2003 BMW MOTORRAD F 650 CS weight

22
Safety check
2
Checklist
For this reason, check the
details in the following sections
before you start the journey:
–Fuel level
–Clutch-lever play
– Brake pressure
– Brake fluid levels (front and rear)
–Drive belt
– Warning lights and telltale lights
– Wheel rim and tyre condition, tread depth and tyre pres-
sures – Load and gross weight
–Coolant level
– Lights
– Check regularly (every time
you stop for fuel), on the basis
of the following section:
– Engine oil level (every second stop for fuel)
– Brake pads
If you encounter any problems
or difficulties, it is always best
to contact your authorised
BMW motorcycle dealer. He will
provide the necessary advice
and assistance.
10K14bkg2.book Seite 22 Montag, 15. September 2003 5:30 17

36
Safety check
2
Spring preloadOE
Adjusting
spring preload
d Warning:
Before the journey starts, ad-
just spring preload to suit the
gross weight/load on the mo-
torcycle.
For safety reasons, never at-
tempt to alter spring preload
while the motorcycle is being
ridden.
Always bring the motorcycle to
a standstill before adjusting.
 Prop the motorcycle on its side
stand
 Adjust spring preload by turn-
ing knob 1
OEOptional extra
Basic setting, one-up,
rider up to 85 kg (187 lbs):
Turn knob 1 as far as it will go
counter-clockwise in the direc-
tion indicated by the “LOW”
arrow
Setting for two-up and
luggage:
Turn knob 1 clockwise in the
direction indicated by the
“HIGH” arrow until spring
preload suits your preferences.
Turn the knob as far as it will go
in the “High” direction if the
motorcycle is loaded to the limit
of its load-bearing capacity
1
10K14bkg2.book Seite 36 Montag, 15. September 2003 5:30 17

1
37
Safety check
2
Shock-absorbersOE
Adjusting shock absorber
d Warning:
Before starting the journey,
adjust the shock absorber to
match total weight.
If spring preload is changed,
it is essential to adjust the
shock-absorber setting ac-
cordingly.  Adjust the shock absorber
with a screwdriver
Firm setting “H”:
 Fully tighten adjusting screw 1
Basic setting:
 Back off adjusting screw 1
through
3/4 of a turn to one full
turn
Soft setting “S”:
 Fully back off adjusting screw 1
OEOptional extra
1
10K14bkg2.book Seite 37 Montag, 15. September 2003 5:30 17

1
39
Safety check
2
Wheels
Checking tyre pressures
d Warning:
Incorrect tyre pressures have
a considerable influence on
handling and on tyre life.
Adjust tyre pressures to suit
total weight. Never exceed
either the motorcycle’s gross
weight or the individual wheel
load limits (
b41).
At high road speeds, tyre
valves have a tendency to
open as a result of centrifugal
force.
Use only metal valve caps
with rubber seals.
Valve caps that are screwed
on well prevent air from es-
caping suddenly. –Tyres cold:
 Unscrew and remove valve
cap
 Check/correct tyre pressure
Tyre pressures: front rear
One-up 2.2 bar 2.5 bar (32 psi) (36.3 psi)
Two-up
and luggage 2.2 bar 2.5 bar (32 psi) (36.3 psi)
 Screw the valve caps back on tightly
10K14bkg2.book Seite 39 Montag, 15. September 2003 5:30 17

1
41
Safety check
2
Correct loading
d Warning:
Overloading can impair the
handling of your motorcycle.
 Make sure that the weight is uniformly distributed
 Pack heavy items at the bot- tom and toward the inboard
side
 Max. load for luggage carrier
and softbag for stowage com-
partment is 5kg (11 lb) each
 Check that fastenings are
correctly positioned and tight
d Warning:
Case systems can impair the
handling of your motorcycle.
Use only genuine BMW ac-
cessories.
e Attention:
Do not exceed the gross weight
limit of 370 kg (815 lb) .
Do not exceed the wheel load
limits of 200 kg (441 lb) at the
front and 270 kg (595 lb) at the
rear.
The total weight is the sum of:
– motorcycle with full tank
–rider
–passenger
– luggage
Accessories and loads
10K14bkg2.book Seite 41 Montag, 15. September 2003 5:30 17

46
Safety check
2
Headlight adjustment,
up/down
L Note:
Do not prop the motorcycle on
the side stand.
 Check tyre pressures and
correct if necessary.
 Position the motorcycle on a
level surface 10 metres
(33 feet) (headlight) from a
light-coloured wall, and with
the rider's weight (approx.
85 kg/187 lbs) on the seat
 Measure the distance H from
the ground to the centre of
the headlight
 Transfer this height H to the
wall and draw a cross on the
wall at this point
 Draw a second cross
(x = 10 cm/3.98 in) lower  Switch on the low-beam
headlight
 Turn adjusting screw 2 to
align the headlight in such a
way that the light-dark cutoff
starts in the middle of the bot-
tom cross and rises to the
right to the height of the upper
cross, before dropping again
e Attention:
Use adjusting screw 1 only for
adjusting the basic setting of
the headlight.
L Note:
Have the headlight basic set-
ting checked by a specialist
workshop, preferably an
authorised BMW motorcycle
dealer.
Lights
10K14bkg2.book Seite 46 Montag, 15. September 2003 5:30 17

3
52
Starting – Riding – Parking
Placing motorcycle on
side stand
d Warning:
For safety reasons, never sit
on the motorcycle with the
side stand extended.
e Attention:
Stop the engine before using
the side stand.
Make sure the surface under
the stand is firm.
On a gradient, the motorcycle
should always face uphill; se-
lect 1st gear.  Switch off the ignition
 Keep both feet on the ground
 Hold the left handlebar grip
with your left hand
 Keep your right hand on the
right handlebar grip and the
handbrake lever
 Hold the motorcycle upright and balanced
 U s e y o u r le f t f o o t a t t h e e x t e n -
sion pin to extend the side
stand fully (arrow)
 Slowly lean the motorcycle to the side until its weight is
taken by the stand and dis-
mount from the motorcycle
 Turn the handlebars to full left
lock (
b9)
 Check that the motorcycle
is firmly supported
Side stand
10K14bkg2.book Seite 52 Montag, 15. September 2003 5:30 17

3
53
Starting – Riding – Parking
Removing motorcycle
from side stand
d Warning:
Make sure the side stand is fully
retracted before you ride off.
– Riding with the side (prop) stand extended represents
a safety risk.
 Turn the ignition key to the “R” or “ON” position (
b9)
– Handlebars unlocked  Both feet on the ground, no
weight on the motorcycle
 Hold the left handlebar grip
with your left hand
 Keep your right hand on the
right handlebar grip and the
handbrake lever
 Slowly raise the motorcycle to
the upright position and keep
it balanced
 Sit on the motorcycle and use your left foot to retract the
side stand
Side stand
10K14bkg2.book Seite 53 Montag, 15. September 2003 5:30 17