2003 YAMAHA TW125 Owners Manual

2-1
EAU00026
DESCRIPTIONPart locations
2
1. Headlight (page 6-34)
2. Steering lock (page 3-8)
3. Fuel tank (page 3-5)
4. Fuel cock (page 3-7)
5. Helmet holder (page 3-10)6. Luggage strap holders (page 3-11)
7. Drive chain adjusting plates (page 6-26)
8. Air filter element (page 6-12)
9. Shift pedal (page 3-4)
3
456
7
8 912Left view
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 8

2-2
DESCRIPTION
2
10. Carrier (page 3-10)
11. Battery (page 6-32)
12. Engine oil filter element (page 6-9)
13. Engine oil level check window (page 6-9)
14. Brake pedal (page 3-5, 6-21)15. Owner’s tool kit (page 6-1)
16. Fuse (page 6-33)
10
11
15 14 12
1316
Right view
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 9

2-3
DESCRIPTION
2
1. Clutch lever (page 3-4, 6-19)
2. Left handlebar switches (page 3-3)
3. Speedometer unit (page 3-2)
4. Starter (choke) knob (page 3-8)
5. Main switch (page 3-1)6. Indicator lights (page 3-1)
7. Right handlebar switches (page 3-3)
8. Brake lever (page 3-5, 6-20)
9. Throttle grip (page 6-15, 6-28)
10. Fuel tank cap (page 3-5)
1
23
45
678
9
10
Controls and instruments
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 10

3-1
EAU00027
INSTRUMENT AND CONTROL FUNCTIONS
3
EAU00028
Main switch
The main switch controls the ignition
and lighting systems. The various
main switch positions are described
below.
EAU04926
ON
All electrical circuits are supplied with
power; the meter lighting, taillight and
auxiliary light come on, and the
engine can be started. The key can-
not be removed.
OFFON
EAU00056
Indicator lightsEAU00057
Turn signal indicator light “5”
This indicator light flashes when the
turn signal switch is pushed to the left
or right.
EAU00063
High beam indicator light “&”
This indicator light comes on when
the high beam of the headlight is
switched on.
312
1. Turn signal indicator light “5”
2. High beam indicator light “&”
3. Neutral indicator light “N”
NOTE:
The headlight comes on automatical-
ly when the engine is started and
stays on until the key is turned to
“OFF”.
EAU00038
OFF
All electrical systems are off. The key
can be removed.
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 11

3-2
INSTRUMENT AND CONTROL FUNCTIONS
3
EAU01087
Speedometer unit
The speedometer unit is equipped
with a speedometer, an odometer
and a tripmeter. The speedometer
shows riding speed. The odometer
shows the total distance traveled.
The tripmeter shows the distance
traveled since it was last set to zero
with the reset knob. The tripmeter
can be used to estimate the distance
that can be traveled with a full tank of
fuel. This information will enable you
to plan future fuel stops.
4
12
3
1. Speedometer
2. Odometer
3. Tripmeter
4. Reset knob
NOTE:
Only for the German model equipped
with a speed limiter:
The speed limiter prevents the motor-
cycle from exceeding a riding speed
of 80 km/h.
EAU00061
Neutral indicator light “N”
This indicator light comes on when
the transmission is in the neutral
position.
312
1. Turn signal indicator light “5”
2. High beam indicator light “&”
3. Neutral indicator light “N”
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 12

3-3
INSTRUMENT AND CONTROL FUNCTIONS
3
EAU00118
Handlebar switchesEAU03888
Dimmer switch “&/%”
Set this switch to “&” for the high
beam and to “%” for the low beam.
3 1
2
1. Dimmer switch “&/%”
2. Turn signal switch “4/6”
3. Horn switch “*”
EAU03889
Turn signal switch “4/6”
To signal a right-hand turn, push this
switch to “6”. To signal a left-hand
turn, push this switch to “4”. When
released, the switch returns to the
center position. To cancel the turn
signal lights, push the switch in after
it has returned to the center position.
EAU00129
Horn switch “*”
Press this switch to sound the horn.EAU03890
Engine stop switch “#/$”
Set this switch to “#” before starting
the engine. Set this switch to “$” to
stop the engine in case of an emer-
gency, such as when the motorcycle
overturns or when the throttle cable is
stuck.
1
2
1. Engine stop switch “#/$”
2. Start switch “,”
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 13

3-4
INSTRUMENT AND CONTROL FUNCTIONS
3
EAU00152
Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the han-
dlebar grip. To engage the clutch,
release the lever. The lever should
be pulled rapidly and released slowly
for smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
3-12 for an explanation of the ignition
circuit cut-off system.)
1
1. Clutch lever
EAU00157
Shift pedal
The shift pedal is located on the left
side of the engine and is used in
combination with the clutch lever
when shifting the gears of the
5-speed constant-mesh transmission
equipped on this motorcycle.
1
1. Shift pedal
EAU00143
Start switch “,”
Push this switch to crank the engine
with the starter.
EC000005
cC
See page 5-1 for starting instruc-
tions prior to starting the engine.
1
2
1. Engine stop switch “#/$”
2. Start switch “,”
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 14

3-5
INSTRUMENT AND CONTROL FUNCTIONS
3
EAU00158
Brake lever
The brake lever is located at the right
handlebar grip. To apply the front
brake, pull the lever toward the han-
dlebar grip.
1
1. Brake lever
EAU00162
Brake pedal
The brake pedal is on the right side
of the motorcycle. To apply the rear
brake, press down on the brake
pedal.
1
1. Brake pedal
EAU00177*
Fuel tank cap
To remove the fuel tank cap
1. Insert the key into the lock and
turn it 1/3 turn counterclockwise.
2. Turn the fuel tank cap 1/3 turn
counterclockwise and pull it off.
1
a
1. Fuel tank cap
a. Unlock.
5RS-9-E1 (TW125) 8/23/02 11:37 AM Page 15