2001 Acura RL headlights

Mirrors

Keep the inside and outside mirrors
clean and adjusted for best visibility.
Be sure to adjust the mirrors before
you start driving.
The inside mirror has an automaticanti-glare mechanism. When the
AUTO switch is pushed in, the indicator will light. When the mirrorsenses light from the headlights of
the car behind you, the mirror surface will automatically darken to
reduce the glare. Adjusting the Power Mirrors
Adjust the outside mirrors with the adjustment button on the driver's
door armrest:
1. Turn the ignition switch ON (II).
2. Move the selector switch to L (driver's side) or R (passenger's

side).

CONTINUED

Instruments and Controls

INDICATOR
SENSOR
AUTO SWITCH SELECTOR SWITCH

Power Windows, Moonroof

The master control panel also con- tains these extra features:
AUTO — To open the driver's window fully, push the windowswitch firmly down and release it.
The window automatically goes all the way down. To stop the window
from going all the way down, pull back on the window switch briefly.
To open the driver's window only partially, push the window switchdown lightly and hold it. The window
will stop as soon as you release the
switch.

The AUTO function only works to lower the driver's window. To raise
the window, you must pull back on
the window switch and hold it until the window reaches the desired

position.
The MAIN switch controls power to
the passengers'windows. With thisswitch off, the passengers'windows
cannot be raised or lowered. The
MAIN switch does not affect the driv-
er's window. Keep the MAIN switch
off when you have children in the car
so they do not injure themselves by
operating the windows unintentional-
ly. The lights inside the switches
come on when you turn the parking
lights or headlights on.
The power window system has a key- off delay function. The windows willstill operate for up to ten minutes
after you turn off the ignition.
Opening either front door cancels
the delay function. You must turn
the ignition switch ON (II) again
before you can raise or lower the
windows. Moonroof
There are two switches on the ceiling near the front ceiling light.
The ignition switch must be ON (II).
To open the moonroof, pull the OPEN/CLOSE switch backward and
hold it until the moonroof reaches
the desired position.

CONTINUED

Instruments and Controls
OPEN/CLOSE
SWITCH

Ceiling Lights

Both front and rear ceiling lights contain a main light as well as twospotlights.
The front ceiling light has a three- position switch. With the switch in
the OFF position (far left), the main
lights do not come on. In the center
position, the main lights come on
when you open any door. After all doors are closed tightly, they dim
slightly then fade out in about 10
seconds. In the ON position (far right), the main lights stay on
continuously.
Turn on the spotlights in the front and rear ceiling lights by pushing the
grey button next to each light. Push
the button again to turn it off. You
can use the front spotlights at all
times. The rear spotlights only light
when the parking lights or head-
lights are on.
On cars with automatic lighting

With the light switch in the AUTO
position, you can use the rearspotlights only when the headlights
turn on automatically.
Instruments and Controls
OFF
ON
FRONT

REAR

Security System

The security system helps to protect your car and valuables from theft.
The horn sounds and a combination of headlights, parking lights, side
marker lights and taillights flashes if someone attempts to break into your
car or remove the radio. This alarm
continues for two minutes, then the system resets. To reset an alarming
system before the two minutes have
elapsed, unlock either front door
with the key or the remote
transmitter.
The security system sets auto- matically fifteen seconds after you
lock the doors, hood, and trunk. For
the system to activate, you must lock
the doors from the outside with the
key, lock tab, door lock switch, or
remote transmitter. The security system light next to the driver's door
lock starts blinking immediately to show you the system is setting itself. Once the security system is set,
opening any door (without using the
key or the remote transmitter), or
the hood, will cause it to alarm. It also alarms if the radio is removed
from the dashboard or the wiring is

cut.
With the system set, you can still
open the trunk with the master key
or the remote transmitter without
triggering the alarm. The alarm will sound if the trunk lock is forced, or
the trunk is opened with the trunk
release button on the driver's door.
The security system will not set if the hood, trunk, or any door is not
fully closed. If the system will not set,check the Door and Brake Lamp
Monitor on the instrument panel (see page 57), to see if the doors
and trunk are fully closed. Since it is not part of the monitor display,
manually check the hood.
Do not attempt to alter this system
or add other devices to it.

Comfort and Convenience Features

SECURITY SYSTEM LIGHT

Driving in Bad Weather

Visibility — Being able to see clearly in all directions and being
visible to other drivers are important in all weather conditions. This is
more difficult in bad weather. To be seen more clearly during daylight
hours, turn on your headlights.
Inspect your windshield wipers and
washers frequently. Keep the wind- shield washer reservoir full of the
proper fluid. Have the windshield
wiper blades replaced if they start to streak the windshield or leave parts
unwiped. Use the defroster and air conditioning to keep the windows
from fogging up on the inside (see
pages 128 and 133). Traction — Check your tires
frequently for wear and properpressure. Both are important in
preventing "hydroplaning" (loss of
traction on a wet surface). In the
winter, mount snow tires on all four
wheels for the best handling.
Watch road conditions carefully, they can change from moment tomoment. Wet leaves can be as slip-
pery as ice. "Clear" roads can have
patches of ice. Driving conditionscan be very hazardous when the
outside temperature is near freezing.
The road surface can become covered with areas of water puddles
mixed with areas of ice, so your
traction can change without warning.
Be careful when downshifting. If
traction is low, you can lock up the drive wheels for a moment and cause
a skid. Be very cautious when passing, or
being passed by other vehicles. The spray from large vehicles reduces
your visibility, and the wind buffeting can cause you to lose control.
Driving

Owner Maintenance Checks
You should check the following items at the specified intervals. If
you are unsure of how to perform any check, turn to the page given. Engine oil level — Check every
time you fill the fuel tank. See page 171.
Engine coolant level — Check the
radiator reserve tank every time
you fill the fuel tank. See page 172 .

Windshield washer fluid — Check the level in the reservoir monthly.
If weather conditions cause you to
use the washers frequently, check
the reservoir each time you stop
for fuel. See page 227 . Automatic transmission — Check
the fluid level monthly. See page
228.
Brakes — Check the fluid level
monthly. See page 230 . Tires — Check the tire pressure
monthly. Examine the tread for
wear and foreign objects. See page
245.

Lights — Check the operation of
the headlights, parking lights,
taillights, high-mount brake light,
turn signals, brake lights, and
license plate lights monthly. See

page 250.

Maintenance

Lights

Check the following: Headlights (low and high beam)
Fog lights
Parking lights
Taillights
Brake lights
Turn signals Back-up lights
Hazard light function License plate light
Side marker lights
High-mount brake light
Daytime running lights (Canadian

models)

If you find any bulbs are burned out,

replace them as soon as possible.

Refer to the chart on page 303 to

determine what type of replacement

bulb is needed.

Maintenance
HIGH-MOUNT BRAKE LIGHT
TURN SIGNAL LIGHT

LICENSE PLATE

LIGHTS

STOP/TAIL LIGHTS

BACK-UP LIGHT

Lights

4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.

5. Insert the new bulb into the hole,

making sure the bulb is right side
up and the nubs on the bulb base
fit in the indentations in the headlight assembly. Pivot the hold-
down wire back in place and clip
the end into the slot.

6. Install the rubber seal over the

back of the headlight assembly.
Make sure it is right side up; it is
marked

7. Push the electrical connector onto

the new bulb.
Turn on the headlights to test the new bulb.

Replacing a Fog Light Bulb
Your car uses halogen fog light bulbs. See page 252 for informationon replacing a halogen bulb.

CONTINUED

Maintenance

WEATHER SEAL
BULB
CONNECTOR

HOLD-DOWN WIRE