2002 CADILLAC ESCALADE EXT clock

6-40
7. Remove the vertical pin from the headlamp assembly
by turning the end of the pin away from you until it
unsnaps and then pulling it upward.
8. Remove the headlamp assembly by lifting it up
and then pulling it out and away from the front of
the vehicle.
9. Disconnect the electrical connector from the lower
corner of the headlamp assembly. This will give you
better access to the headlamp assembly.
10. Remove the rubber,
circular
-shaped bulb
cap of the affected bulb
from the headlamp
assembly.
11. Turn the bulb connector counterclockwise and
remove it with the old bulb from the headlamp
assembly.
12. Unplug the electrical connector from the old bulb.
13. Plug in the electrical connector to the new bulb,
using care not to touch the bulb with your hands,
fingers or anything damp or oily.
14. Place the connector with the new bulb into the
headlamp assembly and turn it clockwise until it
is tight.
15. Reinstall the rubber, circular
-shaped bulb cap onto
the headlamp assembly.

6-47
1. Remove the headlamp assembly as described
previously.
2. Remove the rubber, circular
-shaped bulb cap for the
affected bulb from the headlamp assembly.
3. Press the locking release lever, turn the bulb
socket counterclockwise and remove it from the
headlamp assembly. (There is no lock for the
sidemarker lamp.)
4. Remove the old bulb from the bulb socket.
5. Put the new bulb into the bulb socket.
6. Put the bulb socket into the turn signal housing and
turn it clockwise until it locks. (There is no lock for
the sidemarker lamp.)
7. Reinstall the rubber, circular
-shaped bulb cap to the
headlamp assembly.
8. Put the headlamp assembly back into the vehicle by
reversing the previous mentioned steps.
Center High Mounted Stoplamp (CHMSL)
It is recommended that this component be replaced as a
unit by your dealer.
Taillamps
A. Stop Lamp/Tail Lamp
B. Turn Signal Lamp/
Tail Lamp
C. Back
-Up Lamp

6-48
1. Remove the two screws
from the lamp assembly.
2. Remove the lamp assembly.3. Press the release tab and
turn the bulb socket
counterclockwise to
remove it from the
taillamp housing.
4. Pull the bulb straight out from the socket.
5. Press a new bulb into the socket, insert it into the
taillamp housing and turn the socket clockwise into
the taillamp housing until it clicks.
6. Reinstall the rear lamp assembly and tighten
the screws.