2002 Peugeot 307 Break Dag maintenance

PEUGEOT SERVICING The maintenance cycle of your 307 is based on level A(including the replacement of the engine oil, the oil filter and a set
of checks) and level Cservices [ level Aservice + workshop operations carried out every 40,000 miles (60 000 km)] in
accordance with the tables on the following pages. So that the driving conditions and your style of driving, may be taken into account, your 307 is fitted with a service
indicator which modulates the intervals for level A service:
¥ every 20,000 miles (30 000 km) maximum or 2 years for petrol engines,
¥ every 12,000 miles (20 000 km) maximum or 2 years for direct injection diesel engines,
The frequency of level Aservices specific to your vehicle will be determined by three parameters :
¥ the number of engine revolutions,
¥ the engine oil temperature,
¥ prolonged periods when the vehicle is not in use. Depending on these three elements, the service indicatorwill suggest a service interval which is more or less the same as
the initial programme. Depending on the conditions of use, one or more level Aservices may be carried out between two
level C services.
Depending on the mileage recorded, your dealer may offer to carry out the level Cservice to avoid the visits being too close
together.
PEUGEOT SERVICING
18

Zero re-set
Your PEUGEOT dealer carries out this operation after each service.
However, if you carry out the serviceyourself, the re-set procedure is asfollows: Switch off the ignition,
Press and hold the trip recorder re-set button,
Switch on the ignition.
The display begins a countdown. When the display shows 0, release the button; the service symbol disap-pears. Important: after this operation, if you
wish to disconnect the battery, lock the vehicle and wait for at least fiveminutes, otherwise the zero re-setwill not be registered.
PEUGEOT SERVICING 21
MAINTENANCE OF PARTS SUBJECT TO WEAR and a check of consumables Certain essential components on your vehicle are subject to checks at specific frequencies:
- The brake fluid is to be replaced at a maximum of every 36,000/40,000 miles
(60 000km) or every two years.
- The pollen filter must be checked at each serviceby a PEUGEOT dealer
(services and intermediate visits) or more often, depending on the environment (dust, pollution, etc.).
- For the 2 litre HDI turbo diesel engine (110 bhp) , maintenance of the parti-
culate emission filter and topping up of the additive reservoirmust be car-
ried out at a maximum of every 48,000 miles (80 000 km) by a PEUGEOT
dealer.
- Air bags and pretensioning parts on seat belts must be replaced every
10 years.
- The check on tyre inflation pressure must be carried out cold at least once
a month .

MILES (KM) 40 000 (60 000)80 000 (120 000) 120 000 (180 000)
THE SERVICE LEVELS Each vehicle has its own servicing cycle, based upon the engine type.
This cycle consists of alternating 2 types of service, A and C, intermediate visits and a few additional operations specific to your vehicle; these correspond to key stages in the life of your 307. At your first and each subsequent service, your dealer will advise you of the type and content of the next service due.
PEUGEOT SERVICING
22
MAINTENANCE CYCLE FOR YOUR 307 PETROL ENGINE
Service every 2 years or 20 000 miles (30 000 km) maximum
1st service at 6 000 miles
(10 000 km) or 6 months*.
This is necessary in order to benefit from the warranty.
Replacement of automatic gearbox oil every 40 000 miles (60 000 km). Replacement of brake fluidevery 2 years or 40 000 miles (60 000km).
These fixed operations are carried out with synthetically based oil. Synthetic oilor
Fuel economy oil may also be used.
Arduous conditions of use (corresponding section).
- Replacement of air filterevery 24 000 miles (40 000km).
- Replacement of timing beltevery 48,000 miles (80 000km).
* Whichever comes first.
+ replacement of timing belt
Intermediate visit included in the fixed interval services.

72 ,000 (120 000)108,000 (180 000)
MILEAGE
36 ,000 (60 000)
PEUGEOT SERVICING 23
MAINTENANCE CYCLE FOR YOUR 307 DIESEL
Service every 2 years or 12 000 miles (20 000km) maximum
1st service at 6,000 miles
(10 000km) or 6 months*.
This is necessary in order to benefit
from the warranty.
Replacement of timing beltevery 100,000 miles (160 000 km) (2,0 l HDI 90 bhp/110 bhp) and every 165,000 miles
(240 000 km) (1,4 l HDI 70 bhp). Replacement of brake fluidevery 2 years or 36,000 miles (60 000 km).
These fixed operations are carried out with synthetically based oil.
Synthetic oil or Fuel Economy oil may also be used.
Arduous conditions of use (see corresponding section).
- Replacement of air filterevery 27,000 miles (45 000km).
- Replacement of timing belt every 96,000 miles (120 000km).
* Whichever comes first. Intermediate visit included in the fixed interval services.
+ maintenance of
particulate
emission filter
2,0 l HDI 110 bhp (160 000 km) + maintenance of
particulate
emission filter
2,0 l HDI 110 bhp (80 000 km)

RECOMMENDATIONS FOR APPROVED LUBRICANTS The oils which appear in the table opposite are suitable for most pur-poses. The diagram opposite states the optimum range of viscosity depen-ding on the temperatures at whichthe oils are to be used It is also possible to use "superior quality" synthetic oils. In the absence of semi-synthetic or
synthetic oils, oils of API SH/SJ qua-lity (for petrol engines), or CD/CF (fordiesel engines) may be used by fol-lowing the "Arduous Conditions" ser-vicing schedule which specifies shor-ter intervals. Do not hesitate to ask for advice
from a PEUGEOT dealer to maintaindriving pleasure and to minimise themaintenance cost of your vehicle. For countries outside Europe, please
contact a local PEUGEOT dealer.
PEUGEOT SERVICING27
ONLY ONLY
Manual ESSO GEAR OIL BVTOTAL TRANSMISSION BVGearbox 75W80 PR 9736.41 75W80 AL4 ONLY
Automatic ATF 4HP20-AL4
Gearbox PR 9736.22
Other approved products
Power steering FLUIDE DA PR 9730.A1
Brake fluid PEUGEOT DOT4 Coolant
PROCOR TM108/GLYSANTIN G33 or REVKOGEL 2000
ONLYProtection to minus 35C

Maintenance position This position enables the wiper blade to be removed.
In the minute following switching off of the ignition, any action on the stalkpositions the wipers in the centre ofthe windscreen (winter parking, clea-ning, replacing the blades).
To reposition the wipers after this has been done, switch on the ignitionand operate the stalk.
* According to specification
YOUR 307 IN DETAIL75
When using an automatic car wash, switch off theignition or check that thewiper control is not in theautomatic position.
In winter it is advisable to wait forthe windscreen to completelyclear of ice before operating theautomatic wipe. Rear windscreen wiper
Turn ring
Ato the first notch for inter-
mittent wiping. Rear windscreen wash
Turn ring Apast the first notch; the
windscreen wash then the wind- screen wiper operate for a specifiedtime.

S: sport programme.


: snow programme.
P ark: to park the vehicle or start the engine , with the
handbrake on or off.
R everse: for reversing (select this function with the
vehicle stationary, engine at idle).
N eutral: to start the engine and to park, with the hand-
brake on. Note: if position Nis inadvertently engaged while dri-
ving, allow the engine to return to idle before engaging function Dto accelerate.
D rive : for driving in automatic mode.
M anual: for driving in manual mode.
YOUR 307 IN DETAIL
86
Moving Off
With the engine running, to move off from position P:
it is essential to press the
brake pedal to exit position P,
select function R, D or M, then
gradually release the pressureon the brake pedal; the vehicle
moves off immediately.
You can also start from function N:
release the handbrake, with yourfoot on the brake,
select function R, D or M, then
gradually release the pressureon the brake pedal; the vehicle
moves off immediately.
WARNING When the engine is at idle, brakes not applied, if function R, D or Mis
selected the vehicle moves evenwithout the accelerator being pres-sed.For this reason, do not leave
children unsupervised inside thevehicle, with the engine running. When maintenance operations need to be carried out with the engine run-ning, apply the handbrake and selectposition P.
"PORSCHE TIPTRONIC SYSTEM" AUTOMATIC GEARBOX The four speed
automatic gearbox offers a choice between the comfort of inte-
gral automatic operation , enhanced by a sport and a snow programme, or the
pleasure of manual gear changing.
Gear selection gate Move the lever in the gate to select a function. Once the function is selected, the corresponding indicator light appears on
the instrument panel display.

CHANGING A WINDSCREEN WIPER BLADE Placing the wiper blades in the maintenance position Less than one minute after swit-
ching off the ignition, activate thewindscreen wiper stalk to posi-tion the blades in the centre ofthe windscreen (maintenanceposition).
Replacing a blade Lift the arm, then unclip the blade and remove it.
Fit the new blade and fold downthe arm.
Note: the shortest blade is fitted to
the wiper arm on the right side of thevehicle.
To park the blades, switch on the ignition and operate the wind-screen wiper stalk. ECONOMY MODE FUNCTION After the engine has stopped, certain
functions (windscreen wiper, electricwindows, sunroof*, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multifunction displayand the active functions are put on
standby.
To resume use of these functions, start the engine and let it run for afew seconds.
WARNING: a flat battery will prevent
the engine from starting. LOAD REDUCTION When driving, certain functions (air conditioning*, heated rear screen,heating system for passenger com-partment of diesel vehicles, etc.)
may be switched off temporarily,depending on the level of batterycharge. Reactivation of these functions is automatic, once the battery charge is
sufficient. Note:
at the risk of discharging the
battery, the functions that have been switched off may be reactivated
manually.
* According to specification.
PRACTICAL INFORMATION
110