2002 CHEVROLET TRACKER Owners Manual

5-19
CAUTION: (Continued)
3. If you have a four-wheel-drive vehicle,
be sure the transfer case is in a drive
gear
-- not in NEUTRAL.
4. Turn off the engine.
To be even more certain the vehicle won't move,
you can put blocks at the front and rear of the
tire farthest away from the one being changed.
That would be the tire on the other side of the
vehicle, at the opposite end.
The following steps will tell you how to use the jack and
change a tire.

5-20 Removing the Spare Tire and Tools
The jack, wheel wrench and jack handle are stowed in
the rear left corner of the luggage compartment.
1. To open the jacking tool storage compartment,
turn the knob counterclockwise. Open the cover
two inches and pull the entire cover towards the
front of the vehicle.
2. Turn the jack screw to
remove the jack from
the clamps. If the screw
is too tight, use the jack
handle to loosen it.

5-21
The tools you'll be using include the jack (A), jack
handle (B) and wheel wrench (C).The spare tire is mounted on your tailgate. Your vehicle
may be equipped with either a soft, vinyl cover or a
hard cover.
3. To remove the hard
cover from the spare
tire, insert your key into
the wheel lock and pull
the wheel lock off.
Hard Cover

5-22
4. Using the wheel wrench, remove the wheel cover
nut. Gently pry the spare tire cover off the wheel.
Vinyl Cover
5. If your vehicle is equipped with a vinyl cover, unzip
the cover to find the wheel lock. Insert the key into
the wheel lock and pull it off.
6. Using the wheel wrench, remove the wheel nut under
the lock.

5-23
7. Remove the remaining wheel nuts with the
wheel wrench.
8. Remove the spare tire from the mounting bracket
and place it near your flat tire.
Removing the Flat Tire and Installing the
Spare Tire
1. If your vehicle has wheel nut caps, loosen them by
turning the wheel wrench counterclockwise to find
the wheel nuts.

5-24
2. Using the wheel wrench, loosen all the wheel nuts
but don't remove them yet.
Front Wheel Location
Rear Wheel Location

5-25
3. Under the vehicle near each wheel, there are knobs
in the vehicle's frame. Position the jack and raise
the jack lift head until it fits firmly onto the knobs
nearest to the flat tire.
CAUTION:
Getting under a vehicle when it is jacked up is
dangerous. If the vehicle slips off the jack, you
could be badly injured or killed. Never get under
a vehicle when it is supported only by a jack.
CAUTION:
Raising your vehicle with the jack improperly
positioned can damage the vehicle and even
make the vehicle fall. To help avoid personal
injury and vehicle damage, be sure to fit the jack
lift head into the proper location before raising
the vehicle.
4. Raise the vehicle by turning the jack handle
clockwise. Raise the vehicle far enough off the
ground so there is enough room for the spare
tire to fit underneath the wheel well.

5-26
5. Remove all the wheel
nuts and take off the
flat tire.6. Remove any rust or dirt
from the wheel bolts,
mounting surfaces and
spare wheel.
CAUTION:
Rust or dirt on the wheel, or on the parts to
which it is fastened, can make the wheel nuts
become loose after a time. The wheel could come
off and cause an accident. When you change a
wheel, remove any rust or dirt from the places
where the wheel attaches to the vehicle. In an
emergency, you can use a cloth or a paper towel
to do this; but be sure to use a scraper or wire
brush later, if you need to, to get all the rust or
dirt off.