2004 Acura RL light

The HI or LO indicator lights and
remains lit until you turn it of f by
pushing the opposite side of the
switch lightly. The indicator will turn
off.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly. Select the LO
setting when the seats f eel warm.
The HI setting draws large
amounts of current f rom the
battery.
Do not use the seat heaters, even
on the LO setting, if the engine is
lef t idling f or an extended period.
They can weaken the battery,
causing hard starting.
In LO, the heater runs continuously.
It does not cycle with temperature
changes. In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops. It
continues to cycle as long as you
leave it set on HI. The HI indicator
remains lit as a reminder that you
have the heater on.
Because of the sensors f or the side
airbag system, there is no heater in
the passenger’s seat-back. To use the ski sleeve:
Pull down the rear seat armrest.
Open the trunk pass-through
cover by sliding the knob down-
ward and pulling on the cover.
The ski sleeve allows you to carry
skis or other long objects saf ely
without soiling or damaging the
interior of your car. It attaches to the
trunk pass-through.
1.
CONT INUED
Ski Sleeve
Inst rument s and Cont rols
Seat Heaters, Ski Sleeve
101
KNOB
LID

µ
The master control panel also con-
tains these extra features:
To open the driver’s
window f ully, push the window
switch f irmly down, then release it.
The window automatically goes
down all the way. To stop the
window f rom going all the way down,
pull back on the window switch
brief ly.
To open or close the driver’s window
partially, push down or pull back on
the window switch lightly and hold it.
The window will stop when you
release the switch. To close the driver’s window f ully,
pull back the window switch f irmly,
then release it. The window
automatically goes all the way up. To
stop the window f rom going all the
way up, push down on the window
switch brief ly. If the driver’s window runs into any
obstacle while it is closing
automatically, it will stop, and then
reverse direction. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it.
The MAIN switch controls power to
the passenger’s window. With this
switch of f , the passenger’s window
cannot be raised or lowered. The
MAIN switch does not af f ect the driv-
er’s window. Keep the MAIN switch
off whenyouhavechildreninthe
vehicle so they do not injure them-
selves by operating the window unin-
tentionally. The lights inside the
switches come on when you turn the
parking lights or headlights on.
AUTO
Auto Reverse
Power Windows
Inst rument s and Cont rols104

There are two switches on the
ceiling near the f ront ceiling light.
The ignition switch must be ON (II).
To open the moonroof , pull the
OPEN/CLOSE switch backward and
hold it until the moonroof reaches
the desired position.
If your car’s battery is disconnected
or goes dead, or the driver’s window
f use is removed, the AUTO f unction
will be disabled. The power window
system needs to be reset af ter
reconnecting the battery or installing
the f use. You should do the f ollowing.
Pull back on the driver’s window
switch to close the window
completely then hold the switch
forafurthersecondortwomore. Start the engine. Push down on
the driver’s window switch until
the window is f ully open. The power window system has a key-
of f delay f unction. The windows will
stilloperateforuptotenminutes
after you turn off the ignition.
Opening either f ront door cancels
the delay function. You must turn
the ignition switch ON (II) again
bef ore you can raise or lower the
windows.
If the power windows do not operate
properly af ter resetting, have your
car checked by an Acura dealer. 1.
2.
CONT INUED
Moonroof
Power Windows, Moonroof
Inst rument s and Cont rols105
OPEN/CLOSE
SWITCH

To close the moonroof , push the
OPEN/CLOSE switch f orward and
hold it. The moonroof will not close
completely; it will stop about 5.1
inches (130 mm) away f rom being
closed. Make sure your passengers
are clear of the moonroof , then
release the switch and push it
f orward again to close the moonroof
completely.When you push and hold the TILT-
UP switch, the rear of the moonroof
will tilt up. To close it, push the
OPEN/CLOSE switch f orward. If
you pull the switch backward and
hold it, the moonroof will tilt down
and then open. The AUTO f unction
cannot work with the moonroof in
the tilt up position.
The moonroof has an AUTO
f unction. To open the moonroof f ully,
pull the OPEN/CLOSE switch
backward f irmly until it clicks, then
release it. The moonroof opens
automatically all the way. To stop the
moonroof f rom opening all the way,
push the switch forward briefly. To
open the moonroof partially, pull the
OPEN/CLOSE switch backward
lightly and hold it until the moonroof
reaches the desired position. The
AUTO f unction only works to open
the moonroof .
Moonroof
Inst rument s and Cont rols106
TILT-UP SWITCH
Opening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.

To apply the parking brake, depress
the pedal f ully. To release it, pull the
release lever. The parking brake
light on the instrument panel should
go out when the parking brake is
f ully released with the engine
running (see page ). If you try to
drive the vehicle without releasing
the parking brake, the ABS indicator
maycomeon,andtheABSmaynot
work properly. The VSA system
indicator will also come on alongwith the ABS indicator (see page
).
58 225
Parking Brake
Moonroof , Parking Brake
Inst rument s and Cont rols107
PARKING
BRAKE PEDAL
RELEASE LEVER
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.
Driving the vehicle with the parking
brake applied can damage the rear
brakes and axles.

To use the sun visor, pull it down.
You can also use the sun visor at the
side window. Remove the support
rod f rom the clip and swing the sun
visor toward the side window. In this
position, the sun visor can be
extended by sliding out the
extension.Touseavanitymirroronthebackof
the sun visor, pull up the cover.
The light beside the mirror comes
on when you pull up the cover.
Make sure you put the sun visor
back in place when you are getting
into or out of the vehicle. Do not use
the sun visor extension over the rear
view mirror.
Sun Visor
Vanity Mirror
Sun Visor, Vanit y Mirror
Inst rument s and Cont rols112
EXTENSION

This socket is intended to supply
power f or 12 volt DC accessories
that are rated 120 watts or less (10
amps).
It will not power an automotive type
cigarette lighter element.Route the wire through the notch in
the edge of the console compartment.
The accessory power socket is
located in the console compartment.
To use the accessory power socket,
pull down on the cover. The ignition
switch must be in ACCESSORY (I)
or ON (II).
A ccessory Power Socket
Inst rument s and Cont rols113
ACCESSORY POWER SOCKET NOTCH

The cigarette lighter is next to the
f ront ashtray under the ashtray lid.
Open the lid by pushing on it.The ignition switch must be in
ACCESSORY(I)orON(II)forthe
cigarette lighter to work. To heat up
the lighter, push it in. It will pop out
when it is ready f or use. Do not hold
the lighter in while it is heating up,
you could cause it to overheat.
Cigarette Lighter
Inst rument s and Cont rols114
Push
CIGARETTE LIGHTER