2003 Hyundai H-1 (Grand Starex) jump start

STARTING & OPERATING
STARTING & OPERATING STARTING & OPERATING
STARTING & OPERATING
STARTING & OPERATING
3-18 (1) Position the vehicle so that one wheel is on
a dry paved surface and the other on ice, snow, mud, etc. Drive the vehicle, and observe the operation of the limited-slip differential. The vehicle should not become stuck if the differential is functioning properly.
(2) Depress the accelerator pedal gradually, and then when traction is good, depress itforcefully. If the vehicle accelerates well, thedifferential is functioning properly.
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
(1)(1)
(1)(1)
(1) Never start the engine while one of the
Never start the engine while one of the Never start the engine while one of the
Never start the engine while one of the
Never start the engine while one of the
rear wheels is jacked up and the other in
rear wheels is jacked up and the other in rear wheels is jacked up and the other in
rear wheels is jacked up and the other in
rear wheels is jacked up and the other in
contact with the ground; doing so may
contact with the ground; doing so may contact with the ground; doing so may
contact with the ground; doing so may
contact with the ground; doing so may
cause the vehicle to jump forward.
cause the vehicle to jump forward. cause the vehicle to jump forward.
cause the vehicle to jump forward.
cause the vehicle to jump forward.
(2)(2)
(2)(2)
(2) If one of the rear wheels begins to spin in
If one of the rear wheels begins to spin in If one of the rear wheels begins to spin in
If one of the rear wheels begins to spin in
If one of the rear wheels begins to spin in
mud, snow, etc., the vehicle can some-
mud, snow, etc., the vehicle can some- mud, snow, etc., the vehicle can some-
mud, snow, etc., the vehicle can some-
mud, snow, etc., the vehicle can some-
times be driven out by depressing the
times be driven out by depressing the times be driven out by depressing the
times be driven out by depressing the
times be driven out by depressing the
accelerator pedal further; however, avoid
accelerator pedal further; however, avoid accelerator pedal further; however, avoid
accelerator pedal further; however, avoid
accelerator pedal further; however, avoid
running the engine continuously at high
running the engine continuously at high running the engine continuously at high
running the engine continuously at high
running the engine continuously at high
rpm because doing so could damage the
rpm because doing so could damage the rpm because doing so could damage the
rpm because doing so could damage the
rpm because doing so could damage the
limited-slip differential.
limited-slip differential. limited-slip differential.
limited-slip differential.
limited-slip differential.
D190A02P-GAT
LIMITED-SLIP DIFFERENTIAL
LIMITED-SLIP DIFFERENTIAL LIMITED-SLIP DIFFERENTIAL
LIMITED-SLIP DIFFERENTIAL
LIMITED-SLIP DIFFERENTIAL
(If installed)
(If installed) (If installed)
(If installed)
(If installed) A limited-slip differential, if equipped, is for the
rear wheel differential only. The features of this limited-slip differential are described below:
Just as with a conventional differential, the
wheel on one side is allowed to turn at adifferent speed from the wheel on the other sidewhen the vehicle is cornering. The differencebetween the limited-slip differential and a con-ventional differential is that if the wheel on oneside of the vehicle loses traction, a greateramount of torque is applied to the rear wheel onthe other side to improve traction.
NOTE:
NOTE: NOTE:
NOTE:
NOTE:
In a stationary position, the L.S.D will oper-
In a stationary position, the L.S.D will oper- In a stationary position, the L.S.D will oper-
In a stationary position, the L.S.D will oper-
In a stationary position, the L.S.D will oper- ate when the torque difference between the
ate when the torque difference between the ate when the torque difference between the
ate when the torque difference between the
ate when the torque difference between the
rear right wheel and the left wheel is from
rear right wheel and the left wheel is from rear right wheel and the left wheel is from
rear right wheel and the left wheel is from
rear right wheel and the left wheel is from
5Kgf·m to 9 Kgf·m.
5Kgf·m to 9 Kgf·m. 5Kgf·m to 9 Kgf·m.
5Kgf·m to 9 Kgf·m.
5Kgf·m to 9 Kgf·m.
The following procedures can be used to con-
firm that the limited-slip differential is function- ing properly: This is due to cleaning process for fuel fired
This is due to cleaning process for fuel fired This is due to cleaning process for fuel fired
This is due to cleaning process for fuel fired
This is due to cleaning process for fuel fired
heater and a normal operation.
heater and a normal operation. heater and a normal operation.
heater and a normal operation.
heater and a normal operation.
It will takes about 1- 3 minutes according to
It will takes about 1- 3 minutes according to It will takes about 1- 3 minutes according to
It will takes about 1- 3 minutes according to
It will takes about 1- 3 minutes according to
fuel quantity in the fuel fired heater fuel line.
fuel quantity in the fuel fired heater fuel line. fuel quantity in the fuel fired heater fuel line.
fuel quantity in the fuel fired heater fuel line.
fuel quantity in the fuel fired heater fuel line.

IN CASE OF EMERGENCY
IN CASE OF EMERGENCY IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
4-14 The following points should be observed:
1. Both batteries must be 12V. The capacity
(Ah) of the battery supplying current should not be significantly below that of the dis-charged battery.
2. Use only heavy-duty jumper cables.
3. A discharged battery can freeze. A frozen battery must be thawed out before connect- ing the jumper cables.
4. There should be no contact between the two vehicles; otherwise current may flow whenthe positive terminal is connected.
5. The discharged battery must be correctly connected to the vehicle electrical system.
6. Run the engine of the vehicle supplying current.
7. Connect the jumper cables as follows:
(1) Connect one end of one jumper cable to the positive terminal of the flat battery, and the other end to the positive terminal of thebooster battery.
(2) Connect one end of the other jumper cable to the negative terminal of the booster bat-tery, and the other end to the engine blockof the vehicle with the flat battery at the pointfarthest from the battery.
GS40330A
E110A02P-GAG
If the engine cannot be started because the battery is weak or dead, the battery from an-other vehicle can be used with jumper cables tostart the engine.
E110A01P-GAT
EMERGENCY STARTING
EMERGENCY STARTING EMERGENCY STARTING
EMERGENCY STARTING
EMERGENCY STARTING
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
Do not attempt to start the engine by pulling
Do not attempt to start the engine by pulling Do not attempt to start the engine by pulling
Do not attempt to start the engine by pulling
Do not attempt to start the engine by pulling
or pushing the vehicle.
or pushing the vehicle. or pushing the vehicle.
or pushing the vehicle.
or pushing the vehicle.
2. Operate the hand pump slowly 6 or 7 times
in order to force the water out through thedrain plug.
3. Tighten the drain plug when water no longer comes out.
4. Loosen the air plug and bleed the air. (Refer to "Bleeding the fuel system".)
5. Check to be sure that the warning lamp illuminates when the ignition key is turned to"ON", and that it goes off when the engine isstarted.If in doubt, consult your nearest authorizedHYUNDAI dealer.
WARNING:
WARNING: WARNING:
WARNING:
WARNING:
(1)(1)
(1)(1)
(1) Do not smoke or have any other open
Do not smoke or have any other open Do not smoke or have any other open
Do not smoke or have any other open
Do not smoke or have any other open
flame near the vehicle while bleeding the
flame near the vehicle while bleeding the flame near the vehicle while bleeding the
flame near the vehicle while bleeding the
flame near the vehicle while bleeding the
fuel system.
fuel system. fuel system.
fuel system.
fuel system.
(2)(2)
(2)(2)
(2) Be sure to carefully wipe away any water
Be sure to carefully wipe away any water Be sure to carefully wipe away any water
Be sure to carefully wipe away any water
Be sure to carefully wipe away any water
drained out in this manner, because the
drained out in this manner, because the drained out in this manner, because the
drained out in this manner, because the
drained out in this manner, because the
fuel mixed in the water might be ignited
fuel mixed in the water might be ignited fuel mixed in the water might be ignited
fuel mixed in the water might be ignited
fuel mixed in the water might be ignited
and result in a fire.
and result in a fire. and result in a fire.
and result in a fire.
and result in a fire.

IN CASE OF EMERGENCY
IN CASE OF EMERGENCY IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
4-15
E120A01P-GATFUSES
FUSES FUSES
FUSES
FUSES
HSR4021
To prevent damage to the electrical system due to short-circuiting or overloading, each individ-ual current circuit is provided with a fuse. The fuse housing is located under the dash- board on the driver's side. E120B01P-GAT Fuse load capacity
Fuse load capacity Fuse load capacity
Fuse load capacity
Fuse load capacity
The fuse housing cover lists the names of the electrical systems and the fuse capacities. E120C01P-GAT
Spare fuse
Spare fuse Spare fuse
Spare fuse
Spare fuse
Spare fuses are contained in the fuse housing. Always use a fuse of the same capacity forreplacement.
GS40360A
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
(1)(1)
(1)(1)
(1) Do not allow the jumper cable clips to
Do not allow the jumper cable clips to Do not allow the jumper cable clips to
Do not allow the jumper cable clips to
Do not allow the jumper cable clips to
touch one another.
touch one another. touch one another.
touch one another.
touch one another.
(2)(2)
(2)(2)
(2) Do not connect the jumper cable to the
Do not connect the jumper cable to the Do not connect the jumper cable to the
Do not connect the jumper cable to the
Do not connect the jumper cable to the
negative terminal of the flat battery.
negative terminal of the flat battery. negative terminal of the flat battery.
negative terminal of the flat battery.
negative terminal of the flat battery.
The battery generates explosive gas, and
The battery generates explosive gas, and The battery generates explosive gas, and
The battery generates explosive gas, and
The battery generates explosive gas, and
a spark caused when the jumper cable is
a spark caused when the jumper cable is a spark caused when the jumper cable is
a spark caused when the jumper cable is
a spark caused when the jumper cable is
disconnected from the negative terminal
disconnected from the negative terminal disconnected from the negative terminal
disconnected from the negative terminal
disconnected from the negative terminal
could ignite this gas and cause an explo-
could ignite this gas and cause an explo- could ignite this gas and cause an explo-
could ignite this gas and cause an explo-
could ignite this gas and cause an explo-
sion.
sion. sion.
sion.
sion.
(3)(3)
(3)(3)
(3)
Be careful that the jumper cable becomes
Be careful that the jumper cable becomes Be careful that the jumper cable becomes
Be careful that the jumper cable becomes
Be careful that the jumper cable becomes
not caught in the cooling fan, etc.
not caught in the cooling fan, etc. not caught in the cooling fan, etc.
not caught in the cooling fan, etc.
not caught in the cooling fan, etc.
8. Start engine as described in "Starting the engine".
9. After the engine is started, disconnect the cables in the reverse order. E120D01P-GAT
Changing a fuse
Changing a fuse Changing a fuse
Changing a fuse
Changing a fuseGS40380A
Good
Blown
1. Before replacing a fuse, be sure to turn off the electrical item concerned.
2. Remove the fuse housing cover.
3. Referring to the fuse load capacity table, check the fuse pertaining to the problem.
4. If the fuse is blown, pull it straight out. If it is not blown, something else must be causing the problem; contact an authorizedHYUNDAI dealer to have the problemchecked.
5. Insert a new fuse of the same capacity securely into the clip.
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
(1)(1)
(1)(1)
(1) If the newly inserted fuse blows again
If the newly inserted fuse blows again If the newly inserted fuse blows again
If the newly inserted fuse blows again
If the newly inserted fuse blows again
after a short time, the cause should be
after a short time, the cause should be after a short time, the cause should be
after a short time, the cause should be
after a short time, the cause should be
diagnosed and corrected by an autho-
diagnosed and corrected by an autho- diagnosed and corrected by an autho-
diagnosed and corrected by an autho-
diagnosed and corrected by an autho-
rized HYUNDAI dealer.
rized HYUNDAI dealer. rized HYUNDAI dealer.
rized HYUNDAI dealer.
rized HYUNDAI dealer.