup( )ordown( ).
Press the proper button and hold it
until the desired volume is reached,
then release it.
The AUDIO/CH button has f our
f unctions, depending on whether you
are listening to the radio or XM
satellite radio, or playing a cassette
or CD.
If you are listening to the radio, use
the AUDIO/CH button to change
stations. Each time you press this
button, the system advances to the
next preset station on the band you
are listening to. You will see the
number of the selected Preset button
in the display. To change bands,
press the AM or FM button (without
Navigation System), or AM/FM
button (with Navigation System) on
the audio system’s f ront panel. If you are playing a cassette, use the
AUDIO/CH button to advance to the
next selection. You will see ‘‘FF’’
blinking in the display when you
press the AUDIO/CH button. The
system f ast f orwards until it senses a
silent period, then goes back to
PLAY.
If youareplayingaCD,thesystem
skips to the beginning of the next
track each time you push the
AUDIO/CH button. You will see the
disc and track number in the display.
If you are listening to satellite radio,
you can also use the AUDIO/CH
button to change channels. Each
time you press this button, the
system advances to the next preset
channel on the band you are
listening to. You will see the number
of the selected Preset button in the
display. To change bands (XM1 or
XM2), press the SAT Radio button
on the audio system’s f ront panel.
U.S. Cars only
Audio System
Comf ort and Convenience Feat ures179

You will have to store your favorite
stations in the Preset buttons after
the system begins working. Your
original settings were lost when
power was disconnected.
Your car’s audio system will disable
itself if it is disconnected f rom
electrical power f or any reason. To
make it work again, the user must
enter a specif ic f ive-digit code in the
Preset buttons. Because there are
hundreds of number combinations
possible f rom f ive digits, making the
system work without knowing the
exact code is nearly impossible.
Youshouldhavereceivedacardthat
lists your audio system’s code
number and serial number. It is best
tostorethiscardinasafeplaceat
home. In addition, you should write
the audio system’s serial number in
this Owner’s Manual. If you should
happen to lose the card, you must
obtain the code number f rom your
Acura dealer. To do this, you will
need the system’s serial number. If you make a mistake entering the
code, do not start over or try to
correct your mistake. Complete the
f ive-digit sequence, then enter the
correct code. You have three tries to
enter the correct code. If you are
unsuccessful in three attempts, you
must then leave the system on for
one hour bef ore trying again. If your car’s battery is disconnected
or goes dead, or the radio f use is
removed, the audio system will
disable itself . If this happens, you
will see ‘‘ ’’ in the f requency
display the next time you turn on the
system. Use the Preset buttons to
enter the f ive-digit code. If it is
entered correctly, the radio will start
playing.
Thef t Protection
Audio System
Comf ort and Convenience Feat ures180

µµ
µ
µ
To cancel these retries, press the
Call Answer/End (DOT) button.
Press this button to contact an
OnStar advisor only if you have an
emergency situation. You will hear a
tone, f ollowed by the announcement,
‘‘Connecting to OnStar Emergency.’’
Your call is given highest priority.
Press this ‘‘DOT’’ button to end a call
to the OnStar advisor, or to cancel
the call if you should press one of
the other buttons accidentally. If the
OnStar center should call you, press
this button to answer the call.
This button is also used to initiate
the Personal Calling and Virtual
Advisor services, if you have
subscribed.This light shows you the status of
the system.
The system is ready
for use.
Acallisin
progress.
If you press this button accidentally,
do not cancel the call. Wait until the
OnStar advisor answers, then explain
your mistake. The advisor will ask about the nature
of the emergency, locate your car,
and notif y the appropriate
emergency service agencies.
There is a problem in
the system. Press the OnStar button
to contact an advisor. If the call
connects, the advisor will assist you
with verif ying the system’s operation.
If you are not able to contact an
advisor, take your car to an Acura
dealer to have the system diagnosed.
There is a problem
in the system with a call in progress.
A microphone is located in the base
of the OnStar control panel so you
can speak to the advisor without
taking your hands of f the steering
wheel or diverting your attention
from the road. The OnStar advisor’s
voice comes f rom the audio system’s
speakers. Use the volume control on
the audio system or on the steering
wheel to adjust the volume.
Emergency Button Call Answer/End ButtonSolid Green
Blinking Green System Status L ight
Solid Red
Blinking Red
OnSt ar
Comf ort and Convenience Feat ures193

µ
µ
µ
µ µ
To store a
telephone number and its nametag in
the system:
Press the DOT button.
Say ‘‘Store.’’ OnStar will respond with ‘‘Ready.’’
OnStar will respond with ‘‘Number
Please.’’
Say the f irst digit of the number.
OnStar will repeat that digit.
Say the second digit of the number.
OnStar will repeat that digit.
Continue this until you have given
OnStar the complete telephone
number. Then say ‘‘Store’’ again.
OnStar will respond with
‘‘Nametag Please.’’
Say the name that you want
assigned to that telephone number.
Repeat the nametag. OnStar will respond with ‘‘Again.’’
OnStar will respond with ‘‘Once
more.’’
‘‘Pardon’’ The system could not
match your voice command to one it
knows. Repeat the command
distinctly.
‘‘Slower please’’ The system
missed the command because it was
not yet ready f or it, or there was too
much background noise. Repeat the
command after a short pause.
With
voice f eedback of f , the system will
respond with a tone rather than
‘‘Ready,’’ or repeating each number
you say. Other responses will still be
by voice. To turn voice f eedback on
or of f : When someone places a telephone
call to you, the audio system will
mute and you will hear the ring.
Press the DOT button to answer the
call. When you have completed the
call, press the DOT button again to
hang up.
The OnStar system can store up to
twenty 32-digit telephone numbers in
its memory. When you store these
numbers in its memory, you give
each one a nametag. When you want
to place a telephone call, you can
recall the number by giving the
system the nametag.
OnStar will respond with ‘‘Ready.’’ Press the DOT button.
Say ‘‘Voice Feedback.’’
OnStar will respond with ‘‘Voice
feedback On/Off.’’
CONT INUED
Storing a Nametag
Voice Feedback On/Of f Incoming T elephone Calls
Using Nametags
OnSt ar
Comf ort and Convenience Feat ures197

Modif ying your car, or installing
some non-Acura accessories, can
make your car unsaf e. Bef ore you
make any modif ications or add any
accessories,besuretoreadthe
f ollowing inf ormation.
Your dealer has Acura accessories
that allow you to personalize your car.
These accessories have been
designed and approved f or your car,
and are covered by warranty.When properly installed, cellular
phones, alarms, two-way radios, and
low-powered audio systems should
not interf ere with your car’s
computer-controlled systems, such
as the SRS and anti-lock brake
system.If possible, have your dealer inspect
the f inal installation.Have the installer contact your
Acura dealer f or assistance bef ore
installing any electronic accessory. Be sure electronic accessories do
not overload electrical circuits
(see page ).
Bef ore installing any accessory: However, if electronic accessories
are improperly installed, or exceed
your car’s electrical system capacity,
they can interfere with the operation
of your car, or even cause the
airbags to deploy.
Non-Acura accessories are usually
designed f or universal applications.
Although aftermarket accessories
may f it on your car, they may not
meet f actory specif ications, and
could adversely af f ect your car’s
handling and stability. (See
‘‘Modif ications’’ on page f or
additional information.) Make sure the accessory does not
obscure any lights, or interf ere
with proper vehicle operation or
perf ormance.
211 328
A ccessories
A ccessories and Modif ications
Bef ore Driving210
Improper accessories or
modifications can affect your
car’s handling, stability, and
performance, and cause a
crash in which you can be hurt
or killed.
Follow all instructions in this
owner’s manual regarding
accessories and modifications.