2002 PEUGEOT 807 handbrake

18-11-2002
14 Windscreen washwipe
stalk.
Trip computer stalk.
15 Audio remote control stalk.
16 Interior alarm disarming
switch.
17 Electric mirror controls.
Window controls.
Rear window locking control.
18 Steering lock and ignition.
19 Dynamic stability control
(ESP/ASR) switch.
20 Headlamp height
adjustment.
21 Fuse box.
22 Handbrake.
23 Steering wheel adjustment
control.
24 Battery / Fuse box.
25 Heated seat switches.
26 Storage. 27
Gear lever.
28 Cooled compartment.
29 Ashtray / Can holder.
30 Storage compartment
or remote control keypad.
31 Lighter / 12 V accessories
socket.
32 Hazard warning lights
switch.
33 Air conditioning controls.
34 Passenger compartment
temperature sensor.
35 Passenger lower glove box.
36 Passenger air bag.
37 Side vent.
38 Bonnet release.
39 Passenger air bag disarming
switch*.
* According to country.
YOUR 807 AT A GLANCE3
1 Side window demisting
vents.
2 Speaker (tweeter).
3 Windscreen demisting
vents.
4 Passenger upper glove box.
5 Brightness sensor.
6 Instrument panel /
Multifunction display.
7 RB3, RD3, RT3 audio
equipment with flap.
8 Central vents.
9 Driver’s upper glove box.
10 Lights and direction
indicators stalk.
11 Cruise control controls.
12 Check unit.
13 Driver’s air bag.
Horn.

YOUR 807 AT A GLANCE13
AUTOMATIC GEARBOX "PORSCHE TIPTRONIC SYSTEM"
The four speed automaticgearbox offers a choice between the comfort of
automatic integral regulation enhanced by a snow programme , or the
pleasure of manual gear changing.
Gear selection gate  Move the lever in the gate to select one of the functions.
Once the function is selected, the indicator light for that function is dis
played on the instrument panel screen.
: snow programme.
P ark: to park or to start the engine, with the handbrake on or off.
R everse:to reverse(select this function with the vehicle stationary and the
engine at idle).
N eutral: to start the engine or to park, with the handbrake on.
Note: if position Nis engaged by mistake
while the car is moving, allow the engine
to return to idling speed before engaging
function Dto accelerate.
D rive: for automatic gear changing.
M anual: for manualgear changing.
To change the four gears manually:
 Push the lever to the + symbol to
change up to the next gear and pull the
handle towards the – symbol to
change down to the next gear.
Note: the
(snow) programme do
esnot
operate when in manual mode. Moving Off
With the engine running, to move
off from position
P:
 It is essential to press the
brake pedal to exit positionP
 Select the function required R,
D or M, then gradually release
the pressure on the brake
pedal; the vehicle will move off
immediately.
You can also move off from posi
tion N:
 Release the handbrake, with
your foot on the brake.
 Select function R, D or M then
gradually release the pressure
on the brake pedal; the vehi
cle will move off immediately.
When the engine is idling with
the brakes not applied, if function
R, D or Mis selected, the vehicle
moves without the accelerator
being pressed.
For this reason, do not leave
children unattended inside the
car, with the engine
running.
132
18-11-2002

Level
Operations Description of operation 1st service
AC Intermediate
LEVEL
CHECK
DRAIN/REFILL
REPLACE
PEUGEOT SERVICING 19
Oil filter.
Fuel filter
*(petrol). Fuel filter element (diesel). Air filter element. Spark plugs (petrol).
Engine oil. Bleed fuel filter (diesel).
Engine oil (check + topup). Manual gearbox oil (check + topup). Battery (check + topup) if cap is removable. Screen wash (check + topup). Coolant (check + topup). Brake fluid (check + topup). Power steering fluid (check + top up according to specification). Operation of lights and indicators. Condition of glass, headlamp and light lenses and mirrors. Horn. Windscreen washer jets. Condition of wiper blades. Condition and tension of the ancillary drive belts. Handbrake. Condition of hydraulic circuits (hoses and covers).
Condition of rubber boots and gaiters. Brake pads.
o Play in hubs, link rods, ball joints, flexible mountings. Shock absorbers. Rear drum brake lining wear. Condition and pressure of tyres (including spare wheel). Emission control check as per current legislation (petrol). Smoke opacity (diesel). Pollen filter (according to specification).

oVisual check of the whole vehicle.

: All driving conditions o: Arduous conditions * According to destination
ROAD TEST
A AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
18-11-2002

26
PETROL / DIESEL CONTROL MODULE
1 Dipped beam headlamps indi
cator light.
2 Main beam headlamps indicator
light.
3 Lefthand direction indicator.
4 Service indicator, oil level
indicator, automatic gearbox
indicator* and total distance
recorder.
5 Front fog lamps indicator light. 6
Righthand direction indicator.
7 Dynamic stability control
ASR/ESP indicator light.
8 Rear fog lamps indicator light.
9 ABS system warning light.
10 Engine diagnostics warning
light.
11 Cruise control indicator light.
12 Lighting rheostat. 13
Handbrake, brake fluid level
and electronic brake force
distribution warning light.
14 Engine oil pressure warning
light.
15 Central (STOP) warning light.
16 Battery charge warning light.
17 Diesel engine preheating
indicator light.
18 Trip recorder zero reset.
19 Driver's seat belt warning light.
20 Passenger air bag disarming
indicator light.
21 Front, side and curtain air bags
warning light.
* According to specification.
INSTRUMENTS AND CONTROLS
18-11-2002

Handbrake,low brake fluid level and electronic brake force distri bution warning light
This is linked to the central STOPwarning light.
It comes on each time the ignition is switched on.
This warning light is accompanied by an audible signal and a message on the multifunction display indicating the
cause of the warning:
– "Handbrake on" , if the handbrake is on or not released correctly while driving ,
– "Brake fluid low" in the event of an excessive drop in the brake fluid level (if the warning light remains lit even with the
handbrake released),
– "Braking fault" , displayed at the same time as the ABS warning light, indicat ing an electronic brake force distribution
system fault.
Stop immediately.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS 29
Dynamic stability control warning light (ESP/ASR)
This comes on each time the ignition is switched on.
If it remains on or comes on with the engine running and th e vehicle moving, it is accompanied by an audible
signal and the message "ESP/ASR not operational" on the multifunction display.
Contact a PEUGEOT dealer.
It flashes when the system is activated and is lit continuously when the system is switched off.
Antilock braking system (ABS) warning light
This comes on each time the ignition is switched on.
If it remains on or comes on above 8 mph (12 km/h), it indicates a
malfunction of the ABS.
However, the vehicle retains conventional servoassisted braking.
Illumination of this warning light is accompanied by an aud ible signal and the message "ABS fault" on the multifunction
display.
Contact a PEUGEOT dealer.
18-11-2002

YOUR 807 IN DETAIL89
THE SEATS
Front seats with manual adjustment
1 Forwards/backwards adjustment
Lift the bar and slide the seat forwards or backwards.
2 Seat back angle adjustment Pull the lever upwards.
3 Driver's seat height adjustment Manoeuvre the handle upwards or downwards until the
desired position is reached.
4 Driver's seat lumbar adjustment Move the lever up or down to obtain the required posi
tion.
5 Head restraint height and angle adjustment To raise or lower the restraint, push it forwards, at the
same time sliding it.
The adjustment is correct when the upper edge
of the head restraint is level with the top of the
head.
To remove it, set it in the high position, lift the tab using
a coin and pull upwards and forwards at the same time.
To reinstall, engage the head restraint rods in the
holes, making sure they are aligned with the seat back.
Never drive with the head restraints removed; they
must be in place and correctly adjusted.
6 Rotating of seats Place the seat back in the upright position and move
the steering wheel forward. Place the seat in the middle position on the runner and at maximum height.
On the driver's side, apply the handbrake, then release,
pulling on the end.
Pull the control upwards and rotate the seat inwards.
This rotating operation must be carried out with the
engine switched off.
The passenger must not be facing the rear when the
vehicle is being driven.
18-11-2002

YOUR 807 IN DETAIL
90
Front seats with electrical adjustment A Forwardsbackward
s adjustment
Push the control forwards or backwards to slide the seat.
B Driver's seat height adjustment Push the rear part of the control upwards or downwards to
obtain the required height.
C Seat back angle adjustment Tilt the control to the front or the rear to obtain the co rrect
angle.
D Driver's seat lumbar adjustment (mechanical) Raise or lower the lever to obtain the correct position.
E Head restraint height and angle adjustment To raise or lower the head restraint, pull forwards, at the
same time sliding it.
The setting is correct when the upper edge of the
head restraint is level with the top of the head.
To remove the head restraint, place it in the high position , lift
the tab using a coin and pull upwards and
forwards at the same time.
To reinstall, engage the head restraint rods in the holes,
making sure they are aligned with the seat back.
Never drive with the head restraints removed; they must be
in place and correctly adjusted.
F Rotating of seats (mechanical) Place the seat back in the upright position and move the
steering wheel forward.
Place the seat in the middle position on the runner andat maximum height.
On the driver's side, apply the handbrake, then release,
pulling on the end.
Pull the control upwards and rotate the seat inwards.
This rotating operation must be carried out with the engine
switched off.The passenger must not be facing the rear when the vehicle
is being driven.
Note: the electrical functions of the seats are cancelled one
minute after the ignition has been switched off.
18-11-2002

When this warning light
comes on, connected to the
STOPwarning light,
accompanied by a buzzer
and the message "Braking
fault" , it indicates that there is a mal
function of the electronic brake force
distribution, which can cause a loss of
control of the vehicle when braking.
Stop immediately.
In both cases, consult a Peugeot
dealer.
ANTILOCK BRAKING
SYSTEM (ABS) AND THE
ELECTRONIC BRAKE FORCE
DISTRIBUTION (EBFD)
The ABS, in conjunction with the elec
tronic brake force distribution, increas
es the stability and manoevrability of
your vehicle, particularly on poor or
slippery road surfaces.
Note: when changing wheels (tyres
and rims), make sure that these are
approved.
The antilock braking system comes
into operation automatically when
there is a risk of wheel lock.
When this warning light
comes on, accompanied by
a buzzer and the message
"ABS fault" , it indicates
that there is a malfunction
of the ABS, which can cause a loss
of control of the vehicle when brak
ing.
YOUR 807 IN DETAIL
128
To return to normal operation, pull
the lever upwards until a click is
heard.Illumination of this light,
accompanied by an audible
signal and the message
"handbrake on" on the
multi–function display, indi
cates that the handbrake is still on or
has not been properly released.
HANDBRAKE
Applying
When parking, pull the handbrake to
immobilize your vehicle.
Warning : when parking on a slope,
direct your wheels towards the pave
ment and pull the handbrake.
Releasing
Pull on the handle and press the but
ton to release the handbrake.
Disengaging
Apply the handbrake.
Pull the button located at the end of
the handbrake forwards.
The handbrake lever lowers.
You can now pivot the seat. EMERGENCY BRAKING
ASSISTANCE SYSTEM
In an emergency, this system
enables the optimum braking pres
sure to be reached more quickly,
thus reducing the stopping distance.
It is triggered according to the speed
of activation of the brake pedal. The
effect of this is a reduction in the
resistance of the pedal and an
increase in braking efficiency. Normal operation of the ABS may
make itself felt by slight vibrations
of the brake system.
In emergency braking, press
very firmly without releasing
the pressure.
18-11-2002