2001 TOYOTA HIGHLANDER ECU

'05 HIGHLANDER_U (L/O 0409)
23
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
1. Using a coin or equivalent, open the
transmitter case.2. Remove the discharged transmitter bat-
tery by ballpoint pen. Insert the tip of
ballpoint pen at the guide groove and
lift as shown in the above illustration.
NOTICE
Do not bend the terminals.
3. Put in a new transmitter battery with
positive (+) side up.
Close the transmitter case securely.
NOTICE

Make sure the positive side and
negative side of the transmitter bat-
tery are faced correctly.

Do not replace the battery with wet
hands. Water may cause unexpected
rust.

Do not touch or move any compo-
nents inside the transmitter, or it
may interfere with proper operation.

'05 HIGHLANDER_U (L/O 0409)
24
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)

Be careful not to bend the electrode
when inserting the transmitter bat-
tery and that dust or oils do not
adhere to the transmitter case.

Close the transmitter case securely.
After replacing the battery, check that the
transmitter operates properly. If the trans-
mitter still does not operate properly, con-
tact your Toyota dealer.
LOCKING AND UNLOCKING WITH KEY
Insert the key into the keyhole and turn
it.
To lock: Turn the key forward.
To unlock: Turn the key backward.
All the side doors and back door lock and
unlock simultaneously with either front
door. In the driver 's door lock, turning the
key once will unlock the driver's door and
twice in succession will unlock all the side
doors and back door simultaneously.
This double key turning operation to un-
lock all the side doors and back door can
be changed to a single key turning opera-
tion. For details, contact your Toyota deal-
er.When all the side doors and back door
are unlocked simultaneously using a key,
the center interior light, personal lights
and ignition switch light will come on and
remain on for about 15 seconds before
fading out. (For further information, see
Interior lightsº on page 124, Personal
lightsº on page 125 and Ignition switch
lightº on page 126 in Section 1- 5.)
The driver 's window can be opened or
closed with the key operation in the driv-
er 's door keyhole. (For details, see Power
windowsº on page 27 in this Section.)
Side doors

'05 HIGHLANDER_U (L/O 0409)
30
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
LOCKING AND UNLOCKING WITH KEY
Insert the key into the keyhole and turn
it.
To lock: Turn the key clockwise.
To unlock: Turn the key counterclockwise.
To open the back door, pull the lock
release lever.
Operating the power door lock switch or
wireless remote control transmitter simul-
taneously locks or unlocks the back door.
(See ÐLocking and unlocking doorsº on
page 20 and Side doorsº on page 24 in
this Section.)
When closing the back door, make sure
it is fully closed.See ÐStowage precautionsº on page 313
in Section 2 for precautions when loading
luggage.When closing the back door, the inside
strap can be used to make the reach
easier.
To close the back door, lower it and press
down on it. After closing the back door,
try pulling it up to make sure it is secure-
ly closed.
See ÐStowage precautionsº on page 313
in Section 2 for precautions when loading
luggage.
Back door

'05 HIGHLANDER_U (L/O 0409)
31
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
CAUTION
Keep the back door closed while driv-
ing. This not only keeps the luggage
from being thrown out but also pre-
vents exhaust gases from entering
the vehicle.
To open the hood:
1. Pull the hood lock release lever. The
hood will spring up slightly.
CAUTION
Before driving, be sure that the hood
is closed and securely locked. Other-
wise, the hood may open unexpected-
ly while driving and an accident may
occur.
2. In front of the vehicle, pull up the
auxiliary catch lever and lift the
hood.
Hood

'05 HIGHLANDER_U (L/O 0409)
32
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
3. Hold the hood open by inserting the
support rod into the slot.
Before closing the hood, check to see that
you have not forgotten any tools, rags,
etc. and return the support rod to its
clipÐthis prevents rattles. Then lower the
hood and make sure it locks into place.
If necessary, press down gently on the
front edge to lock it.
CAUTION
After inserting the support rod into
the slot, make sure the rod supports
the hood securely from falling down
on to your head or body.
To deter vehicle theft, the system is
designed to sound an alarm if any of
the side doors, back door or hood is
forcibly unlocked or the battery termi-
nal is disconnected and then recon-
nected when the system is set.
The alarm blows the horn intermittently
and flashes the headlights, tail lights and
turn signal lights, and turns on the interior
light.SETTING THE SYSTEM
1. Turn the ignition key to the LOCKº
position and remove it.
The indicator light will start flashing when
the key is removed from the ignition
switch. (See Engine immobilizer systemº
on page 17 in this Section for details.)
2. Have all passengers get out of the
vehicle.
3. Close and lock all the side doors, back
door and hood.
The indicator light will remain on when all
the side doors, back door and hood are
closed and locked.
Theft deterrent system

'05 HIGHLANDER_U (L/O 0409)
35
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
2. To remove the fuel tank cap, turn
the cap counterclockwise by 90 de-
grees (to the pressure point 1), and
then turn it an additional 30 degrees
(to point 2). Pause slightly before
removing it.
It is not unusual to hear a slight swoosh
when the cap is opened.3. The removed cap can be stored on
the back side of the fuel filler door.
Position the cap so that the hooks point
to the left and right, and set it in the
receptacle on the back side of the door.When installing the cap, turn the cap
clockwise until you hear a click. When
you hear the click, the cap is fully
closed.
If the cap is not installed securely, the
malfunction indicator lamp comes on.
Make sure the cap is tightened securely.
The indicator lamp goes off after driving
several times. If the indicator lamp does
not go off, contact your Toyota dealer as
soon as possible.
CAUTION

Make sure the cap is installed se-
curely to prevent fuel spillage in
the event of an accident.

Use only a genuine Toyota fuel tank
cap for replacement. It is designed
to regulate fuel tank pressure.
NOTICE
To prevent damage to the cap, apply
force only in the turning direction to
the cap. Do not pull or pry it.

'05 HIGHLANDER_U (L/O 0409)
44
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)
CAUTION
Avoid reclining the seatback any
more than needed. The seat belts pro-
vide maximum protection in a frontal
or rear collision when the driver and
the front passenger are sitting up
straight and well back in the seats. If
you are reclined, the lap belt may
slide past your hips and apply re-
straint forces directly to the abdomen
or your neck may contact the shoul-
der belt. In the event of a frontal
collision, the more the seat is re-
clined, the greater the risk of death
or personal injury.
3. SEAT LUMBAR SUPPORT
ADJUSTING SWITCH
Press either side of the switch.
The amount of lumber support will change
while the switch is pressed.
CAUTION

Do not adjust the seat while the
vehicle is moving.

Be careful that the seat does not
hit a passenger or luggage.

Be careful not to get your hands or
feet pinched in the seat.

After adjusting the seat position, re-
lease the lever and try sliding the
seat forward and backward to make
sure it is locked in position.

After adjusting the seatback, push
your body back against the seat to
make sure the seat is locked in
position.

When returning the seatback to the
upright position, observe the follow-
ing precautions in order to prevent
personal injury in a collision or
sudden stop:
Make sure the seatback is securely
locked by pushing forward and rear-
ward on the top of the seatback.
Failure to do so will prevent the
seat belt from operating properly.
Make sure the seat belts are not
twisted or caught in the seatback
and are arranged in their proper
position and are ready to use.
Folding down the rear seatbacks will en-
large the luggage compartment. See
ÐStowage precautionsº on page 313 in
Section 2 for precautions when loading
luggage.
Rear seatsÐ
ÐRear seat precautions

'05 HIGHLANDER_U (L/O 0409)
46
2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)

Avoid reclining the seatback any
more than needed. The seat belts
provide maximum protection in a
frontal or rear collision when the
passengers are sitting up straight
and well back in the seats. If you
are reclined, the lap belt may slide
past your hips and apply restraint
forces directly to the abdomen or
your neck may contact the shoulder
belt. In the event of a frontal colli-
sion, the more the seat is reclined,
the greater the risk of death or per-
sonal injury.

After adjusting the seat position, re-
lease the lever and try sliding the
seat forward and backward to make
sure it is locked in position.

After adjusting the seatback, push
your body back against the seat to
make sure the seat is locked in
position.
NOTICE
Do not fold the second seat seatback
forward with the luggage cover hooks
attached.
For easy access to the third seat:
1. Lift the lever on the side of the seat-
back and fold the seatback.
The seat will slide forward.
2. Move the seat to the front- most posi-
tion.
After passengers are in, lift up the seat-
back and return the seat until it locks.
CAUTION
After putting back the seat, try push-
ing the seat forward and rearward to
make sure it is secured in place.
To fold down the second seat after it has
been moved to access the third seat,
push the seatback up slightly and then
pull the seatback adjusting lever before
folding the seatback down. (See ÐFold-
ing down second seatsº described below
for instructions about folding down the
second seat.)
ÐMoving second seat for
third seat access