2001 LAND ROVER FREELANDER light

LIGHTING
REPAIRS 86-2-5
Lamp assembly - flasher side repeater -
front
$% 86.40.53
Remove
1.Push lamp towards rear of vehicle to release
spring clip, and release lamp from wing.
2.Disconnect multiplug.
Refit
1.Connect multiplug to lamp and secure lamp to
wing.
Lamp assembly - tail
$% 86.40.70
Remove
1.Remove 2 Torx screws securing tail lamp to
bumper. Illustrations show up to 04MY.
2.Release lamp, disconnect multiplug and
remove lamp.
NOTE: Do not carry out further dismantling if
component is removed for access only.
3.Remove multiplug and bulb holders from tail
lamp.
Refit
1.Fit multiplug and bulb holders to replacement
tail lamp.
2.Position tail lamp, connect multiplug and
secure to bumper with Torx screws.

LIGHTING
86-2-6 REPAIRS
Lamp assembly - number plate
$% 86.40.86
Remove
1.Remove 2 screws securing lamp to tail door
handle.
2.Disconnect 2 Lucars from number plate lamp.
Refit
1.Position number plate lamp and connect
Lucars.
2.Fit number plate lamp and secure with screws.
Lamp assembly - fog/driving - from 04MY
$% 86.40.96
Remove
1.Release and remove fog/driving lamp finisher
from bumper.
2.Remove 3 screws securing fog/driving lamp to
bumper.
3.Release fog/driving lamp from bumper,
disconnect multiplug and remove lamp.
Refit
1.Position fog/driving lamp to bumper and
connect multiplug.
2.Fit fog/driving lamp to bumper and secure lamp
with screws.
3.Fit fog/driving lamp finishers to bumper.

LIGHTING
REPAIRS 86-2-7
Lamp assembly - rear
$% 86.41.15
Remove
1.Remove 3 Torx screws securing lamp to body.
2.Release lamp, disconnect 2 bulb holders and
remove lamp.
3.Remove lamp sealing rubber.
Refit
1.Fit sealing rubber and bulb holders to lamp.
2.Position lamp, fit and tighten Torx screws.
Lamp assembly - centre high mounted
stop (CHMSL)
$% 86.41.32
Remove
1.Remove 3 screws securing CHMSL bracket to
spare wheel carrier.
2.Release lamp bracket and disconnect
multiplug.
3.Remove lamp and bracket.
4.Remove 2 nuts and remove lamp from bracket.
Refit
1.Position lamp to bracket and tighten nuts.
2.Position lamp bracket and connect multiplug to
lamp.
3.Position lamp bracket to spare wheel carrier
and secure with screws.

LIGHTING
86-2-8 REPAIRS
Lamp assembly - glove compartment
$% 86.45.08
Remove
1.Open glove box.
2.Release illumination lamp from glove box.
3.Disconnect 2 Lucars and remove glove box
lamp.
Refit
1.Position lamp and connect Lucars.
2.Fit lamp and close glove box.
Lamp assembly - load space
$% 86.45.16
Remove
1.Release load space lamp from trim casing.
2.Disconnect 2 Lucars and remove load space
lamp.
Refit
1.Position lamp and connect Lucars.
2.Fit load space lamp to trim casing.

LIGHTING
REPAIRS 86-2-9
Switch - headlamp levelling
$% 86.65.16
Remove
1.Release headlamp levelling switch from fascia
and disconnect multiplug.
Refit
1.Position switch, connect multiplug and secure
switch to fascia.
Switch - glove compartment
$% 86.65.24
Remove
1.Remove glove box.

+ INTERIOR TRIM COMPONENTS,
REPAIRS, Glove box.
2.Disconnect 2 Lucars from glove box lamp
switch.
3.Release clips and remove switch from glove
box latch.
Refit
1.Fit switch to glove box latch and connect
Lucars.
2.Fit glove box.

+ INTERIOR TRIM COMPONENTS,
REPAIRS, Glove box.

LIGHTING
86-2-10 REPAIRS
Switch - hazard warning
$% 86.65.50
Remove
1.Remove radio.

+ IN CAR ENTERTAINMENT,
REPAIRS, Radio - up to 04MY.
2.Remove selector knobs from heater controls.
3.Remove 2 screws securing heater control
finisher to heater controls and remove finisher.
4.Release hazard warning switch from heater
controls.
5.Disconnect multiplug and remove hazard
warning switch.
Refit
1.Position hazard warning switch and connect
multiplug.
2.Fit hazard warning switch to heater controls.
3.Fit heater control finisher to heater controls and
secure with screws.
4.Fit heater control knobs.
5.Fit radio.

+ IN CAR ENTERTAINMENT,
REPAIRS, Radio - up to 04MY.
Switch - combined direction indicator/
headlight/horn
$% 86.65.55
Remove
1.Remove steering column nacelle.

+ STEERING, REPAIRS, Nacelle -
column.
2.Disconnect 2 multiplugs from indicator and light
switch.
3.Rotate steering wheel to access switch screws.
4.Remove 2 screws securing switch.
5.Depress retaining tag and remove switch.
Refit
1.Fit indicator and light switch and secure with
screws.
2.Connect multiplugs to switch.
3.Fit steering column nacelle.

+ STEERING, REPAIRS, Nacelle -
column.

LIGHTING
REPAIRS 86-2-11
Switch - rear fog lamp
$% 86.65.65
Remove
1.Remove instrument cowl.

+ INSTRUMENTS, REPAIRS, Cowl -
instrument - up to 04MY.
2.Remove rear fog lamp switch from instrument
cowl.
Refit
1.Fit switch to instrument cowl.
2.Fit instrument cowl.

+ INSTRUMENTS, REPAIRS, Cowl -
instrument - up to 04MY.

WINDOWS
86-5-6 REPAIRS
Switch - backlight heater
$% 86.65.36
Remove
1.Remove radio.

+ IN CAR ENTERTAINMENT,
REPAIRS, Radio - up to 04MY.
2.Remove selector knobs from heater controls.
3.Remove 2 screws securing heater control
finisher to heater controls and remove finisher.
4.Release heated rear screen switch from heater
controls.
5.Disconnect multiplug from heated rear screen
switch and remove switch.Refit
1.Position heated rear screen switch and connect
multiplug.
2.Fit switch to heater control panel.
3.Fit heater control finisher to heater controls and
secure with screws.
4.Fit heater control knobs.
5.Fit radio.
+ IN CAR ENTERTAINMENT,
REPAIRS, Radio - up to 04MY.