2002 Peugeot 307 Break Dag diagram

RECOMMENDATIONS FOR APPROVED LUBRICANTS The oils which appear in the table opposite are suitable for most pur-poses. The diagram opposite states the optimum range of viscosity depen-ding on the temperatures at whichthe oils are to be used It is also possible to use "superior quality" synthetic oils. In the absence of semi-synthetic or
synthetic oils, oils of API SH/SJ qua-lity (for petrol engines), or CD/CF (fordiesel engines) may be used by fol-lowing the "Arduous Conditions" ser-vicing schedule which specifies shor-ter intervals. Do not hesitate to ask for advice
from a PEUGEOT dealer to maintaindriving pleasure and to minimise themaintenance cost of your vehicle. For countries outside Europe, please
contact a local PEUGEOT dealer.
PEUGEOT SERVICING27
ONLY ONLY
Manual ESSO GEAR OIL BVTOTAL TRANSMISSION BVGearbox 75W80 PR 9736.41 75W80 AL4 ONLY
Automatic ATF 4HP20-AL4
Gearbox PR 9736.22
Other approved products
Power steering FLUIDE DA PR 9730.A1
Brake fluid PEUGEOT DOT4 Coolant
PROCOR TM108/GLYSANTIN G33 or REVKOGEL 2000
ONLYProtection to minus 35C

Low coolant level warning light* Linked to the central STOPwarning light.
This comes on for approximately 3 seconds each time the ignition is switched on. This warning light is accompanied by an audible signal and the messa-
ge "Top up coolan" t on the multifunction display.
Stop immediately.
Warning: Allow the engine to cool before topping up.
The cooling system is pressurised. Central STOP warning light This is linked to the "engine oil pressure", ''oil temperature''*, ''coolant level low'', ''brake fluid level'', electronic brake force distribution fault'',and ''coolant temperature gauge'' warning lights, as well as warnings
of openings, indicated by a diagram on the multifunction display. This light comes on each time the ignition is switched on.Stop immediately if it flashes with the engine running.
Contact a PEUGEOT dealer.
Engine oil pressure warning light Linked with the central STOPwarning light.
If it comes on with the engine running, it is accompanied by an audible signal and the message "Oil pressure low"or "Top up engine oil" on
the multifunction display.
Stop immediately.If there is a lack of oil in the lubrication circuit, top up the level.
Contact a PEUGEOT dealer without delay.
INSTRUMENTS AND CONTROLS
A permanently lit warning light or one that flashes with the engine running, indicates an operating fault in the relevant unit. Some warning lights may
be linked to buzzers and a message on the multifunction display. Do notignore this warning: contact a PEUGEOT dealer as soon as possible.
If the Central STOP warning light comes on when you are driving, stop immediately where it is safe to do so.
To prevent the risk of scalding, uns-crew the cap by two turns to allowthe pressure to drop. Once the pressure has dropped, remove the cap and topup the level.
Contact a PEUGEOT dealer.
Handbrake and low brake fluid levelwarning light Linked to the central STOP
warning light. This comes on each time the ignition is switched on. Illumination of this light is accompa- nied by an audible signal and a mes-sage on the multifunction displayindicating the cause of the warning: - ''Handbrake on'' ,if the handbrake
is applied or has not been released
correctly,
- ''Low brake fluid level'' if there is
an excessive drop in the brakefluid (if the light remains on evenwith the handbrake released),
- ''Brake system problem'' is dis-
played simultaneously with theABS light, indicating a malfunctionof the electronic brake force distri-bution.
Stop immediately.
Contact a PEUGEOT dealer. *Depending on engine
INSTRUMENTS AND CONTROLS
30

Locking / Unlocking from the inside Press button A.
This allows locking or unlocking of the doors and the tailgate. Note: if the vehicle is deadlocked,
button Adoes not function. In this
case use the remote control for unlocking. "Door open" alert With the engine running or the vehicle moving, the flashing of thecentral "STOP" warning light,
accompanied by an audible signaland a diagram locating the problem
on the multifunction display, warnsyou that a door is not properly clo-sed.
THE DOORS Opening the doors from outside Opening the doors from inside The front door unlocking controls permit complete unlocking of thevehicle.
However, the rear door unlocking controls only unlock the door concerned. Note:
the door opening switches do
not function when the vehicle is deadlocked.
Child safety This prevents either of the rear doors being opened from inside. Turn the red plastic switch a quarter of a turn using the ignition
key.
YOUR 307 IN DETAIL 69

TAILGATE Simultaneous locking or unlocking of the tailgate andthe doors The tailgate is locked or unlocked by the remote control or the driver's door lock.
To open, pull handle Aand lift the
tailgate.Note: the tailgate locks automatical-
ly when the vehicle is being driven at 6 mph (10 km/h) and unlocks whenone of the doors is opened or at aspeed below 6 mph (10 km/h).
"Tailgate open" warning When the engine is running or if the vehicle is being driven, the flashingof the central "STOP"warning light
accompanied by an audible signaland a diagram on the multifunctiondisplay warns you that the tailgate isnot properly closed. Tailgate release This enables the tailgate to be unloc- ked in the event of a central lockingfault.
- Fold back the rear seats to gain
access to the lock from inside the boot,
- Insert a small screwdriver into hole A of the lock to unlock the tailgate. THE SUNROOF* -
to partially open the roof: Turn
the switch to the right (three pos- sible settings).
- to close: Turn the switch back to
position "O".
- to open the roof completely:
Turn the switch to the left (six pos-sible settings).
- to close it completely: Turn the
switch back to position "O".
- safety auto-reverse: When the
sunroof is closing and meets anobstacle, it stops then opensagain.
- After a safety auto-reverse manoeuvre, to synchronise theposition of the switch with the roofposition, press and hold the switch.
Note: the sunroof shutter is manual.
* According to specification.
YOUR 307 IN DETAIL
70

FILLING WITH FUEL Low fuel levelWhen the minimum fuel level in the tank is rea-ched, this warning lightcomes on.
You can still drive
approximately 30 miles (50 km). Flashing of the warning light indi- cates a malfunction of the fuelgauge.
Contact a PEUGEOT dealer.The engine must be switched off when filling with fuel.
OPENING THE BONNET From inside: push the handle on the
driver's side under the fascia. From outside: lift the catch and
raise the bonnet. Bonnet strut Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is properly locked. "Bonnet open" warning* With the engine running or the vehicle moving, flashing of the central
"STOP" warning light accompanied by an audible signal and a diagram
on the multifunction display, warnsyou that the bonnet is not properlyclosed.

Open the fuel filler flap.
Insert the key then turn it to theleft.
Remove the cap and hang it onthe hook located on the inside ofthe flap.
A label affixed inside the fuel fillerflap indicates which type of fuel touse. When you fill your tank, do not conti-
nue after the third cut-off of the
pump. This could cause your vehicleto malfunction. The capacity of the tank is approxi- mately 12 gallons (60 litres). After filling the tank, lock the cap and close the fuel filler flap.
* According to specification.
YOUR 307 IN DETAIL 71

Place the jack 4in contact with
one of the four locating points A
on the sub-frame, (the one which is closest to the wheel to bechanged).
Extend the jack 4until its base is
in contact with the ground.Ensure that the centre line of thebase of the jack is straight abovethe locating point A.
Raise the vehicle.
Unscrew the bolts and removethe wheel.
Fitting a wheel Position the wheel using the cen- tralising tool to assist you.
Tighten the bolts by hand andremove the centralising tool.
Partly tighten the bolts using thewheelbrace 1.
Fold the jack and 4and remove it.
Fully tighten the bolts using thewheelbrace 1.
Replace the wheel trim*, startingby placing the wheel trim notchopposite the valve, and press iton using the palm of the hand.
Put the tools and the wheel backin the boot.
Note: a diagram on the holder indi-
cates the location of the tools.
Tighten the spare wheel securing strap to prevent noise and for yoursafety in the event of impact.
* According to specification
PRACTICAL INFORMATION
102
For your safety, always change the wheel:
- on level, stable, non-slippery ground,
- with the handbrake on and the ignition switched off,
- with first or reverse gear enga- ged (position Pfor the automatic
gearbox),
- with the vehicle chocked. Never go underneath a vehicle that is supported only by a jack(use a ramp) After changing the wheel:
- have the tightening of the bolts and the tyre pressure checked by a PEUGEOT dealer as soonas possible.
- have the punctured wheel repai- red and refit it to the vehicle assoon as possible.