2003 MERCEDES-BENZ C320 4MATIC clock

292 Practical hintsReplacing bulbsReplacing bulbs for front lamps
Halogen headlamps
1Bulb socket for turn signal lamp
2Headlamp cover for high beam head-
lamp, parking and standing lamp
3Headlamp cover for low beam head-
lamp4Low beam headlamp bulb
5High beam headlamp bulb
6Bulb socket for parking and standing
lamp bulb
Low and high beam bulb

Switch off the lights.

Open the hood (
page 235).

Press the clamp and remove headlamp
cover2 or 3.

Pull electrical connector off.

Unclip the retainer springs and take out
the bulb.

Insert the new bulb so that the base
locates in the recess on the holder.

Clip the retainer springs and plug the
connector onto the bulb.

Align headlamp cover2 or 3 and click
into place.
Front turn signal lamp bulb

Switch off the lights.

Open the hood (
page 235).

Twist bulb socket1 counterclockwise
and pull out.

Push bulb into socket, turn counter-
clockwise and remove.

Insert new bulb in socket, push in and
twist clockwise.

Reinsert bulb socket in lamp and twist
clockwise.

294 Practical hintsReplacing bulbs
Twist bayonet socket5 counterclock-
wise to the stop (do not remove).

Pull the bulb out of the socket.

Insert the new bulb so that the base
locates in the recess in the bayonet
socket5.

Twist bayonet socket clockwise until
you hear it snap into place.

Plug the connector onto the bulb.

Align headlamp cover2 and click into
place.
Front turn signal lamp bulb

Switch off the lights.

Open the hood (
page 235).

Twist bulb socket1 counterclockwise
and pull out.

Push bulb into socket, turn counter-
clockwise and remove.

Insert new bulb in socket, push in and
twist clockwise.

Reinsert bulb socket in lamp and twist
clockwise.
Parking and standing lamp bulb

Switch off the lights.

Open the hood (
page 235).

Press the clamp and remove headlamp
cover2.

Pull out the bulb socket6 with the
bulb.

Pull the bulb out of the bulb socket.

Insert a new bulb in the socket.

Reinstall the bulb socket.

Align headlamp cover2 and click into
place.
Side marker lamp bulb
Switch off the lights.

Carefully slide lamp towards rear.

Remove front end first.

Twist bulb socket counterclockwise
and pull out.

Pull bulb out of the bulb socket.

Insert new bulb in socket.

Reinstall bulb socket, push in and twist
clockwise.

To reinstall lamp, set rear end in
bumper and let front end snap into
place.

295 Practical hints
Replacing bulbs
Replacing bulbs for rear lamps
Tail lamp assemblies
Switch off lights.

Open trunk lid.
1Locking lever

Fold trim to the side.

Turn locking lever1 to vertical position
and remove bulb carrier.2Rear fog lamp, driver’s side
3Back up lamp
4Stop lamp
5Turn signal lamp
6Tail, parking, standing and side marker
lamp

Gently push bulb into socket, turn
counterclockwise and remove.

Insert new bulb and turn clockwise.

Reinstall bulb socket.

Reinstall bulb holder and close trim
panel.License plate lamp
1Screw

Switch off the lights.

Loosen both screws1 and remove
lamp.

Replace the tubular lamp and reinstall
lamp.

Retighten the screws.

301 Practical hints
Flat tire
In the case of a flat tire, you may
temporarily use the Minispare wheel when
observing the following restrictions:

Do not exceed vehicle speed of 50 mph
(80 km/h).


Drive to the nearest tire repair facility
to have the flat tire repaired or
replaced as appropriate.


Do not operate vehicle with more than
one spare wheel mounted.Lowering the vehicle

Lower vehicle by turning crank
counterclockwise until vehicle is
resting fully on its own weight.

Remove the jack.
1-5 Wheel bolts

Tighten the five wheel bolts evenly,
following the diagonal sequence
illustrated (1to5), until all bolts are
tight. Observe a tightening torque
of 80 ft lb (110 Nm).

Before storing the jack in the trunk, it
should be fully collapsed, with handle
folded in (storage position)
(page 280).
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque
of 80 ft lb (110 Nm).

305 Practical hints
Battery
Reconnecting the battery
Turn off all electrical consumers.

Connect the positive lead and fasten its
cover.

Connect the negative lead.

Reinstall the filter box (
page 303).Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12 volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
!NEVER invert the terminal connections!!The battery, its filler caps and the vent
tube must always be securely installed
when the vehicle is in operation.
iThe following procedures must be car-
ried out following any interruption of
battery power (e.g. due to reconnec-
tion):

Set the clock (
page 120)
Vehicles with COMAND*:
see COMAND operator’s manual.


Resynchronize the front seat head
restraints (
page 94).


Resynchronize the ESP
(page 75).


Resynchronize side windows
(page 189).


Resynchronize sliding/pop-up
roof* (
page 191).

312 Practical hintsFuses
FusesFuse box in passenger compartment
1CoverOpening

Pull cover1 open with a screw driver or
similar tool.

Remove cover1 rearward.
Closing

Attach the cover1 in the front.

Fold the cover1 in until it engages.
Fuse chart
The fuse chart is found in the fuse box in
the passenger compartment. The amper-
ages of the fuses are also given there.
Fuse box in engine compartment
The fuse box is located in the engine com-
partment on the left hand side.
1Screw
2Cover
3Retainer
Removing/installing cover
Twist screws1 90° counterclockwise.

Pull up cover2.

Slide out retainer3 and remove cover
by pulling towards front.

Install cover2 in reverse order.
iOnly install fuses that have been tested
and approved by Mercedes-Benz and
that have the specified amperage rat-
ing.
Never attempt to repair or bridge a
blown fuse. Have the cause determined
and remedied by an authorized
Mercedes-Benz Center.

351 Index
Climate control 148
Adjusting 151
Defogging windshield 151
Defrosting 151
Setting the temperature 150
Clock 23, 122
Closing
Glove box 203
Hood 236
Side windows 187
Sliding/pop-up roof* 190, 289
Sliding/pop-up roof*
with SmartKey 191
Trunk lid 89
Windows 187
Windows with SmartKey 188
Closing sliding/pop-up roof*
In an emergency 289
Cockpit 20, 341
Cockpit management and data system
(COMAND*) 342
COMAND* see separate operating
instructionsCombination switch 104
High beam flasher 47
Turn signals 47
Windshield wipers 48
Consumer information 339
Control and operation of radio
transmitters 230
Control system 111, 342
AUDIO menu 116
Convenience submenu 129
Display digital speedometer 116
Functions 112, 115
Instrument cluster submenu 122
Lighting submenu 125
Malfunction memory menu 118
Menus 114, 115, 343
Multifunction display 111
Multifunction steering wheel 112
NAVI menu* 118
Selecting radio system 117
Settings menu 119
Standard display menu 116
Submenus 113, 115
TEL* menu 134
Trip computer menu 132
Vehicle submenu 128Convenience submenu 129
Activating easy-entry/exit
feature* 129
Setting key dependency 131
Setting parking position* for
exterior rear view mirror 131
Coolant 238, 336
Adding 239
Anticorrosion/antifreeze
quantity 336
Capacities 329
Checking level 238
Messages in display 266, 267
Temperature 232
Temperature display 108
Warning lamp 267
Coolant level
Checking 234, 238
Cruise control 193, 342
Canceling 194
Driving downhill 194
Driving uphill 194
Fine adjustment 195
Saving current speed 194
Setting speeds 195
Cruise control lever 193

364 IndexSelector lever 23
Lock 44
Position
(automatic transmission) 23, 138
Self-test
BabySmart
TM airbag deactivation
system 67
Tele Aid* 210
Service
Calling up the service indicator 248
Major service (Service B) 247
Minor service (Service A) 247
Overdue 247
Spare parts 316
Types 247
When due 247
Service and Warranty Booklet
Loss of 317
Service and warranty information 10
Service indicator 247
Calling up 248
Clearing 247, 248
Service life (tires) 243
Service see maintenance 247
Service System see FSS 247Setting
Convenience functions 121, 129
Cruise control 194
Daytime running lamp mode 125
Higher speed in cruise control 195
Hours (clock) 122
Individual vehicle settings 119
Instrument lighting 107, 108
Interior lighting delayed shut-off 127
Key dependent memory 131
Lamps and lighting
(control system) 125
Language, multifunction display 124
Locator lighting 126
Lower speed in cruise control 195
Miles/kilometers in
speedometer 123
Minutes (clock) 122
Night security illumination 126
Parking position* for exterior rear
view mirrors 131
Slower speed in cruise control 195
Speed in cruise control 195
Speedometer display mode 123
Station selection mode 128
Temperature (Interior) 158Temperature (interior) 150
Temperature indicator 123
Time display mode (Clock) 123
Units
Speedometer 123
Temperature 123
Settings
Convenience functions 129
Factory, SmartKey 85
Individual (SmartKey) 131
Lighting (control system) 125
Menus and submenus 113
Resetting all (control system) 120
Resetting in the submenu 120
Selective 85
Settings menu
Functions in 119
Individual vehicle settings 119
Submenus 120
Shift lock 344
Shifting
Gear selector lever positions 141
Gearshift lever 137
Into optimal gear range
(automatic transmission) 139