2003 Acura CL Owner's Manual

To get into the rear seat, open the
door and pull the release lever up on
thesideof theseat-back.Theseat-
back will tilt f orward and the entire
seat will move forward to allow
easier entry to the rear seat.After you return the seat-back to the
upright position, the seat bottom will
automatically return to its original
position.
If the seat runs into any obstacle,
such as a large package on the floor
between the f ront and rear seats
while it is moving back to its original
position, the seat will stop and move
f orward slightly.
Remove the obstacle, then move the
seat to the desired position with the
adjustment switch.
To move the driver’s seat, you can
select the memorized position with
the memory button.
Sitting down heavily in the seat as it
is moving backward can also cause
the seat to react as if it has run into
an obstacle.
Rear Seat Access
Seat A djustments
Inst rument s and Cont rols94
R RE
EL
LE
E A
A S
SEE L
LEE V
V E
ER
R

See page f or important saf etyinf ormation and a warning about how toproperly position the head restraints. 15
The f ront head restraints help
protect you and your passenger f rom
whiplash and other injuries. They are
most ef f ective when you adjust them
so the back of the occupant’s head
rests against the center of the
restraint. A taller person should
adjust the restraint as high as
possible.
The f ront head restraints adjust f or
height. You need both hands to
adjust the restraint. Do not attempt
to adjust it while driving. To raise it,
pull upward. To lower the restraint,
push the release button sideways
and push the restraint down. To remove a head restraint f or
cleaning or repair, pull it up as f ar as
it will go. Push the release button
and pull the restraint out of the seat-
back.
Head Restraints
Seat A djustments
Inst rument s and Cont rols95
R RE
EL
LEE A
A S
SEE B
BUUT TT
TO
ON N

The lid of the console compartment
canbeusedasanarmrestbymoving
it f orward and backward. Make sure
the armrest is securely latched.The rear seat armrest is located at
the center of the rear seat. Pivot it
down to use it.
Make sure the passenger’s hands or
fingersareawayfromthearmrest
bef ore moving it.
Armrest
Inst rument s and Cont rols96

The pass-through cover can be
opened f rom either side; it f olds
f orward onto the center armrest.
Open the cover by sliding the knob
downward and pushing or pulling on
the cover. To close the cover, swing
it up and push f irmly on the top.
Make sure it latches properly.Make sure all items in the trunk and
those extending through the pass-
through are secured.
For security, this cover can be
locked and unlocked only with the
master key. To lock the cover, insert
thekeyandturnitclockwise.
Never drive with this cover open and
the trunk lid open.
See
on
page . 52
T runk Pass-through Cover
Carbon Monoxide Hazard
Armrest
Inst rument s and Cont rols97
K KNNO OBB
C
CO OV VE
ER
R

Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side).
Adjust the outside mirrors with the
adjustment switch on the driver’s
door armrest:
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror can automatically
darken to reduce glare. To turn on
this feature, press the button on the
bottom of the mirror. The AUTO
indicator comes on as a reminder.
When it is on, the mirror darkens
when it senses the headlights of a
vehicle behind you, then returns to
normal visibility when the lights are
gone. Press the button again to turn
of f this sensing.1.
2. Adjusting the Power Mirrors
Mirrors
Inst rument s and Cont rols98
I IN
ND DI
ICCA A T
TO
OR R S
SE
EL
LEE C
CT TO
OR R S
SWWI ITT C
CH H
A
A U
UT TO
O B
BUUT TT
TO
ON N
S
SE
EN
NS SOOR R
I
INND DI
ICCA A T
TO
OR R
W
Wi
itth h o
ou
ut
t O
On nS
St taar r W
Wi
itth h O
OnnS
St taar r
A
A U
UT TO
O B
BUUT TT
TO
ON N

The outside mirrors are heated to re-
move fog and frost. With the ignition
switchON(II),turnontheheaters
by pressing the button. The light in
the button comes on as a reminder.
Press the button again to turn the
heaters of f .
Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown. When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.
Outside mirror positions can be
stored in the driving position
memory system (see page ). With the selector switch in the
center (of f ) position, the passenger’s
side mirror will pivot downward
slightly when you shif t the
transmission into reverse. This gives
you a better view of that side of the
vehicle while parallel parking. The
mirror returns to its original position
when you take the transmission out
of reverse. 4.
3. 100
Mirrors
Inst rument s and Cont rols99
H HE
EA
A T
TE
ED
D M
MI
IRRR ROOR R B
BUUT TT
TO
ON N
A
A
D
DJ
JUUS STTM
M E
EN
NT T S
SWWI ITT C
CH H

Turn the ignition switch ON (II).
You cannot add a new driving
position in the memory unless the
ignition switch is ON (II). You can
recall a memorized position with
the ignition switch in any position.
Store a driving position as explained
in this section only when the car is
parked.
Your Acura has a memory f eature
f or the driver’s seat and outside
mirror positions.
Two seat and outside mirror
positions, f or dif f erent drivers or
drivingconditions,canbestoredin
separate memories. You select a
memorized position by pushing the
appropriate button or using the
appropriate remote transmitter
(Memory1orMemory2).
Adjust the seat to a comfortable
position (see page ).Press and release the MEMO
buttononthecontrolpanel.You
will hear a beep. Immediately
press and hold one of the memory
buttons (1 or 2) until you hear two
beeps. The indicator light in the
memory button will come on. The
current positions of the driver’s
seat and outside mirrors are now
stored.
Adjust the outside mirrors f or best
visibility (see page ).
3.
1.
2.
91
98
St oring a Driving Posit ion in Memory
Driving Posit ion Memory Syst em
Inst rument s and Cont rols100
M M E
EM
M O
O B
BUUT TT
TO
ON N

Doing any of the f ollowing af ter
pressing the MEMO button will
cancel the storing procedure.Not pressing a memory button
within 5 seconds.
Readjusting the seat position. The system will move the seat and
outside mirrors to the memorized
positions. The indicator light in the
selected memory button will f lash
during movement. When the
adjustments are complete, you will
hear two beeps and the indicator
light will remain on.
Readjusting the outside mirror
position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
All stored driving positions will be
lost if your car’s battery goes dead or
is disconnected. Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
You can select memorized positions
as f ollows.
Make sure the parking brake is set
and the shif t lever is in Park (A/T)
or a f orward gear (M/T). You cannot select a memorized
position if the transmission is in
Reverse. Shif t to another gear,
then select.
If the parking brake is not set, you
must press and hold the memory
button until the adjustment is
complete.
1.
2.
CONT INUED
Notes f or Type-S with M/T
Select ing a Memorized Posit ion
Driving Posit ion Memory Syst em
Inst rument s and Cont rols101
M M
E
EM
M O
ORRYY B
BUUT TT
TO
ON NSS