
At a glance
Controls
Driving tips
Mobility
Reference
 73
Tire condition
Tire tread – Tire damage
Inspect your tires frequently for tread wear, 
signs of damage and for foreign objects 
lodged in the tread. Check the tread depth.
Tread depth should not be allowed to go 
below 
1/8 in / 3 mm, even though in 
Europe, for example, the legally specified 
minimum tread depth is only 
1/16 in / 
1.6 mm. 
Tread wear indicators in the tread-groove 
base – see arrow – are distributed around 
the wheel circumference and are labeled 
on the tire sidewall as TWI – Tread Wear 
Indicator. At a tread depth of 
1/16 in / 
1.6 mm, the indicators signal that the 
legally permissible wear limit has been 
reached. 
Avoid overloading the vehicle so that 
the permitted load on the tires is not 
exceeded. Overloading can cause over-
heating and damage inside the tires.
The ultimate result can assume the form of 
a sudden air loss.
Unusual vibrations encountered during 
normal vehicle operation can indicate tire 
failure or some other vehicle malfunction. 
This type of problem can be caused by 
contact with curbs, etc.  This is also true for 
irregularities in the vehicle's handling char-
acteristics, such as a pronounced ten-
dency to pull to the left or right. Should this 
occur, respond by immediately reducing 
your speed. Proceed carefully to the near-
est BMW center or professional tire center, 
or have the vehicle towed there to have it 
and its wheels or tires inspected.
Tire damage – up to and including sudden and complete air loss – can pose an 
extreme hazard for both vehicle occupants 
and other road users.<
Tire replacement
To maintain good handling and vehicle 
response, use tires of a single tread config-
uration from a single manufacturer. 
BMW advises against using retreaded 
tires as this could negatively affect 
driving safety. This is due to possible varia-
tions in casing structures and, in some 
cases, to their extreme age, factors which 
can lead to a decrease in their durability.<
Tire age
The date on which the tire was manufac-
tured is indicated by the code on the side-
wall:
DOT … 3602 indicates that the tire was 
manufactured in week 36 of the year 2002.
BMW recommends the replacement of all 
tires every 6  years at the latest, even if a tire 
usage of 10 years is possible.
Run Flat tires
When replacing tires, always use 
Run Flat tires since a spare wheel is 
not provided to replace a flat tire.
Run Flat tires are labeled on the sidewall 
with a circular symbol containing the letters 
RSC. Refer to page 75.<
DOT quality grades
Tread wear 
Traction AA A B C 
Temperature A B C
All passenger car tires must conform 
to Federal Safety Requirements in 
addition to these grades.< 
Tread wear
The tread wear grade is a comparative rat-
ing based on the wear rate of the tire when 
tested under controlled conditions on a 
specified government test course. 
For example, a tire graded 150 would wear  

Wheels and tires
76
Winter tires
Choosing the right tire
BMW recommends Run Flat winter tires – 
M+S – for operation under inclement winter 
driving conditions. While all-season tires 
with the M+S identification mark do indeed 
possess better winter traction than summer 
tires that have the H, V, W, Y and ZR speed 
ratings, they generally do not provide the 
same levels of performance as true winter 
tires.
In the interests of sure tracking and safe 
steering response, mount winter tires 
which are made by the same manufacturer 
and which have the same tread configura-
tion on all four wheels.
Your BMW is equipped with Run Flat tires. 
Please consult your BMW center if you 
wish to replace the tires of your BMW or 
change from summer to winter tires, or vice 
versa.
When replacing tires or changing from 
summer to winter tires – or vice versa – 
use only Run Flat tires since a spare tire will 
not be available in the event of a flat tire.<
Comply with recommended speed
Never exceed the maximum speed for 
which the winter tires are rated.
Unprofessional attempts by laymen to ser-
vice tires can lead to damage and acci-
dents.
Have this work performed by skilled pro-
fessionals only. Any BMW center has the 
required technical knowledge and the 
proper equipment and will be happy to 
assist you.<
Tire condition, tire pressure
Once the tire wears to below 3/16 in / 
4 mm, winter tires display a perceptible 
decrease in their ability to cope with winter 
driving conditions, and should be replaced 
in the interest of safety.
Comply with the specified tire inflation 
pressures – and be sure to have the wheel 
and tire assemblies balanced every time 
you change the tires.
Storage
Store tires in a cool, dry place, protecting 
them against light whenever possible. Pro-
tect the tires from contact with oil, grease 
and fuel.
Snow chains*
Only certain types of snow chains have 
been tested by BMW, classified as road-
safe and approved. Consult your BMW 
center for more information. BMW recom-
mends using only approved fine-link snow 
chains.
Their use is only permitted in pairs on the 
winter tires on the rear wheels. Comply 
with all manufacturer's safety precautions 
when mounting the chains.
You cannot mount snow chains on the fol-
lowing tires:
245/40 R 17
255/35 R 18
Do not exceed a speed of 30 mph / 
50 km/h when using snow chains.<
Do not initialize the Flat Tire Monitor 
after snow chains have been 
mounted.
When driving with snow chains, it may be 
useful to deactivate the DSC briefly. Refer 
to page 51.< 

At a glance
Controls
Driving tips
Mobility
Reference
 87
1.Remove the cover by turning the lock to 
the right; refer to the detail in the illus-
tration
2.Applying light pressure, turn the bulb to 
the left. Remove and exchange the bulb
3.Reinstall the cover.
Center high-mount brake lamp
The LED strip is in the luggage compart-
ment lid.
Please contact a BMW center in case of a 
malfunction.
License plate lamps
5 watt bulb
1.Push out the lamp with a suitable object 
and remove it
2.Replace the bulb.
Snap the lamp back into place.
Changing a wheel
Run Flat tires
Your BMW is equipped with Run Flat tires. 
Therefore, the wheel no longer has to be 
changed immediately in the event of a loss 
in inflation pressure.
Run Flat tires are labeled on the sidewall 
with a circular symbol containing the letters 
RSC. Refer to page 75.
BMW recommends that you consult your 
BMW center if you wish to replace the tires 
of your BMW, or change from summer to 
winter tires or vice versa. 
Your BMW center knows how to work with 
Run Flat tires and is equipped with the nec-
essary special tools.
When replacing tires or changing 
from summer to winter tires – or vice 
versa – use only Run Flat tires since a spare 
tire will not be available in the event of a flat 
tire.<
Jacking points
The jacking points are located at the posi-
tions indicated in the illustration.
Your BMW center can provide you 
with a suitable jack.<
Battery
Maintenance
The battery is completely maintenance-
free. This means that the original electro-
lyte will normally last for the service life of 
the battery under moderate climatic condi-
tions.