2001 Peugeot Partner VU engine

Engine oil level indicator (Diesel)
When the ignition is switched on, the maintenance indicator is displayed for several seconds followed by the engine oil level for approximately 10 seconds. Max Min Check using the oil dipstick.
Check with the vehicle on level ground, and the engine off for at least 10 minutes. Lack of oil (flashing of the lines) The oil level must be topped up. If it is not, the engine may be destroyed.
A flashing of the indicator informs you there is an operating fault .
Contact your network dealer.
30I-14INSTRUMENT PANEL*
Multifunction Display
On switching the ignition on, the display shows in turn :
- Maintenance indicator.- Engine oil level indicator (Diesel).
- Total mileage recorder.
- Indication of the time.
* According to model or country

B
1 - The clockcan be set, with the ignition on and the engine not running , by pressing button B for more than three
seconds; the hour will start to flash.
Changing the time 2 - Short press on B, allows the time to be changed slowly.
If the button is not pressed for five seconds : The hour is memorised, the minutes flash. Long press, rapid scrolling
Changing the minutes 3 - Short press on B, allows the time to be changed slowly.
If the button is not pressed for five seconds : The minutes are set. Long press, rapid scrolling
Note : the clock display comes on when the driverÕs door is opened and goes out one minute after it is shut. The
clock display goes off after 10 minutes if the driverÕs door remains open.
32I-14INSTRUMENT PANEL*
Digital clock
* According to model or country

B
Adjust with theengine running and the sidelamps
on by pressing the control B.
- Press the button successively : the level of lighting
of the instrument panel changes progressively.
- Keep the button pressed down : the level of ligh-
ting of the instrument panel changes rapidly
33I-14INSTRUMENT PANEL*
Dashboard lighting
* According to model or country

Rear fog lamp See ÒSIGNALLINGÓ.ABS system See ÒBRAKESÓ.Diesel engine preheating warning lamp
See ÒSTARTING THE ENGINEÓ.
Left direction indicators See ÒSIGNALLINGÓ.
Right direction indicatorsSee ÒSIGNALLINGÓ.
34I-15WARNING LAMPS *
All the direction indicator lights flash at the same time when the hazard warning signal is operated.
Dipped beam See ÒSIGNALLINGÓ. Main beamSee ÒSIGNALLINGÓ.
* According to specification or country

Electronic key warning lamp Lights up when switching
on ignition if the key is not recogni- sed
* Depending on version or country.
35I-15WARNING LAMPS *
Minimum coolant fluid level warning lamp If the warning lamp lights
up, it is imperative to stop the vehicle. Check the level and takethe precautions detailed in chapter
ÒLEVELS AND CHECKSÓ).
Battery charge warninglamp Should not be on when the engine is running. If it
comes permanently on, contact
your nearest approved Dealer.
Imperative stopwarning lamp Lights up at the same time as ano-
ther visual warning or if the maxi-mum permissible coolant fluid tem-perature is reached.
Engine oil pressurewarning lamp If it lights up while you are
driving, stop the engine, check the
level, (See ÒLEVELS ANDCHECKSÓ). If it remains lit despite the level being correct, contact your nearest
approved Dealer. Warning lamp for hand-brake and for brakefluid level Indicates that the brake
is applied or incorrectly released. Also that the brake fluid level is
insufficient. See ÒBRAKESÓ,
ÒLEVELS AND CHECKSÓ . The warning lamp may also indica- te a malfunction of the electronicbraking distribution.
Engine operation war-ning lamp (autodiagno-sis)
If it flashes or lights up, this indi-cates a malfunctioning of either theinjection, ignition or emissioncontrol systems (depending oncountry). Quickly consult your nearest
approved dealer.
AIRBAG operation war-ning lamp
See ÒTHE AIRBAG SYSTEMÓ. Doors open warninglamp Lights up when swit- ching on ignition.
Goes out when all the doors are
closed correctly.

Direction indicators Left: move the stalk downwards. Right: move the stalk upwards.
To signal a change of direction, move the stalk past the point of resistance. The signal will cancel automatically as the steering wheel returns.
36I-16SIGNALLING
Horn Press the end of the stalk. Headlamp flash Flick the stalk gently towards you.
It is possible to flash the headlamps when the engine is switched off. Hazard warning This operates all the direction indicators at the same time.
Use it only in case of danger,for an emergency stop or in exceptional dri-
ving circumstances.
It can also operate when the ignition is off.The direction indicators will not operate if the vehicle is driven with the hazard warning lights on.

3
2
1
0
4
5
6
Front wipers 0Stop
1 Intermittent wipe
2 Normal wipe
3 Rapid wipe
4 Single stroke wipe
Press downwards Front windscreen washPull the stalk towards you. This starts a timed wiping operation. Note : - Position 1: the intermittent wipe
will automatically adjust according to the vehicle speed.
- Positions 1, 2 and 3: when statio-
nary, the wipe speed will automati-cally reduce.
- The engaging of reverse gear, when the front wiper is operating,makes the rear wiper operate. 5 Rear screen wiper For intermittent wipe: twist the ring forwards. 6 Rear screen wash
For screen wash and wipe: turn the ring for-wards.
On release: approximately fourwipes, then it stops. Electric demister* : Electric demister for rear screen or rear view mirrors or both simulta-
neously, according to specifica-
tion. The light indicating operation
switches off automatically afterapproximately 12 minutes to pre-vent excessive power consump-tion. Press once to stop thedemisting function. Press onceagain to restart for 12 minutes. The electric demister will only ope- rate when the engine is running.
* According to specification or country.
39I-17VISIBILITY

1
79V- 11.1 i - 1.4 i ENGINES *
* According to specification.