2002.5 Peugeot 307 SW Dag change time

REAR PARKING
ASSISTANCE This system, installed in the rear
bumper, detects any obstacle
(person, vehicle, tree, barrier,kerb ...) situated behind thevehicle. Activation With the engine running, the sys- tem is activated when reverse
gear is engaged. A bleep indi-cates that it is active. The proximity information is pro- vided by an audible signal,consisting of bleeps which beco-me faster as the vehicleapproaches the obstacle. When the distance between the rear of the vehicle and the obs-tacle is less than approximatelytwenty-five centimetres, theaudible signal becomescontinuous. ➜Change to neutral to disarm the system.
11
OPENING THE BONNET Inside the vehicle: Push the
handle on the left side, under the fascia. Outside the vehicle: Lift
the catch, raise the bon- net and secure the strutto keep the bonnet open.
FILLING WITH FUEL This operation must be carried out with the
engine switched off .
The fuel to be used is indicatedon the inside of the flap. The capacity of the tank is approximately 60 litres. On filling, do not continue after
the third cut-off of the pump toavoid any malfunction. Low fuel level From the time this light comes on, the range remaining isapproximately 50 km.YOUR 307 SW AT A GLANCE
108108132
22-07-2002

22-07-2002
YOUR 307 SW IN DETAIL
36
Parameter configuration Monochrome screen B Press button 1for two seconds to
gain access to the settings. Then, each press of this button per- mits scrolling of the various parame-ters.
Ð language of the information dis- played,
Ð speed unit (km or miles),
Ð temperature unit (degrees Celcius or Fahrenheit),
Ð time format (12 or 24 hours),
Ð hour,
Ð minute,
Ð year,
Ð month,
Ð day. Pressing button 2enables you to
change the parameter selected. Continue pressing the button forrapid scrolling. After ten seconds without action, the
screen returns to the usual display,the modified data is recorded.
Ð configuration (see corresponding
section).
Ð map (see section "Satellite naviga- tion system")
A few definitions... Superimposed display: a window appears over the current application for a short while, toannounce a change of status of ano-ther application. Permanent application: main application currently in use,dis-
played in the main screen window. Contextual menu: limited menu associated with the main application currently in use, dis-
played in the main screen window.
Colour screen DT General menu Press the
"MENU"button to access
the general menu and select one of
the following applications: navigation - guidance (see section "Satellite navigation system"),
Ð trip computer (see corresponding section),
Ð directory (see "RT3 audio/telepho- ne" section),
Ð telematics (see "RT3 audio/tele- phone" section),

22-07-2002
YOUR 307 SW IN DETAIL
36
Parameter configuration Monochrome screen B Press button 1for two seconds to
gain access to the settings. Then, each press of this button per- mits scrolling of the various parame-ters.
Ð language of the information dis- played,
Ð speed unit (km or miles),
Ð temperature unit (degrees Celcius or Fahrenheit),
Ð time format (12 or 24 hours),
Ð hour,
Ð minute,
Ð year,
Ð month,
Ð day. Pressing button 2enables you to
change the parameter selected. Continue pressing the button forrapid scrolling. After ten seconds without action, the
screen returns to the usual display,the modified data is recorded.
Ð configuration (see corresponding
section).
Ð map (see section "Satellite naviga- tion system")
A few definitions... Superimposed display: a window appears over the current application for a short while, toannounce a change of status of ano-ther application. Permanent application: main application currently in use,dis-
played in the main screen window. Contextual menu: limited menu associated with the main application currently in use, dis-
played in the main screen window.
Colour screen DT General menu Press the
"MENU"button to access
the general menu and select one of
the following applications: navigation - guidance (see section "Satellite navigation system"),
Ð trip computer (see corresponding section),
Ð directory (see "RT3 audio/telepho- ne" section),
Ð telematics (see "RT3 audio/tele- phone" section),

22-07-2002
GENERAL FUNCTIONSOn/off With the ignition key in the accessories or ignition position, press button Mto switch the set on or off.
The set can operate for 30 minutes without the vehicle ignition being switched on.
Anti-theft systemThe audio system is coded in such a way that it can operate only on your vehicle. It would not function if fitted to another vehicle. The anti-theft system is automatic and requires no action on your part. ADJUSTING THE VOLUME Press button Oto increase the volume, or button Nto decrease it.
Continuous pressure on buttons Oand Nallows a gradual adjustment of the volume.
AUDIO SETTINGS Press button Gseveral times in succession to access the bass (BASS), treble (TREB), loudness (LOUD),
fader ( FAD), balance (BAL)and automatic volume correction.
Exit from audio mode is automatic after a few seconds without pressing any button, or by pressing button G
after configuration of the automatic volume correction. Note : bass and treble settings are specific to each source. It is possible to set them differently for radio,
cassette (RB3), CD (RD3) and CD changer.
YOUR 307 SW IN DETAIL
42

22-07-2002
CD CHANGER Selecting CD changer modeAudio RB3 : press the "SRC"button several times in succession.
Audio RD3 : press button R.
Selecting a disc Press buttons "1"to "5" of the CD changer or the radio to select the corresponding disc.
Selecting a track Press button Ito select the next track.
Press button Jto return to the start of the current track or to select the previous track.
Accelerated playPress and hold button Ior Jfor forwards or backwards accelerated play.
Accelerated play stops as soon as the button is released. Shuffle (RDM) When the CD changer is selected: - audio RB3 : press and hold the "SRC" button for two seconds;
- audio RD3 : press and hold button R for two seconds.
The tracks will be played in random sequence. Pressing the button again for two seconds returns you to normal play.
YOUR 307 SW IN DETAIL
50

22-07-2002
YOUR 307 SW IN DETAIL61
COMPACT DISC CHANGER Selecting the CD changer mode Press the ''SOURCE'' button several times.
Selecting a disc Press press one of the buttons ''1'' to ''5'' on the CD changer or on the audio/telephone to select the appropriate disc.
Buttons Hand Iallow you to select respectively the previous or following disc in the changer.
Selecting a track Press button Mto select the following track.
Press button Nto return to the start of the current track or to select the previous track.
Accelerated playKeep button Mor Nfor forwards or backwards accelerated play.
Accelerated play starts as soon as you release the button. Contextual menu
The contextual menu permits you to switch the shuffle functions on or off, to play the start of a track or to repeat a track.

22-07-2002
YOUR 307 SW IN DETAIL
74
Select the Navigation/Guidance icon using the knob, then validate bypressing the knob to access themain "Navigation - Guidance"
menu.
General menu
Switch on the RT3 audio/telephone and insert the navigation CD ROM. Press the
"MENU"button to access
the general menu .
During guidance, if the navigation CD-ROM is present, the screen displays
different information depending on the manoeuvres to be carried out. 1. Current manoeuvre or compass.
2. Next manoeuvre to be carried out.
3. Next road to be taken.
4. Current road.
5. Estimated time of arrival at destination.
6. Distance to final destination.
7. Distance to next manoeuvre.
Notes:
Ð depending on the situation of the vehicle and on the reception of the GPS infor- mation, this information may disappear from the screen temporarily,
Ð during guidance, it is only possible to listen to a CD if the vehicle is fitted with a CD changer.
General notes on the display
Monochrome screen CT Colour screen DT
12
765
123
7654
4
3

YOUR 307 SW IN DETAIL
78
Select the ''Directory'' function to
access the file in which the address you are looking for is archived. Select a description by scrolling down the list by means of the knob, then
confirm it by pressing the knob. Thedirectory file is then displayed. Select the "OK"function, then press
the knob to access the guidance acti- vation functiont. Follow the directions given by the system.
Selecting a destination stored inthe directory
Select the "Most recent destina-
tions" function to access one of the
last ten addresses stored. Select a description by scrolling down the list by means of the knob,then confirm it by pressing the knob.The complete address is then dis-played. Select the "OK"function, then press
the knob to access the guidance activation function. Follow the instructions given by the system.
Selection of one of the last tendestinations
Activate the function ''Changing the
route'' , then input the distance invol-
ved in the change required Select the ''OK'' function then valida-
te by pressing the knob. The system calculates the change which is closest to the value inputand gives you the option of whetheror not to use this change. Details of the route
You can consult the destination address at any time by activating the"Chosen destination" function.
Changing the initial route
22-07-2002