BODY SERVICE 9-7
DOOR MIRROR
REMOVAL AND INSTALLATION
When removing or installing door mirror, refer to above figure.
1. Door mirror a. Mirror mount screw Tightening order : a →
b →
c
2. Inner garnish b. Mirror mount screw Tightening torque
3. Clip c. Mirror mount screw
a 4.5 N·m (0.45 kg-m)
c 4.5 N·m (0.45 kg-m)
b 4.5 N·m (0.45 kg-m)
2
“A”
“A”
1
3 “A”
BODY SERVICE 9-13
REMOVAL
1) Clean both inside and outside of glass and around it.
2) Remove wiper arms and garnish.
3) Using tape, cover body surface around glass to prevent any
damage.
4) Remove rear view mirror, sunvisor, and front pillar trims (right
& left).
5) If necessary, remove instrument panel. Refer to “INSTRU-
MENT PANEL” in this section.
6) If necessary, remove head lining. Refer to “HEAD LINING” in
this section.
7) Remove (or cut) windshield molding.
8) Drill hole with eyeleteer (1) through adhesive and let piano
string through it.
9) Cut adhesive all around windshield (1) with piano string (2).
When using tool, windshield knife (3), to cut adhesive, be
careful not to cause damage to windshield. Use wire to cut
adhesive along lower part of windshield.
10) Using knife (1), smoothen adhesive (2) remaining on body
side (3) so that it is 1 to 2 mm thick all around.
NOTE:
Use piano string (2) as close to glass as possible so as to
prevent damage to body and instrument panel.
NOTE:
Before using knife (1), clean it with alcohol or the like to
remove oil from it.
