2000 Lexus ES300 brake light

GAUGES, METERS AND SERVICE REMINDER INDICATORS
62(n) Low fuel level Fill up tank.
warning light
(o) Automatic headlight Take vehicle to leveling system Lexus dealer.
warning light
(p) Key reminder buzzer Remove key.
(a) Brake System Warning Light
This light comes on in the following cases when the
ignition key is turned on.
 When the parking brake is applied...
 When the brake fluid level is low...
Have your vehicle checked at your Lexus dealer in
the following cases.
 The light does not come on even if the parking brake
is applied with the ignition ªONº.
CAUTION
If the light does not go out even after the parking brake
is released during the engine running, immediately stop
your vehicle at a safe place and contact your Lexus
dealer. In this case, the brakes may not work properly
and your stopping distance will be longer. Depress the
brake pedal firmly.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
65
(h) ªABSº Warning Light
The light comes on with the ignition key turned to ªONº.
If the anti±lock brake system and the brake assist
system work properly, the light goes out after a few
seconds. Thereafter, if either of the systems
malfunctions, the light comes on.
When the ªABSº warning light is on (and the brake
system warning light is off), the anti±lock brake system,
the brake assist system, the traction control system
and/or the vehicle skid control system do/does not
operate, but the brake system still operates
conventionally.
When the ªABSº warning light is on (and the brake
system warning light is off), the anti±lock brake system
does not operate so that the wheels could lock up during
a sudden braking or braking on slippery road surfaces.
If the following conditions occur, this indicates a
malfunction somewhere in the parts monitored by
the warning light system. Contact your Lexus
dealer as soon as possible to service the vehicle.
 The light does not come on with the ignition key
turned to ªONº, or remains on.
 The light comes on while driving.
If the light lit during driving goes out and does not come
on again, it is a normal operation.
(i) Open Door Warning Light
This light remains on until all the doors are completely
closed.
(j) Rear Light Failure Warning Light
If this light comes on when the headlight switch is turned
on (at the first or second clickstop), it indicates that one
or more of the tail lights are burned out.
If it comes on when the brake pedal is depressed, one
or more stop lights are burned out.
Have defective bulbs replaced as soon as possible.
(k) Vehicle Skid Control System Warning Lights (Vehicles with Vehicle Skid
Control System only)
These lights warn that there is a problem somewhere in
the vehicle skid control system, traction control system
and brake assist system.
The lights will come on when the ignition key is turned to
ªONº, and will go off after a few seconds.
If the ªVSCº warning light and ªVSC OFFº indicator light
come on, the vehicle skid control system, traction control
system and brake assist system do not work. However,
as conventional braking operates when applied, there is
no problem to continue your driving.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
67
(m) Low Washer Fluid Warning Light
This light comes on when the fluid level in the tank
becomes nearly empty. F ill the tank as soon as possible.
(n) Low Fuel Level Warning Light
This light comes on when the fuel level in the tank
becomes nearly empty. F ill the tank as soon as possible.
On inclines or curves, due to the movement of fuel in the
tank, the low fuel level warning light may come on earlier
than usual.
(o) Automatic Headlight Leveling System Warning Light (Vehicles with
discharge headlight only)
This light warns that when there is a problem
somewhere in the automatic headlight leveling
system.
If it comes on, have your vehicle checked by your Lexus
dealer.
(p) Key Reminder Buzzer
This buzzer reminds you to remove the key when you
open the driver's door with the ignition key in the ªACCº
or ªLOCKº position.
How to check all the service reminder
indicators
(except the low fuel level warning light and low
washer fluid warning light):
1. Apply the parking brake.
2. Open the door.
The following service reminder indicator should come
on. It goes off when you close the door completely.
3. Turn the ignition key to ªACCº.
The following service reminder indicator should come
on. It goes off after 6 seconds.
4. Turn the ignition key to ªONº.
The following service reminder indicators should come
on.
or

or

STARTING AND DRIVING
280
PARKING BRAKE
31E080
To set: Hold the regular brake pedal down with your
right foot. Push down the parking brake pedal with
your left foot.
To release: Hold the regular brake pedal down with
your right foot and push the parking brake pedal
with your left foot. When you lift your left foot, the
parking brake pedal will follow it to the released
position.
Before leaving your vehicle, firmly apply the parking
brake.
CAUTION
Before driving, make sure the parking brake is fully
released and that the parking brake reminder light is off.

STARTING AND DRIVING
281
HOW TO START THE ENGINE
Before cranking
1. Apply the parking brake firmly.
2. Turn off unnecessary lights and accessories.
3. Put the selector lever in ªPº. If you need to restart the
engine while the vehicle is moving, put the selector lever
in ªNº. A starter safety device will prevent the starter
from operating if the selector lever is in any drive
position.
4. Depress the brake pedal and hold it to the floor until
driving off.
Starting the engine
Before starting the engine, be sure to follow the
instructions in ªBefore crankingº.
Normal starting procedure
The multiport fuel injection system/sequential multiport
fuel injection system in your engine automatically
controls the proper air±fuel mixture for starting. You can
start a cold or hot engine as follows:
1. With your foot off the accelerator pedal, crank the
engine by turning the key to ªSTARTº. Release it when
the engine starts.
2. After the engine runs for about 10 seconds, you are
ready to drive. If the weather is below freezing, let the engine warm up
for a few minutes before driving. Do not leave the vehicle
while the engine is warming up.
If the engine stalls ...
Simply restart it , using the correct procedure given in
normal starting.
If the engine will not start
See ªIf your vehicle will not startº on page 337.
NOTICE
Do not crank for more than 30 seconds at a
time. This may overheat the starter and wiringsystems.
Do not race a cold engine.
If the engine becomes difficult to start or stallsfrequently, have the engine checkedimmediately.

STARTING AND DRIVING
301
You can turn off the traction control system by
pushing the ªTRAC OFFº switch. The ªTRAC OFFº
indicator/warning light will then come on. Pushing
the ªTRAC OFFº switch a second time turns the
system back on and extinguishes the ªTRAC OFFº
indicator/warning light.
You may hear a sound in the engine compartment for a
few seconds when the engine is started or just after the
vehicle is started. This means that the traction control
system is in the self
±check mode, and does not indicate
malfunction.
When the traction control system is operating, you may
feel vibration or noise of your vehicle, caused by
operation of the brakes. This indicates the system is
functioning properly.
When getting the vehicle out of mud or new snow, etc.
the traction control system will help operate to prevent
the wheels from spinning.
Traction control failure warning
The ªTRAC OFFº indicator/warning light warns that
when there is a problem somewhere in the traction
control system.
The light will come on when the ignition key is turned to
ªONº, and will go off after a few seconds.
If either of the following conditions occurs, this indicates
malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as
soon as possible to service the vehicle.
 The light does not come after the ignition is turned to
on.
 The light is left on after the ignition is turned to on.
 The light comes on while driving without pushing
ªTRAC OFFº switch.
 The light flashes.
CAUTION
Under certain slippery road conditions, full traction of
the vehicle and power to the front wheels cannot be
maintained, even though the traction control system is
in operation. Do not drive the vehicle under any speed
or maneuvering conditions which will cause the vehicle
to lose traction. In situations where the road surface is
covered with ice or snow, your vehicle should be fitted
with snow tires or tire chains. Always drive at an
appropriate and cautious pace.

STARTING AND DRIVING
302
VEHICLE SKID CONTROLSYSTEM
The vehicle skid control system helps provide
comprehensive control of the systems such as an
anti±lock brake system, brake assist system,
traction control, engine control, etc. This system
automatically controls the output of the brakes or
engine to help prevent the vehicle from skidding
when cornering on a slippery road surface or abrupt
steering wheel operation occurs.
31E013±1

Slip indicator light
If the vehicle is going to skid during driving, the slip
indicator light flashes and an alarm sounds
intermittently.
The vehicle skid control activates when the vehicle
speed is about more than 15 km/h (9 mph). You may hear a sound in the engine compartment for a
few seconds when the engine is started or just after the
vehicle is started. This means that the vehicle skid
control is in the self±check mode and does not indicate
a malfunction.

STARTING AND DRIVING
304These lights warn that there is a problem somewhere in
the vehicle skid control system, traction control system
or brake assist system.
The lights will come on when the ignition key is turned to
ªONº, and will go off after a few seconds.
If the ªVSCº warning light and ªVSC OFFº indicator light
come
on, the vehicle skid control system, traction control
system and brake assist system do not work. However,
as conventional braking operates when applied, there is
no problem to continue your driving.
If either of the following conditions occurs, this indicates
a malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as
soon as possible to service the vehicle:
 The ªVSCº warning light and/or ªVSC OFFº indicator
light do/does not come on after the ignition is turned
to on. 
The ªVSCº warning light and ªVSC OFFº indicator
light are left on after the ignition is turned to on.
 The ªVSCº warning light and ªVSC OFFº indicator
light comes on while driving without pushing ªVSC
OFFº switch.