3
73
3
Starting – Riding – Parking
General
warning
lighte ABS warning
light
l/
brake failure Malfunctions
OFF ON Only RESIDUAL BRAKING FUNCTION
available in both circuits (
b 69)
OFF Flashes at 1 Hz ABS not available Pull-away test not completed (
b 70)
OFF Flashes at 4 Hz Only RESIDUAL BRAKING FUNCTION available in both circuits (
b 69)
Self-diagnosis not completed (b 70)
ON OFF Tail light/brake light defective
(Maintenance Instructions, ( b Chapter 2)
ON Flashes at 1 Hz At least one brake circuit without
ABS (
b 70)
ON Flashes at 4 Hz At least one brake circuit in RESIDUAL BRAKING FUNCTION mode (
b 69)
Alternate
flashing at
1Hz Alternate flash-
ing at 1 Hz
Fluid level in BMW Integral ABS too low.
Check the motorcycle as follows:
– Ignition OFF: is brake pressure OK at
the brake levers?
– Are the brakes acting on both wheels?
– Is the brake system leaktight, no signs of brake fluid escaping?
The brake system is defective if the test
outcome is negative.
Alternate
flashing at 4
Hz Alternate flas-
hing at 4 Hz
Fluid level in the BMW Integral ABS is too
low, perform the checks listed above.
Only RESIDUAL BRAKING FUNCTION
available in at least one circuit (
b 69)
d Warning:
Do not ride the motorcycle if you
have any doubts about the
dependability of the brake system.
BMW Integral ABSOE - Fault table
10r28FUNbkg1.book Seite 73 Dienstag, 24. Januar 2006 9:31 09
