2002 CADILLAC ESCALADE EXT Owners Manual

2-71
7. Close both top and bottom mechanisms at the center
of the bag (bag should now be tightly secured).Reinstalling the Cargo Cover Panels
You only need to reinstall as many cargo panels as you wish.
1. Remove the cargo panel(s) from the storage bag.
You can either leave the bag attached to the side of
the cargo area while it is not in use, or you can store
it outside of the vehicle.
2. Starting with cargo panel 1, place the latches in the
open (unlocked) position. Place cargo panel 1 on the
cargo area rails while holding the back of the cargo
panel up.

2-72
Left Side Shown, Right Side Similar
Push the panel forward until it is snug against the
Midgate and then let the back of the panel down
being sure that the alignment pegs align with the
receivers (see arrow).
3. Push both left latches away from you to lock the
latches (remember that there are two latches on each
side for panel 1). You should hear a click when each
latch locks correctly. Lock the remaining two right
latches on panel 1.
For any cargo cover panel you must lock the left
latch in place before you can lock the right latch. If
you do not follow this exactly, the cargo cover panels
may not lock in place correctly.

2-73
4. Install cargo cover 2 next. Place the latches in the
open (unlocked) position. Place the cargo cover
panel on the cargo area rails while holding the back
of the cargo panel up.
Left Side Shown, Right Side Similar
Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the alignment pegs align with the
receivers (see arrow).
5. Push the latches away from you (start with the left
latch) to lock the panel in place. You should hear a
click when each latch locks correctly.
6. Install cargo cover 3 next. Place the latches in the
open (unlocked) position. Place the cargo cover
panel on the cargo area rails while holding the back
of the cargo panel up.

2-74
Left Side Shown, Right Side Similar
Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the alignment pegs align with the
receivers (see arrow).
7. Push the latches away from you (start with the left
latch) to lock the panel in place. You should hear a
click when each latch locks correctly.

2-75
All-Weather Cargo Area
Your vehicle has the ability to operate in many different
configurations (cargo panels on or off, Midgate up or
down, rear glass in or out), allowing the cargo and
passenger area to be open to the environment. To allow
the vehicle to operate in these configurations, it is
equipped with many different features to help it resist
the elements and protect cargo inside the cargo area.
Some of the features that help with this are the
following: top drain grates, side rail channels, catch
cups, Midgate drain, cargo area floor drains and the
rubber cargo mat. These are all part of the water
management system, which is designed to quickly direct
water out of the cargo box.
Even when the water management system is working
properly and the cover system is on, there may be some
instances (heavy rains, automated car washes etc.) when
water may be present in the following areas:
A. Top drain grates
B. Removable front
drain grate (Midgate
drain grate)
C. Side rail channels
and catch cups
D. Front drainsE. Water drainage area
(around both sides
of the cargo box and
tailgate side)
F. Rear Drains
G. Cargo floor
H. Cargo mat (central
area of mat is
intended to be dry)

2-76
Maintenance and Cleaning
To ensure that the water management system performs
properly, be sure that the Midgate, tailgate and cover
system are fully closed and that each element of the
water management system is clean and not blocked with
debris. Follow the instructions given next in this section
for the proper procedures on cleaning each item of the
water management system.
Top Drain Grates
-- Removal and Cleaning
The top drain grates are located near the rear glass on
both sides of the vehicle. You may need to clean the
grates and drains if there seems to be blockage. But first
you will have to remove the drain grates by pulling them
off of the vehicle. To remove each drain grate, do the
following:
1. Start with the cargo panels off. See ªCargo Panel
Coversº in the Index for more information.
2. Grasp the edges of the grate and pull it out from the
vehicle. Flush the drain with clean water.

2-77
To replace the drain grate do the following:
1. Line up the clips on the vehicle with the slots in
the grate.
2. When you are sure that the clips are aligned with the
slots, push the grate down firmly.
The grate should clip into place. Don't force the grate
if it won't clip into place; realign the clips with the holes
and try again.Side Rail Channels
The side rail channels are located on top of both sides of
the cargo area. You may want to flush them out with
clean water if you notice any debris collecting inside
of them.
When loading cargo into the cargo area, be careful not to
damage the rails.

2-78
Midgate Drain Grate Removal and Cleaning
The Midgate drain grate is located near the base of
the Midgate (the Midgate side facing outside). You will
find a removable drain grate covering the drain. After
hauling dirt, wood chips, pebbles etc. you will need
to flush the Midgate drain with water. But first you
will have to remove the drain grate by using the
following steps:
1. Lower the Midgate. See ªMidgateº in the Index for
more information.
2. Pull up on the rear (side opposite the Midgate) of
the drain grate.
3. Tilt the drain grate away from you and pull it
straight out.
Reverse the procedure to reinstall the drain grate.