2001 TOYOTA HIGHLANDER reset

'05 HIGHLANDER_U (L/O 0409)
187
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
1. +-º switch
Push +º to increase the volume. The vol-
ume continues to increase while the
switch is being pushed.
Push - º to decrease the volume. The
volume continues to decrease while the
switch is being pushed.
2. 
º switch
Radio
This switch has the following featuresÐ
To select a preset station:
Quickly push and release the 
º or º
side of the switch. Do this again to select
the next preset station.
To seek a station:
Push and hold the 
º or º side of the
switch until you hear a beep. Do this
again to find the next station. If you push
the switch on either side during the seek
mode, seeking will be cancelled.
To step up or down the frequency, push
and hold the switch even after you hear
a beep. When you release from the
switch, the radio will begin seeking up or
down for a station. Do this again to find
the next station.Cassette player
This switch has the following featuresÐ
To skip to a different track in either direc-
tion:
Quickly push and release the 
º or º
side of the switch. FF 1º or REW 1º will
appear on the display.
Next, push either side of the track switch
until the track you want to listen to is set.
If you push the switch ten times, the skip
function will turn off. (You can skip up to
nine tracks at a time.)
When counting the number of the tracks
you want to rewind, remember to count
the current track as well. For example, if
you want to rewind to a song that is two
tracks before the song you are listening
to, push the º side of the switch three
times.
If you push the track switch further than
you wanted to, push the other side of the
switch. The track number will be in-
creased or reduced.
The track number you select is not valid
if it is higher than the number of the
tracks remaining on the current side of
the cassette.When the tape reaches to the begin-
ning, the player will automatically start
playing that side.
After the tape reaches to the end, the
player will automatically reverse and
start playing the other side.
There must be at least 3 seconds of blank
space between tracks for the track switch
to work correctly. In addition, the feature
may not work well with some spoken, live,
or classical recordings.
To fast forward or reverse:
Push and hold the 
º side of the switch
to fast forward a cassette tape. FFº will
appear on the display. Push and hold the
º side of the switch to rewind a tape.
REWº will appear on the display.
To stop the tape while it is fast forward-
ing, push the 
º side of the switch. To
stop the tape while it is rewinding, push
the º side of the switch.
If a tape rewinds completely, the cassette
player will stop and then play that same
side. If a tape fast forwards completely,
the cassette will play the other side of the
tape using the auto- reverse feature.

'05 HIGHLANDER_U (L/O 0409)
196
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
1. DVDº button
This button turns on the DVD mode.
2. SOURCEº button
This button turns on the rear seat en-
tertainment system and selects the
mode.
3. OFFº button
This button turns off the rear seat en-
tertainment system.
4. Joystick
This joystick selects a control switch,
mode switch on the screen or the
menu for the disc.
5. ENTº button
This button inputs the selected switch
or the selected menu for the disc.
6. DISC/CH/PROGº button
This button skips directly to a desired
preset station, disc, track or chapter.
7. 

º button
This button fast forwards a screen
when the DVD player is operated.
8. RETURNº button
This button skips to the predetermined
scene for the disc when the DVD play-
er is operated.
ÐControl buttons

Controller

'05 HIGHLANDER_U (L/O 0409)
198
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
1. º button
This button ejects a disc.
2. SOURCEº button
This button turns on the rear seat en-
tertainment system and selects the
mode.
3. TUNE/TRACKº button
This button seeks a radio station or
selects track/chapter.
4. DISC/CH/PROGº button
This button skips directly to a desired
preset station, disc, track or chapter.
5. CURSOR (REMOTE)º button
This button indicates the control
switches on the screen when the DVD
player is operated. This button also
can be used when you lose sight of
the controller.
6. Joystick
This joystick selects a control switch,
mode switch on the screen or the
menu for the disc.
Buttons on the DVD player unit

'05 HIGHLANDER_U (L/O 0409)
202
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
When you select a mode, the screen indi-
cates which is selected.
Radio
AM mode:
When you select the AM mode, AMº will
appear on the screen.
FM mode:
When you select the FM mode, FM1º or
FM2º will appear on the screen.
Tape mode
TAPEº appears on the screen while this
mode is selected.
Compact disc mode
CDº appears on the screen while this
mode is selected.
The screen shows the track, or track and
disc number currently being played.
Controller
DVD player unit
OPERATING FRONT AUDIO SYSTEM
To operate the front audio system, use
the following switches.
1. DISC/CH/PROGº button
Radio
You can scan only the preset stations for
the band of the front audio system. (For
instructions, see ÐControls and featuresº
on page 173 in this Section.)
To scan the preset stations:
Push the 
º or º side of the DISC/
CH/PROGº button. The radio will tune in
the next preset station up or down the
band. The station frequency will appear on
the screen.

2005 HIGHLANDER (EWD592U)
155
SRS
NOTICE: When inspecting or repairing the SRS, perform service in accordance with the following precautionary instructions
and the procedure, and precautions in the Repair Manual applicable for the model year.

Malfunction symptoms of the SRS are difficult to confirm, so the DTCs become the most important source of information
when troubleshooting. When troubleshooting the SRS, always inspect the DTCs before disconnecting the battery.

Work must be started more than 90 seconds after the ignition SW is turned to the ºLOCKº position and the
negative (-) terminal cable is disconnected from the battery.
(The SRS is equipped with a back-up power source so that if work is started within 90 seconds from
disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

When the negative (-) terminal cable is disconnected from the battery, the memory of the clock and audio system will be
cleared. So before starting work, make a record of the contents in the audio memory system. When work is finished,
reset the audio systems as they were before and adjust the clock. Some vehicles have power tilt steering, power
telescopic steering, power seat and power outside rear view mirror which are all equipped with memory function.
However, it is not possible to make a record of these memory contents. So when the work is finished, it will be
necessary to explain it to your customer, and ask the customer to adjust the features and reset the memory. To avoid
erasing the memory in each system, never use a back-up power supply from outside the vehicle.

Before repair, remove the airbag sensor if shocks are likely to be applied to the sensor during repair.

Do not expose the following parts directly to hot air or flame;

Even in cases of a minor collision where the SRS does not deploy, the following parts should be inspected;

Never use SRS parts from another vehicle. When replacing parts, replace with new parts.

For the purpose of reuse, never disassemble and repair the following parts.

If the following parts have been dropped, or have cracks, dents and other defects in their case, bracket, and connector,
replace with new one.

Use a volt/ohmmeter with high impedance (10 kW/V minimum) for troubleshooting electrical circuits of the system.

Information labels are attached to the periphery of the SRS components. Follow the instructions of the notice.

After work on the SRS is completed, check the SRS warning light.

If the vehicle is equipped with a mobile communication system, refer to the precaution in the IN section of the Repair
Manual.
*Steering wheel pad
*Front passenger airbag assembly
*Side airbag assembly
*Curtain shield airbag assembly
*Seat belt pretensioner
*Center airbag sensor assembly
*Front airbag sensor assembly
*Side airbag sensor assembly

1 Reset the oil replacement reminder (“MAINT REQD”) light after replacing engine oil, if vehicle is equipped with this light.2 Perform these service items only if you drive primarily under the conditions indicated.3 See page 37 for details.4 Applies to Corolla Matrix 4WD and Sienna 4WD.
Maintenance Log: Cars
15,000 Miles or 18 Months
qReplace engine oil and oil filter1
qRotate tires (except MR2 Spyder)
qClean cabin air filter (Camry)
qTighten drive shaft bolt (Corolla and Corolla Matrix)
qVisually inspect brake linings/drums and brake pads/discs
qInspect the following:__ Ball joints and dust covers
__ Brake lines and hoses
__ Drive shaft boots
__ Engine coolant
3
__ Exhaust pipes and mountings
Note: Driving in heavy traffic, on dirt roads or in urban, dusty or desert areas may shorten
the life of the cabin air filter. Replacement may be needed if you notice reduced air flow
from the air conditioner and heater or if the windows fog easily when you use the "Fresh"
mode. Consult your dealer if any of these conditions occur.
Additional Maintenance Items for Special Operating Conditions2
Driving in desert or on dirt roads:
qInspect engine air filter
qTi ghten nuts and bolts on chassis
Driving while towing:
qReplace rear differential oil4
qR eplace transfer case oil4
qTi gh ten n uts and bolts on chassis
Dealer Service Verification:
Date:
Mileage:
5
__ Rear differential oil4
__ Steering gear box
__ Steering linkage and boots
__ Transfer case oil
4

1 Reset the oil replacement reminder (“MAINT REQD”) light after replacing engine oil, if vehicle is equipped with this light.2 Perform these service items only if you drive primarily under the conditions indicated.3 Required under the terms of the Emission Control Warranty.4 Inspec tthickness measurement and disc runout.5 Ex cept front differential of Corolla Matrix 4WD with manual transmission.6 See page 37 for details.7 Applies t o Coroll a M atrix 4WD and Sienna 4WD.8 Applies to Corolla Matrix 4WD, MR2 Spyder and Sienna 4WD.
Maintenance Log: Cars
30,000 Miles or 36 Months
qReplace engine oil and oil filter1
qRotate tires (except MR2 Spyder)
qReplace cabin air filter (Camry and Camry Solara)
qReplace engine air filter
qReplace spark plugs (ECHO)3
qTighten drive shaft bolt (Corolla and Corolla Matrix)
qInspect the following:__ Ball joints and dust covers
__ Brake lines and hoses
__ Brake linings/drums and brake pads/discs
4
__ Differential oil5
__ Drive shaft boots
__ Engine coolant6
__ Exhaust pipes and mountings
__ Fuel lines and connections, fuel tank band
and fuel tank vapor vent system hoses
Additional Maintenance Items for Special Operating Conditions2
Driving in desert or on dirt roads:
qTighten nuts and bolts on chassis
Driving while towing:
qR epl ac e f ront diff erential oil (all models with manual transmission
e x ce pt Cor oll a M atrix 4WD)
qReplace manual transmission oil
qRepl ac e r ear differential oil8
qRepl ac e t ran sfer case oil7
qTighten nuts and bolts on chassis
Dealer Service Verification:
Date:
M ileage:
7
__ Fuel tank cap gasket
__ Radiator core and condenser
__ Steering gear box
__ Steering linkage and boots
__ Transfer case oil
7
__ Transmission fluid or oil

1 Reset the oil replacement reminder (“MAINT REQD”) light after replacing engine oil, if vehicle is equipped with this light.2 Per for m t hese service items only if you drive primarily under the conditions indicated.3 See p age 37 for details.4 Applies to Corolla Matrix 4WD and Sienna 4WD.
Maintenance Log: Cars
45,000 Miles or 54 Months
qReplace engine oil and oil filter1
qRotate tires (except MR2 Spyder)
qClean cabin air filter (Camry)
qTighten drive shaft bolt (Corolla and Corolla Matrix)
qVisually inspect brake linings/drums and brake pads/discs
qInspect the following:__ Ball joints and dust covers
__ Brake lines and hoses
__ Drive shaft boots
__ E ngine coolant
3
__ Exhaust pipes and mountings
Note: Driving in heavy traffic, on dirt roads or in urban, dusty or desert areas may shorten
t he life of the cabin air filter. Replacement may be needed if you notice reduced air flow
from the air conditioner and heater or if the windows fog easily when you use the "Fresh"
mode. Consult your dealer if any of these conditions occur.
Additional Maintenance Items for Special Operating Conditions2
Driving in desert or on dirt roads:
qInspect engine air filter
qTighten nuts and bolts on chassis
Driving while towing:
qReplace rear differential oil4
qReplace transfer case oil4
qTighten nuts and bolts on chassis
Dealer Service Verification:
Date:
M ileage:
9
__ R ear differential oil4
__ Steering gear box
__ Steering linkage and boots
__ Transfer case oil
4