Page 78 of 378

Leaving Your Vehicle 
If  you  are leaving the  vehicle, take your keys,  open your 1 
door  and  set  the  locks from inside.  Then get out and 
dose the door. 
ur ’ 
It can  be  dangerous  to  drive  with  the trunk lid 
open  because  carbon  monoxide 
(CO) gas  can 
come  into  your  vehicle.  You  can’t  see or 
smell 
CO. It can  cause  unconsciousness  and 
even  death. 
CAUTION: (Continued)  if  you  must  drive  with  the  trunk 
lid aen or if 
electrical  wiring  or  other  cable  connections 
must  pass  through  the  seal  between  the  body 
and  the  trunk  lid: 
0 Make  sure  all  other  windows  are shut. 
0 Turn  the  fan  on  your  heating  or  cooling  system  to  its  highest  speed  and  select  the 
control  setting  that  will  force  outside  air  into  your  vehicle.  See “Climate  Controls” 
in the  Index. 
instrument  panel,  open  them  all  the  way. 
If  you  have  air  outlets  on  or  under  the 
See  “Engine  Exhaust”  in  the  Index. 
Trunk Lock 
To unlock  the trunk from the outside, insert  the  key into 
the lock  on the  trunk and turn it clockwise.  You can  also 
press  the trunk  symbol  on  the remote  keyless entry 
transmitter. 
2-1 1  
     
        
        Page 141 of 378

Climate Controls 
Dual Climate Control System 
f;' (Vent): This mode  directs  air to  the  instrument 
panel outlets. 
+2 (Bi-Level): This  mode  directs  half  of the  air  to  the 
instrument panel  outlets,  and  then  directs  the 
With  this system  you  can  control the heating, cooling 
and  ventilation  for  your  vehicle.  remaining air 
to the  floor  outlets.  Some  air  may  be 
directed  toward the  windshield.  Cooler  air  is  directed  to 
the  upper  outlets and  warmer  air  to  the  floor  outlets. 
(Floor): This mode  directs  most  of the  air to 
the  floor  outlets with  some  air  directed  toward  the 
outboard outlets (for  the  side  windows)  and  a little air 
directed  to  the  windshield. 
The  mode  knob can also  be  used  to  select  defog  or 
defrost  mode. Information  on  defogging  and  defrosting, 
see "Defogging and  Defrosting" later in this  section. 
3f (Fan): Turn  the knob  located  on  the  left of 
the climate  control panel  clockwise  or  counterclockwise 
Use  the  mode  knob  located on  the right side  of the  to  increase or  decrease  the  fan  speed. 
climate  control panel  to select the following  modes: 
Driver  or Passenger  (Temperature  Levers): Slide  the 
2 MAX (Maximum): This  mode recirculates  much of 
the  air  inside  your vehicle and sends  it through  the 
instrument  panel  outlets.  The  air conditioning 
compressor  will  run automatically  in this  setting  unless 
the temperature  is  at  or below freezing.  lever(s) 
up  or down  to  increase  or  decrease  the 
temperature. 
3-20  
     
        
        Page 168 of 378

4 00 (Dolby): Press  this pushbutton to  reduce 
background  noise.  The double-D  symbol  will  appear 
on  the  display. 
Dolby  Noise  Reduction  is manufactured under a 
license  from  Dolby  Laboratories  Licensing Corporation. 
Dolby  and  the double-D  symbol are trademarks 
of 
Dolby  Laboratories  Licensing Corporation. 
5 REV (Reverse): Press this  pushbutton to  reverse the 
tape  rapidly.  Press  it  again  to  return to playing  speed. 
The  radio  will  play  while  the tape reverses.  You 
may  select  stations  during  reverse  operation using 
SEEK  or  TUNE. 
6 FWD (Forward): Press  this pushbutton to  advance 
quickly.  Press  the pushbutton  again  to  return to playing 
speed.  The  radio  will  play  while  the tape advances. 
You  may  select  stations  during forward operation using 
SEEK  or  TUNE. 
A SEEK : Press  the  up  or  the down arrow  to  seek 
to  the  next  or to the  previous  selection on the tape. 
AM/FM: Press this button  to  listen to the  radio when a 
tape 
is playing. 
TAPE/PLAY: Press this  button to change to  playing a 
tape  when  listening to the  radio. The tape symbol 
with  an arrow  will appear  on the  display  while the tape 
is active. 
A EJECT: Press this  button  to  stop a tape when  it  is 
playing and to  remove a tape  when it is  not  playing. 
The  eject  button  may be activated  with either the  ignition 
or  radio 
off. Cassettes  may be loaded  with the  radio 
and ignition 
off if this  button  is pressed  first. 
Cassette Tape Messages 
E (Error): If this  message and a number appears while 
trying  to  play  a cassette tape,  it could be one  of the 
following: 
0 ElO: The  tape is tight and the  player  can’t turn the 
tape  hubs.  Remove  the tape.  Hold the tape with 
the  open  end down and try to turn the  right 
hub  counterclockwise  with a pencil.  Turn the tape 
over  and repeat.  If the  hubs  do  not turn easily, your 
tape  may be damaged and should  not be  used  in 
the player. Try a  new tape to  make sure your  player 
is working properly. 
El 1 : The tape  is broken. Try  a  new tape. 
0 E14: Wrapped  tape. Try  a  new tape. 
3-47