2001 TOYOTA AVALON washer fluid

Z19562
 O-Ring
* For use with SST  Non-reusable partRack Housing
No. 2 Grommet
Rack HousingRack Boot
Clip
Tie Rod End
Lock Nut
Rack End
Steering Rack Rack Housing
No. 2 Bracket Clamp
 Claw Washer
 Teflon Ring
 Oil Seal
 Wire
 Oil Seal
Molybdenum disulfide lithium base grease
Power steering fluidCylinder End Stopper
Bushing  Claw Washer Rack End
83 (850, 61)
*60 (610, 44)
 Clamp Rack Boot Clip
Lock Nut Tie Rod End
74 (750, 54)
74 (750, 54)
N´m (kgf´cm, ft´lbf) : Specified torque
 O-Ring
83 (850, 61)
*60 (610, 44)
SR-38
- STEERINGPOWER STEERING GEAR
1501 Author
: Date
:
2001 AVALON (RM808U)

F08852
Pressure Port Union

O-Ring
Flow Control Valve
Suction Port Union
SpringRear Housing
Rear
Bracket
Front Housing
Front Bracket
Vane Pump Shaft
Vane Pump PulleyVane Pump
Rotor

Straight Pin
Wave Washer
O-Ring
O-Ring

Gasket
Side Plate
Cam Ring
Vane Platex 10

Oil Seal


Snap Ring

Non-reusable part
Power steering fluid
83 (850, 62)
13 (130, 9)
43 (440, 32)
43 (440, 32)
17 (170, 12)
17 (170, 12)
44 (450, 33)
N´m (kgf´cm, ft´lbf): Specified torque
SR-26
- STEERINGPOWER STEERING VANE PUMP
1489 Author
: Date
:
2001 AVALON (RM808U)

SR0ER-03
R13458
Inscribed Mark
R01149
Round End
R11292
- STEERINGPOWER STEERING VANE PUMP
SR-33
1496 Author
: Date
:
2001 AVALON (RM808U)
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1. COAT PARTS INDICATED BY ARROWS WITH POWER
STEERING FLUID (See page SR-25)
2. INSTALL 2 STRAIGHT PINS
Using a plastic hammer, tap in 2 new straight pins.
NOTICE:
Be careful not to damage the straight pins.
3. INSTALL VANE PUMP SHAFT
4. INSTALL CAM RING
Align the holes of the cam ring and 2 straight pins, and install
the cam ring with the inscribed mark facing outward.
5. INSTALL VANE PUMP ROTOR
(a) Install the vane pump rotor with the inscribed mark facing
outward.
(b) Install a new snap ring to the vane pump shaft.
6. INSTALL 10 VANE PLATES
Install the 10 vane plates with the round end facing outward.
7. INSTALL GASKET
Install a new gasket.
8. INSTALL SIDE PLATE
Align the holes of the side plate and 2 straight pins, and install
the side plate.
9. INSTALL WAVE WASHER
Install the wave washer so that its protrusions fit into the slots
in the side plate.
10. INSTALL REAR HOUSING
(a) Coat 2 new O-rings with power steering fluid and install
them to the rear housing.
(b) Install the rear housing with 4 bolts.
Torque: 17 N´m (170 kgf´cm, 12 ft´lbf)