2001 NISSAN PATROL engine oil

Body Front End
+When removing or installing hood, place a cloth or other padding on front fender panel and cowl top.
This prevents vehicle body from being scratched.
+Bumper fascia is made of plastic. Do not use excessive force and be sure to keep oil away from it.
+Hood adjustment: Adjust at hinge portion.
+Hood lock adjustment: After adjusting, check hood lock control operation. Apply a coat of grease to hood
locks engaging mechanism.
+Hood opener: Do not attempt to bend cable forcibly. Doing so increases effort required to unlock hood.
REMOVAL Ð Front bumper assembly
V1Remove front guard bar. Refer to ªEXTERIORº for details, BT-2005.
V2Remove left and right headlamp wipers (on models with headlamp wipers).
V3Remove clips securing front grille and remove the front grille.
V4Remove screws and bolts securing left and right front bumper side bracket.
V5Remove bolts securing bumper lower to engine under cover.
V6Remove bolts securing left and right front bumper stay upper (without winch).
V7Remove bolts securing left and right front bumper stay side.
V8Extract bumper assembly.
SBT243A
BODY END
BT-2003

Bulb Replacement
The headlamp is a semi-sealed beam type which uses a replace-
able halogen bulb. The bulb can be replaced from the engine
compartment side without removing the headlamp body.
+Grasp only the plastic base when handling the bulb.
Never touch the glass envelope.
1. Disconnect the battery cable.
2. Turn the bulb retaining ring counterclockwise until it is free
from the headlamp reflector, and then remove it.
3. Disconnect the harness connector from the back side of the
bulb.
4. Remove the headlamp bulb carefully. Do not shake or rotate
the bulb when removing it.
5. Install in the reverse order of removal.
CAUTION:
Do not leave headlamp reflector without bulb for a long
period of time. Dust, moisture, smoke, etc. entering head-
lamp body may affect the performance of the headlamp.
Remove headlamp bulb from the headlamp reflector just
before a replacement bulb is installed.
Aiming Adjustment
When performing headlamp aiming adjustment, use an aiming
machine, aiming wall screen or headlamp tester. Aimers should
be in good repair, calibrated and operated in accordance with
respective operation manuals.
If any aimer is not available, aiming adjustment can be done as
follows:
For details, refer to the regulations in your own country.
a. Keep all tires inflated to correct pressures.
b. Place vehicle and tester on one and same flat surface.
c. See that there is no-load in vehicle (coolant, engine oil
filled up to correct level and full fuel tank) other than the
driver (or equivalent weight placed in driver's position).
CAUTION:
Be sure aiming switch is set to ª0º when performing aiming
adjustment on vehicles equipped with headlamp aiming
control.
SEL995K
SEL466V
HEADLAMP/WAGON AND HARDTOP MODELS Ð Conventional Type Ð
EL-2035

Wiring Diagram Codes (Cell Codes)
Use the chart below to find out what each wiring diagram code
stands for.
Refer to the wiring diagram code in the alphabetical index to find
the location (Page number) of each wiring diagram.
Code Section Wiring Diagram Name
A/C, A HA Auto Air Conditioner
A/C, M HA Manual Air Conditioner
A/CCUT EC Air Conditioner Control
A/T AT A/T
AAC/V EC IACV-AAC Valve
ABS BR Anti-lock Brake System
ACC/SW EC Accelerator Switch (F/C)
APS EC Accelerator Position Sensor
ASCD EL Automatic Speed Control Device
AT/C EC A/T Control
AUDIO EL Audio
BACK/L EL Back-up Lamp
BCDD EC BCDD System
BOOST EC Turbo Charger Boost Sensor
BRK/SW EC Brake Switch Signal
CD/CHG EL CD Auto Changer
CHARGE EL Charging System
CHIME EL Warning Chime
CHOKE EC Automatic Choke
CIGAR EL Cigarette Lighter
CMPS EC Camshaft Position Sensor
COMPAS EL Compass and Thermometer
COOL/B HA Cool Box
COOL/F EC Cooling Fan Control
CORNER EL Cornering Lamp
D/LOCK EL Power Door Lock
DEICER EL Wiper Deicer
DEF EL Rear Window Defogger
DIFF/L PD Differential Lock Control System
DTRL ELHeadlamp Ð With Daytime Light
System
ECMRLY EC ECM Relay
ECTS EC Engine Coolant Temperature Sensor
EGVC/V EC EGR Volume Control Valve
EPS STElectric Controlled Power Steering
system
F/FOG EL Front Fog Lamp
F/PUMP EC Fuel Pump
FCUT EC Fuel Cut SystemCode Section Wiring Diagram Name
FICD EC IACV-FICD Solenoid Valve
FPCM EC Fuel Pump Control Module
GLOW EC Quick Glow System
H/AIM EL Headlamp Aiming Control System
H/LAMP EL Headlamp
HEATUP EC Heat up Switch
HLC EL Headlamp Cleaner
HORN EL Horn
IGN EC Ignition System
IGNSYS EC Ignition Signal
ILL EL Illumination
INJECT EC Injector
INJPMP ECElectronic Control Fuel Injection
Pump
INT/V ECIntake Air Control Valve Control
Solenoid Valve
IVC ECIntake Valve Timing Control Solenoid
Valve
KS EC Knock Sensor
LOAD EC Load Signal
MAFS EC Mass Air Flow Sensor
MAIN ECMain Power Supply and Ground Cir-
cuit
METER ELSpeedometer, Tachometer, Temp.,
Oil and Fuel Gauges
MIL/DL EC Mil and Data Link Connectors
MIRROR EL Door Mirror
MULTI EL Multi-remote Control System
NATS EL Nissan Anti-Theft System
P/ANT EL Power Antenna
PGC/V ECEVAP Canister Purge Volume Con-
trol Solenoid Valve
PNP/SW EC Park/Neutral Position Switch
POWER EL Power Supply Routing
PST/SW EC Power Steering Oil Pressure Switch
R/COOL HA Rear Cooler System
R/FOG EL Rear Fog Lamp
R/HEAT HA Rear Heater System
REMOTE EL Audio (Remote Control Switch)
ROOM/L EL Interior Room Lamp
WIRING DIAGRAM CODES (CELL CODES)
EL-2132

L
License lamp ......................................... EL-2041
Location of electrical units ..................... EL-2103
Lubricants ............................................. MA-2002
M
MAFS - Wiring diagram ........................ EC-2006
MAIN - Wiring diagram ......................... EC-2004
METER - Wiring diagram ...................... EL-2064
MIRROR - Wiring diagram .................... EL-2098
Maintenance (engine) ........................... MA-2003
Mass air flow sensor (MAFS) ............... EC-2006
Meter ...................................................... EL-2062
Model variation ....................................... GI-2002
N
NATS (Nissan Anti-theft System) .......... EL-2100
NATS - Wiring diagram ......................... EL-2100
O
Oil change (capacity) ............................ MA-2002
Operating cylinder (clutch) .................... CL-2003
P
PNP/SW - Wiring diagram .................... EC-2034
POWER - Wiring diagram ..................... EL-2005
Park/Neutral position switch ................. EC-2034
Parking lamp .......................................... EL-2041
Power door mirror .................................. EL-2098
Power supply routing ................... EL-2004, 2005
Pressure plate - See Clutch cover ........ CL-2005
R
R/HEAT - Wiring diagram ..................... HA-2003
Radio - See Audio ................................. EL-2088
Rear washer .......................................... EL-2078
Rear wiper ............................................. EL-2078
S
SHIFT - Wiring diagram ........................ AT-2013
SRS - See Supplemental Restraint
System .............................................. RS-2003
STAB - Wiring diagram ......................... RA-2002
SWL/V - Wiring diagram ....................... EC-2036
Seal - See Exterior ................................ BT-2006
Seat belt pre-tensioner disposal ........... RS-2009Seat belt pre-tensioner ......................... RS-2003
Shift schedule ........................................ AT-2014
Side air bag ........................................... RS-2003
Speedometer ......................................... EL-2062
Spiral cable ........................................... RS-2006
Stabilizer release device - Wiring
diagram ............................................. RA-2002
Stabilizer release device ....................... RA-2002
Start signal ............................................ EC-2033
Starter .................................................... EL-2032
Starting system ...................................... EL-2029
Supplemental Restraint System ........... RS-2003
Supplemental restraint system - Wiring
diagram ................................... RS-2020, 2021
Swirl control valve control solenoid
valve .................................................. EC-2036
T
TAIL/L - Wiring diagram ........................ EL-2041
TCM circuit diagram .............................. AT-2002
TURN - Wiring diagram ......................... EL-2050
Tachometer ............................................ EL-2062
Tail lamp ................................................ EL-2041
Thermostat ............................................ LC-2003
Turn signal lamp .................................... EL-2050
V
VSS - Wiring diagram ........................... EC-2008
Vehicle identification number ....... GI-2002, 2003
Vehicle speed sensor (VSS) ................. EC-2008
W
WARN - Wiring diagram ........................ EL-2069
WIP/R - Wiring diagram ........................ EL-2079
Warning lamps ....................................... EL-2067
Washer, rear .......................................... EL-2078
Water temperature gauge ..................... EL-2062
Wiper deicer .......................................... EL-2086
Wiper, rear ............................................. EL-2078
ALPHABETICAL INDEX
IDX-2003

Fluids and Lubricants
Capacity (Approximate)
Recommended Fluids/Lubricants
LiterImp mea-
sure
Engine oil (Refill)
Diesel engine: API CF4 or ACEA
B3-96.98 or ACEA B3/E3-
96.98*4 With oil filter ZD30DDTi 8.2 7-1/4 qt
Without oil filter ZD30DDTi 7.7 6-3/4 qt
Cooling system (with reservoir tank)
+Genuine Nissan Anti-freeze Coolant
(L2N) or equivalent*5 With front heater
ZD30DDTiRHD 13.0 11-1/2 qt
LHD 13.2 11-5/8 qt
Without front
heaterZD30DDTi 12.0 10-5/8 qt
With rear heater
ZD30DDTiRHD 14.1 12-3/8 qt
LHD 14.3 12-5/8 qt
Manual transmission oil
FS5R50B 3.5 6-1/8 qt API GL-4, Viscosity SAE 75W-90 only
Differential carrier gear oil (without limited slip differential)
Without diff. lock 2.4 4-1/4 qt
API GL-5*1
With diff. lock 3.0 5-1/4 qt
Transfer fluid
Genuine Nissan ATF or equivalent*3 or
API GL-4*1
TX12A 1.9 1-5/8 qt
Automatic transmission fluid
RE4R03A 11.8 10-3/8 qt Genuine Nissan ATF or equivalent*3
Power steering fluid Refill to the proper oil level
according to the instructions
in the ªDo-it-yourself opera-
tionsº section of the owner's
manual.Type DEXRON
TMIII or equivalent
Brake and clutch fluid
DOT3orDOT4*6
Multi-purpose grease Ð Ð NLGI No. 2 (Lithium soap base)
Propeller shaft greaseNLGI No. 2 (Molybdenum disulphide
lithium soap base)
Air conditioning system refrigerant Ð Ð HFC-134a (R-134a)
Air conditioning system lubricants
ÐÐNissan A/C System Oil Type S or
exact equivalent
*1: For further details, see ªSAE viscosity numberº.
*2: For more information regarding suitable fluids, contact a Nissan dealer for correct brands of DEXRON
TMIII/MERCONTMAutomatic Transmission Fluid.
*3: Never use API CG-4.
*4: Use Genuine Nissan Anti-freeze Coolant (L2N) or equivalent in its quality, in order to avoid possible aluminum corrosion within the engine cooling
system caused by the use of non-genuine engine coolant.
Note that any repairs for the incidents within the engine cooling system while using non-genuine engine coolant may not be covered by
the warranty even if such incidents occurred during the warranty period.
*5: Never mix DOT 3 & DOT 4.
RECOMMENDED FLUIDS AND LUBRICANTS
MA-2002