2003 MITSUBISHI SHOGUN heater

H16A297A
Rear ventilators
EH16ABJa
1- Roof ventilators
2- Rear floor ventilators*
(from under the second seat)
3- Rear floor ventilators*
(from side of the third seat)
H16A038A
A
Air flow direction adjustmentAdjust the direction of the air flow by mov-
ing the knob (A).
H23A255A
LHDFront heater/Manual air
conditioning*
EH04AOH
The front heater and the air conditioning
can be operated while the engine is run-
ning. The performance of the heater is
directly related to the temperature of the
engine coolant, so operate the heater after
the engine has had a chance to warm up.
The amount of air flow can be regulated by
adjusting the blower speed.
1- Air conditioning switch*
Push the switch when the blower is
switched on, and the air conditioning
unit (cooling/dehumidifying function) will
operate, turning the operation indica-
tor lamp on.
Push the switch again, and the air con-
ditioning unit will stop.
For pleasant driving
6-36Div:
Out put date:

H23A254A
RHDNOTE
On an air conditioned vehicle, the cool air
from the ventilators may appear as a mist.
This is due to moist air being suddenly
cooled by the air conditioning. This will clear
after a few moments.
CAUTION
(1) When using the air condition-
ing, the idling speed may slightly
increase as the air condition-
ing compressor is switched
on/off automatically. Especially
for vehicles with an automatic
transmission, while the vehicle
is stationary, fully depress the
brake pedal to prevent the
vehicle from creeping.
CAUTION
(2) On 3500 models, if a problem is
detected in the air conditioning
compressor, the air condition-
ing operation indicator lamp
blinks. Stop the vehicle in a safe
place, turn off the engine, then
restart the engine. If the air con-
ditioning operation indicator
lamp does not blink, there is no
problem. If it does blink, have it
checked at an authorized MIT-
SUBISHI dealer.
2- Blower speed selection dial
There are 4 blower speeds for control of
the amount of air flow.
Adjust the blower speed by turning the
blower speed selection dial clockwise or
anticlockwise.
The setting for ordinary use should be
the first or second speed.
3- Temperature control dial
The heater will not operate if the dial is
set all the way to the left.
The air flow temperature will gradually
increase as the dial is turned to the right.
NOTE
When the engine coolant temperature is
low, temperature of air introduced into the
passenger compartment does not change
even if the temperature control dial is
moved to the high temperature side.
H16A296A
MODE SELECTION AIR OUTLETS
B, CB, C, D, EA*, C*, D, EA, C*, D, EA, C*
A:From front and side demister
B:From centre ventilators
C:From side ventilators
D:From under the instrument panel
E:From rear end of the centre console
* :means a small amount of air flow
For pleasant driving
6-37
Div:
Out put date:

H14F020A
To stop the air conditioning
EH14F-G
By setting the blower speed selection dial
to the“
”(OFF) position.
All operations will stop except the change
of air selection.
H18A091G
Rear heater* /
Rear air conditioning*
EH18A-Z
The rear heater/air conditioning can be
operated when the ignition switch is at the
“ON”position.
1- Main switch
2- Blower speed selection dial
3- Temperature control dial
For pleasant driving
6-52Div:
Out put date:

H18A140A
Type CThe temperature will gradually decrease as
the dial is turned to the right.
Air purifier
EH14K-Jb
Operate the blower, and the air purifier
incorporated in the heater or air condition-
ing will operate to purify air in the passen-
ger compartment.
NOTE
The air purifier contains a filter. The dirt
settles on the filter, decreasing the air puri-
fication efficiency. It is, therefore, recom-
mended that the filter be cleaned every 12
months or every 12, 000 km (7,400 miles).
For the detail, refer to your authorized MIT-
SUBISHI dealer.
Important operation tips for air
conditioning
EH04JALc
(1) Park the vehicle in the shade.
Parking in the hot sun will make the
vehicle interior extremely hot, and it will
require more to cool the interior.
If it is necessary to park in the sun,
open the windows for the first few min-
utes of air conditioning operation to
expel the hot air.
(2) Close the windows when the air con-
ditioning is in use. The entry of out-
side air through open windows will
reduce the cooling efficiency.
(3) Too much cooling is not good for the
health. The inside air temperature
should only be 5 to 6°C below the out-
side air temperature.
(4) When operating the system, make sure
the air intake, which is located in front
of the windscreen, is free of obstruc-
tions such as leaves. Leaves col-
lected in the air-intake plenum may
reduce air flow and plug the plenum
water drains.
For pleasant driving
6-55
Div:
Out put date:

Chrome parts
EK06A-Aa
In order to prevent spots and corrosion of
chrome parts, wash with water, dry thor-
oughly, and apply a special protective coat-
ing. This should be done more frequently
in winter.Aluminium wheels*
EK35A-Af
A protective coating is provided over the
aluminium type wheels.
Clean aluminium wheels with a cleaner
designed for use on aluminium and apply
an appropriate protection agent.
NOTE
(1) When cleaning aluminium type wheels,
do not use abrasive cleaners. Wheels
exposed to sea water or road chemi-
cals should be cleaned as soon as
possible.
(2) Brushes may damage the aluminium
wheel surface. Always use a sponge,
chamois leather, etc.
(3) Do not apply hot water directly from the
steam cleaner or similar to the wheel
surface.
Window glass
EK10A-E
Window glass can normally be cleaned
using only a sponge and water.
Glass cleaner can be used to remove oil,
grease, dead insects, etc. After washing the
glass, wipe dry with a clean, dry, soft cloth.
Never use the same cloth to wipe the win-
dow glass as would be used to wipe the
paintwork; wax from the painted surfaces
could adhere to the glass and reduce its
transparency and visibility.
NOTE
To clean the inside of the backdoor win-
dow, always use a soft cloth and wipe the
window glass along the demister heater
element so as not to cause damage.Wiper blades
EK11A-Aa
Use a soft cloth and glass cleaner to
remove grease, dead insects, etc., from the
wiper blades. Replace the wiper blades
when they no longer wipe properly (Refer
to page 9-19).
Cleaning the sunroof*
EK30A-Ab
Clean the inside of the sunroof with a soft
cloth. Hard deposits should be wiped away
with a cloth dipped in warm, neutral deter-
gent solution. Wipe away the solution with
a sponge dipped in fresh water.
NOTE
The surface treatment on the inside of the
glass may be removed if a hard cloth or
organic solvent (benzine, thinner, etc.) is
used.
Vehicle care
7-7
Div:
Out put date:

N28A132A
CC: RHD 2500 models with 2 batteries
2. You could be injured if the vehicles
move. Set the parking brake firmly on
each vehicle. Put an automatic trans-
mission in“P”(PARK) or a manual
transmission in“N”(Neutral). Turn off the
ignition switch.
WARNING
Turn off the ignition on both vehicles
beforehand. Take care to make sure
that the cables or your clothes do not
get caught by the fan or drive belt.
Personal injury could result.
NOTE
Turn off all lamps, heater and other elec-
trical loads. This will avoid sparks and help
save both batteries.3. Make sure that the battery electrolyte is
at the proper level.
Refer to“Battery”on page 9-6.
WARNING
If the electrolyte fluid is not visible, or
appears to be frozen, Do Not Attempt
Jump Starting!
A battery might rupture or explode if
the temperature is below the freez-
ing point or if it is not filled to the
proper level.
N28A133A
DD: LHD 2500 models with 2 batteries
4. Connect one end of one jumper cable to
the positive (+) terminal of the dis-
charged battery, and the other end to
the positive (+) terminal of the booster
battery.
5. Connect one end of the other jumper
cable to the negative (-) terminal of the
booster battery, and the other end to the
engine block of the vehicle with the dis-
charged battery at the point farthest from
the battery.
NOTE
Remove the cover before connecting the
jumper cable to the positive terminal of the
battery.
For emergencies
8-26Div:
Out put date:

N29B269A
Fuse load capacity
EN29BOIb
The fuse capacity and the name of the
electric systems protected by the fuses are
indicated on the inside of the lid located at
the driver’s leg area and on the inside of
the fuse box lid for fuses located in the
engine compartment.
Passenger compartment
NOTE
Spare fuses are contained in the fuse hous-
ing. Always use a fuse of the same capac-
ity for replacement.LHD
NO Symbol Electric systemCapacity
1
Rear window wiper 15A
2- - -
3Radio 10A
4Cigarette lighter 15A
5Relay 10A
6Gauge 10A
7Engine control 20A
8Reversing lamps 10A
9Rear fog lamp 10A
10Central door locks 20A
11Rear window demister 30A
12Heater 30A
13Sunroof 20A
14Anti-lock brake system 10A
NO Symbol Electric systemCapacity
15
Heated seat 20A
16Heated door mirror 10A
1 7 - Spare fuse 10A
1 8 - Spare fuse 15A
1 9 - Spare fuse 20A
2 0 - Spare fuse 30A
•Some fuses may not be installed on your
vehicle, depending on the vehicle model
or specifications.
•The table above shows the main equip-
ment corresponding to each fuse.
For emergencies
8-30Div:
Out put date:

N29B270A
RHD
NO Symbol Electric systemCapacity
1
Rear window wiper 15A
2- - -
3Radio 10A
4Cigarette lighter 15A
5Relay 10A
6Gauge 10A
7Engine control 20A
8Reversing lamps 10A
9Rear fog lamp 10A
10Central door locks 20A
11Rear window demister 30A
12Heater 30A
13Heated door mirror 10A
14Heated seat 20A
NO Symbol Electric systemCapacity
15
Anti-lock brake system 10A
16Sunroof 20A
1 7 - Spare fuse 10A
1 8 - Spare fuse 15A
1 9 - Spare fuse 20A
2 0 - Spare fuse 30A
•Some fuses may not be installed on your
vehicle, depending on the vehicle model
or specifications.
•The table above shows the main equip-
ment corresponding to each fuse.
For emergencies
8-31
Div:
Out put date: