2000 Lexus ES300 add brake fluid

GAUGES, METERS AND SERVICE REMINDER INDICATORS
61
(a) If parking brake
is off, stop
immediately and
contact Lexus
dealer.
(b) Fasten seat belt.
(Indicator and buzzer)
(c) Take vehicle to Lexus dealer
immediately.
(d) Stop and check.
(e) Stop and check. (f) Add engine oil.
(g) Take vehicle to
Lexus dealer.
(h) Take vehicle to Lexus dealer.
(i) Close all doors.
(j) Replace bulb.
(k) Take vehicle to Lexus dealer.
(l) Take vehicle to Lexus dealer.
(m) Add washer fluid.
or
or
and
w069

MAINTENANCE
378
Engine compartment
Items listed below should be checked from time to
time, e.g. each time when refueling.
Washer fluid
Make sure there is sufficient fluid in the tank. See page
459 for additional information.
Engine coolant level
Make sure the coolant level is between the ªFULLº and
ªLOWº lines on the see±through reservoir when the
engine is cold. See page 407 for additional information.
Battery
Your Lexus has a maintenance free battery. You do not
have to add distilled water. For longer life of the battery,
however, see page 443 for additional information.
Brake fluid level
Make sure the brake fluid level is correct. See page 416
for additional information.
Engine oil level
Check the level on the dipstick with the engine turned off
and the vehicle parked on a level spot. See page 402 for
additional information.
Power steering fluid level
Check the level through the reservoir. The level should
be in the ªHOTº or ªCOLDº range depending on the fluid temperature. See page 418 for additional information.
Exhaust system
If you notice any change in the sound of the exhaust or
smell exhaust fumes, have the cause located and
corrected immediately.
(See engine exhaust cautions in
Section 3±1.)

INTRODUCTION
389
Checking brake fluid
Parts (if level is low):

FMVSS No. 116 DOT 3 or SAE J1703 brake fluid
Tools:

Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):

Automatic transmission fluid DEXRON
II or III
Tools:

Rag or paper towel

Funnel (only for adding fluid)
Checking battery condition
Non±maintenance batteries
Tools:

Warm water

Baking soda

Grease

Conventional wrench (for terminal clamp bolts)
Maintenance type batteries
Parts (if level is low):

Distilled water
Tools:

Warm water

Baking soda

Grease

Conventional wrench (for terminal clamp bolts)

Coin (for vent plugs)

Funnel (only for adding distilled water)

CHASSIS
417


Vehicles equipped with traction control system
To check the fluid level, simply look at the
see±through
reservoir. The level should be between
the ªMAXº and ªMINº lines on the tank.
It is normal for the brake fluid level to go down slightly as
the brake pads wear. So be sure to keep the reservoir
filled.
If the reservoir needs frequent refilling, it may indicate a
serious mechanical problem.
If the level is low, add FMVSS No.116 DOT 3 or SAE
J1703 brake fluid to the brake reservoir.
Remove and replace the reservoir cap by hand. Add
brake fluid up to the ªMAXº line.
Use only newly opened brake fluid. Once opened, brake
fluid absorbs moisture from the air, and excess moisture
can cause a dangerous loss of braking efficiency.
CAUTION
Take care when filling the reservoir because brake fluid
can harm your hands or eyes and damage painted
surfaces. If fluid gets in your hands or eyes, flush them
with clean water.