Page 124 of 502
INTERIOR EQUIPMENT
107
NOTICE
Do not load the vehicle beyond the vehiclecapacity weight specified on the tire pressurelabel inside the glove box lid.
Page 342 of 502
STARTING AND DRIVING
325
Anti±lock brake system is not designed to shorten the
stopping distance: Always drive at the moderate speed
and maintain a safe distance from the vehicle in front of
you. Compared with vehicles not fitted with an
anti±lock brake system, your vehicle may require a
longer stopping distance in the following cases:
Driving on rough, gravel or snow±covered roads.
Driving with tire chains installed.
Driving over the steps such as the joints on the road.
Driving on roads where the road surface is pitted or
has other differences in surface height.
Install all 4 tires of specified size at designated
pressure: The anti±lock brake system detects vehicle
speeds using the speed sensors for respective wheels'
turning speeds. The use of tires other than specified
may fail to detect the accurate turning speed, resulting
in a longer stopping distance.
Page 358 of 502

DRIVING TIPS
341
Tires
Ensure that your vehicle's tires are properly inflated.
Adjust the tire pressure to the recommended cold tire
pressure indicated below:
Tire pressure, kPa (kgf/cm
2 or bar, psi)
Front 220 (2.2, 32)
Rear 220 (2.2, 32)
The trailer tires should be inflated to the pressure
recommended by the trailer manufacturer in respect
to the total trailer weight.
Trailer lights
Trailer lights must comply with federal,
state/provincial and local regulations. See your local
recreational vehicle dealer or rental agency for the
correct type of wiring and relays for your trailer.
Check for correct operation of the turn signals and
stop lights each time you hitch up. Direct splicing may
damage your vehicle's electrical system and cause a
malfunction of your lights.
Break±in schedule
Lexus recommends that you do not tow a trailer with
a new vehicle or a vehicle with any new power train
component (engine, transmission, differential, wheel
bearing, etc.) for the first 800 km (500 miles) of
driving.
Maintenance
If you tow a trailer, your vehicle will require more
frequent maintenance due to the additional load. For
this information, please refer to the scheduled
maintenance information in the ªOwner's Manual
Supplement / Maintenance Scheduleº.
Retighten all fixing bolts of the towing ball and bracket
after approximately 1000 km (600 miles) of trailer
driving.
Pre±towing safety check
Check that your vehicle remains level when a loaded
or unloaded trailer is hitched. Do not drive if the
vehicle has an abnormal nose±up or nose±down
condition, and check for improper tongue load,
overload, worn suspension or other possible causes.
Make sure the trailer cargo is securely loaded so that
it cannot shift.
Check that your rear view mirrors conform to any
federal, state/provincial or local regulation. If they do
not, install required rear view mirrors appropriate for
towing purposes.
Page 362 of 502

DRIVING TIPS
345
HOW TO SAVE FUEL AND
MAKE YOUR VEHICLE LAST LONGER
Getting more kilometer/mileage from a liter/gallon of fuel
is easy ± just take it easy. It will help make your vehicle
last longer, too. Here are some specific tips on how to
save money on both fuel and repairs:
Keep your tires inflated at the correct pressure.
Check the pressure every two weeks, or at least once
a month. Underinflation causes tire wear and wastes
fuel.
Do not carry unneeded weight in your vehicle.
Excess weight puts a heavier load on the engine,
causing greater fuel consumption.
Avoid lengthy warm±up idling. Once the engine is
running smoothly, begin driving ± but gently.
Remember, however, that on cold winter days this
may take a little longer.
Accelerate slowly and smoothly. Avoid jackrabbit
starts.
Avoid long engine idling. If you have a long wait
and you are not in traffic, it is better to turn off the
engine and start again later.
Avoid engine overrevving. Use a gear position
suitable for the road on which you are traveling.
Avoid continuous speeding up and slowing
down. Stop±and±go driving wastes fuel.
Page 375 of 502

IN CASE OF AN EMERGENCY
358B: If no steam is coming from your engine:
Leave the engine running and turn off the air
conditioning. Check the following.
Is the cooling fan operating?
Is the coolant in the acceptable range?
Is the engine drive belt O.K.?
CAUTION
When the engine is running, keep hands and clothing
away from the moving fan and engine drive belt.
Do not attempt to remove the radiator cap when the
engine and radiator are hot. Serious injury could
result from scalding hot fluid and steam blown out
under pressure.
If the cooling fan is not operating or the coolant is not in
the acceptable range, turn off the engine and call your
Lexus dealer.
If both conditions are O.K., after the engine coolant
temperature has cooled to normal, continue driving your
vehicle.
If the engine coolant temperature does not cool down, or
your vehicle overheats again, have it checked as soon
as possible by your Lexus dealer.IF YOU HAVE A FLAT TIRE
1. Reduce your speed gradually, keeping a straight line.
Move cautiously off the road to a safe place ± well away
from the traffic. Avoid stopping on the center divider of
a highway. Park on a level spot with firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the pa rking brake and put the transmission
in ºPº.
4. Have everyone get out of the vehicle on the side away
Page 391 of 502
IN CASE OF AN EMERGENCY
37411. After changing the wheel, check the air pressure
of the replaced tire. Stow all the tools, jack and flat
tire securely.
If the pressure of the replaced tire is low, drive slowly to
the nearest service station and fill to the correct
pressure.
Do not forget to reinstall the tire valve cap as dirt and
moisture could get into the valve core and possible
cause air leakage. If the cap is missing, put a new one
on as soon as possible.
This is the same procedure for changing or rotating your
tires.
CAUTION
Before driving, make sure all the tools, jack and flat tire
are securely in place in their storage location to reduce
the possibility of personal injury during a collision or
sudden braking.
Page 407 of 502

MAINTENANCE
390
GENERAL MAINTENANCE
Listed below are the general maintenance items that
should be performed at the intervals specified. It is
recommended that any problem you notice be brought
to the attention of your Lexus dealer or qualified service
shop for their advice.
CAUTION
Make these checks only where adequate ventilation can
be obtained if you run the engine.
Vehicle exterior
Items listed below should be performed from time to
time, unless otherwise specified.
Tire pressure
Check the pressure with a gauge every two weeks, or at
least once a month and adjust as shown on the tire
pressure label. See page 431 for a dditional information.
Tire surface
Check the tires carefully for cuts, damage or excessive
wear. See page 435 for additional information.
Wheel nuts
When checking the tires, make sure to check the nuts for
looseness. Tighten them if necessary. Tire rotation
Rotate
the tires every 12000 km (7500 miles). See page
433 for additional information.
Fluid leaks
Check underneath for leaking fuel, oil, water or other
fluid after the vehicle has been parked for a while. If you
smell fuel fumes or notice any leak, have the cause
found and corrected immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate
smoothly and all latches lock securely. Make sure the
engine hood secondary latch secures the hood when the
primary latch is released.
Page 440 of 502
SECTION 6 ± 3
423
SERVICE PROCEDURES AND
SPECIFICATIONS
Chassis
Specifications424
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking brake fluid 427
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking power steering fluid 428
. . . . . . . . . . . . . . . . . .
Checking tire pressure 431
. . . . . . . . . . . . . . . . . . . . . . . . .
Rotating tires 433
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking and replacing tires 435
. . . . . . . . . . . . . . . . . . .
Installing snow tires and chains 439
. . . . . . . . . . . . . . . . .
Replacing wheels 441
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Aluminum wheel precautions 441
. . . . . . . . . . . . . . . . . . .
Suspension and chassis 442
. . . . . . . . . . . . . . . . . . . . . . .