2001 BMW 5 SERIES Basic handsfree retrokit for updating various mobile phones Instalation Instruction Manual

EN/25Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
10. To install the basic wiring harness A and power supply wiring harness B in E39/2 cars
0Carefully cut open the sheathing of the audio
wiring harness (20) for a length of 100 mm behind
the black plug connector X322.
Connect branch B2, open cable end, grey/red
cable, to the supply cable, grey/red cable, of the
black 12-pin plug connector X322 PIN5 using a
2-way insulation-piercing connector (1).
0Lay branch B3 and branch B4 on the power supply
wiring harness B along the standard wiring
harness (20) to the tied back black 2-pin plug
connector X325 above the power distributor in the
boot on the right.
Secure the power supply wiring harness B to the
standard wiring harness (20) using cable ties (3).
0Connect branch B3, black 2-pin socket casing
on the power supply wiring harness B to the black
2-pin plug casing X325S.
Connect branch B4, black 2-pin plug casing on
the power supply wiring harness B to the black
2-pin socket casing X325B.
0Tie back plug connectors X325S+B3 and
X325B+B4 on the standard wiring harness (20)
with cable ties.
When securing the connections, make sure
that the cable harnesses will not be damaged
during the subsequent assembly of the
car.
"
X3221
20
B2
120
F 39 1001 B
oooooooooooooooooo
B
320
20
B
B4B3
X325
F 39 1002 B
B
X325S
B4
B3
X325B
F 39 1003 B
20
X325S
B4 B3
X325B
F 39 1004 B

EN/26Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
10. To install the basic wiring harness A and power supply wiring harness B in E39/2 cars
0
The figure shows the boot on the left."
Secure branch A11, cable eyelet with a diameter
of 6 mm, brown cable, to earth post X13016 under
the left tail light.
0
In cars without an on-board monitor radio,
insulate and tie back branches A9, A10 and
A15.
"
Lay branch A9, black 12-pin plug casing, branch
A10, socket contact, white/brown cable, and
branch A15, socket contact, white/green cable, on
the basic wiring harness A to the installation site of
the on-board monitor radio.
0Cars with an on-board monitor radio only
Disconnect the black 12-pin plug casing X13598
from the radio connection plug (20) and tie it back.
Connect branch A9, black 12-pin plug casing, into
the cleared slot (21) in the on-board monitor radio
connection plug (20).
If the car does not have a black 12-pin plug
casing X13598, branch A9 must be
connected direct.
"
0
This step only applies to cars without an
existing mute cable on the on-board
monitor radio connection plug (20) PIN10
of the 8-pin plug casing X18126.3
Connect branch A10, socket contact, white/brown
cable, to the free slot in the on-board monitor radio
connection plug (20) PIN10 on the 8-pin plug
casing X18126.
X13016A11
F 39 1005 B
A9+A10+A15
F 39 1044 B
A
X13598
20
20
A9
21
F 39 1009 B
F 39 1010 B
20 A10X18126/PIN10
20

EN/27Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
10. To install the basic wiring harness A and power supply wiring harness B in E39/2 cars
0
This step only applies to cars with an
existing mute cable on the on-board
monitor radio connection plug (20) PIN10 of the
8-pin plug casing X18126.3
Carefully cut open the sheathing of the audio
wiring harness (21) for a length of 100 mm behind
the on-board monitor radio connection plug (20).
Cut off the basic wiring harness A near branch
A10.
Connect branch A10, socket contact, white/brown
cable, to the supply cable of the on-board monitor
radio connection plug (20) PIN10, white/brown
cable, on the 8-pin plug casing X18126 using a
2-way insulation-piercing connector (1).
0Cars with an on-board monitor radio only
This step only applies to cars without an
existing TEL ON cable on the on-board
monitor radio connection plug (20) PIN11
of the 8-pin plug casing X18126.
"
Connect branch A15, socket contact, white/green
cable, to the free slot in the on-board monitor radio
connection plug (20) PIN11 on the 8-pin plug
casing X18126.
0
This step only applies to cars with an
existing TEL ON cable on the one-board
monitor radio connection plug (20) PIN11
of the 8-pin plug casing X18126.3
Cut off the basic wiring harness A near branch
A15.
Connect branch A15, socket contact, white/green
cable, to the supply cable of the on-board monitor
radio connection plug (20) PIN11, white/green
cable, on the 8-pin plug casing X18126 using a
2-way insulation-piercing connector (1).
20
F 39 1011 B
A10
211
20 X18126
039 0005 B
20 A15 X18126/PIN11
20
20
039 0006 B
A15
211
20 X18126

EN/28Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
10. To install the basic wiring harness A and power supply wiring harness B in E39/2 cars
0Applies to all E39/2 cars
Insert the 5A fuse (2) into the fuse holder A8.
Secure the fuse holder A8 to the wiring harness
near the left tail light with a cable tie (3).
0
5A2
A8
3
F 39 1006 B

EN/29Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
11. Concluding work
Do not assemble the car again until the required hands-free retrofit kit has been installed (see
separate installation instructions).

EN/30Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
12. Circuit diagram for the basic wiring harness A in E39 cars
A5*
130
3TELE ON
231
SCHIRM 0.35
SW
0.35
5AF1*
12RT
1.0
X13016
BR
1.0
A7*1ANTA1*1ANT
SCHIRM
0.5
WS 0.5
A13*
X322S
11TELE
3TACHO A
2R
9NF+
10NF-
4I BUS
8TELM
130
558g
X322B
A12*
11TELE
3TACHO A
2R
9NF+
10NF-
4I BUS
8TELM
130
558gGRRT 0.75
RTGN
2.5
VIWS
1.5
WSGN 0.5
SWBR
1.0
SWWS
1.0
WSBR
0.75
WSRT
GE 0.75
SWWS 0.75
13MIK-
4MIK+
3
8 R
5TELNF+
TELNF-
231
18MUTE
1030
1558g
1731
1430
11TELE ON
SWWS 0.35
SWBR
0.35
SWWS
0.35
SWBR
0.35
WSBR
0.35
GRRT
0.35
RT
0.35
VIWS
0.35
X18507N9X18126 X13598
X13598
1MIK+
2MIK-
TELNF+
TELNF-
TELNF+
TELNF-
MUTE
X001*
10MUTE
GRRT 0.75
SWWS 0.35
SWBR
0.35
WSBR 0.35
WSBR
0.35
WSGN 0.35
RTGN
2.5
VIWS 1.5
RTGN
2.5
BR 1.0BR
0.35
BR
0.35
BR
0.5
RT
0.5
RT
0.35
A4* X002*
F 39 0970 B
10
TEL ONWSGN 0.3511
6
612
12
1)1) 2)
X003*
10WSGN 0.35TEL ON

EN/31Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
12. Circuit diagram for the basic wiring harness A in E39 cars
Legend
F1*Floating fuse holder near the left tail light
X001*Socket contact
X002*Black 18-pin plug casing
X003*Socket contact
A1*Console aerial connector
A4*Black 18-pin socket casing
A5*Black 3-pin socket casing; cable compensator
A7*Boot aerial connector
A12*White 12-pin plug casing
A13*White 12-pin socket casing
N9Radio
X13016Cable eyelet, 6 mm in diameter; earth
X13598Black 12-pin plug casing
X181268-pin plug casing
X18507Black 3-pin connection plug; microphone
1)To standard wiring harness
2)To hands-free system wiring harness
The components and X designations marked with an asterisk (*) are only valid for this circuit
diagram.
All the other components and X designations correspond to BMW after-sales circuit diagrams
Colour abbreviations
BL = Blue OR = Orange
BR = Brown OR = Orange
GE = Yellow SW = Black
GN = Green VI = Violet
GR = Grey WS = White

EN/32Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544 Issue date: 04.2001
13. Circuit diagram for the basic wiring harness A in E39/2 cars
A5*
130
3TELE ON
231
SCHIRM 0.35
SW
0.35
5AF1*
12RT
1.0
X13016
BR
1.0
A7*1ANTA1*1ANT
SCHIRM
0.5
WS 0.5
A13*
11TELE
3TACHO A
2R
9NF+
10NF-
4I BUS
8TELM
130
558g
B1*
A12*
11TELE
3TACHO A
2R
9NF+
10NF-
4I BUS
8TELM
130
558gGRRT 0.75
RTGN
2.5
VIWS
1.5
WSGN 0.5
SWBR
1.0
SWWS
1.0
WSBR
0.75
WSRT
GE 0.75
SWWS 0.75
13MIK-
4MIK+
3
8 R
5TELNF+
TELNF-
231
18MUTE
1030
1558g
1731
1430
11TELE ON
SWWS 0.35
SWBR
0.35
SWWS
0.35
SWBR
0.35
WSBR
0.35
GRRT
0.35
RT
0.35
VIWS
0.35
X18507 3)N9X18126 X13598
X13598
1MIK+
2MIK-
TELNF+
TELNF-
TELNF+
TELNF-
MUTE
X001*
10MUTE
GRRT 0.75
SWWS 0.35
SWBR
0.35
WSBR 0.35
WSBR
0.35
WSGN 0.35
RTGN
2.5
VIWS 1.5
RTGN
2.5
BR 1.0BR
0.35
BR
0.35
BR
0.5
RT
0.5
RT
0.35
A4* X002*
F 39 1045 B
10
6
612
12
1) 2)
TEL ONWSGN 0.3511
X003*
10WSGN
0.35TEL ON