2000 Citroen C5 torque

Downloaded from www.Manualslib.com manuals search engine HYDRAULIC
SYSTEM
237
B4BP01CDB4DP003D
HYDRAULIC SPECIFICATIONS
Hydractive 3+ regulator
(40) Slimline sphere.
(39) Hydractive regulator.
(38) Electrovalve.
(41) Depressurisation screw.Hydraulic unions
ReferenceTube diameter Tightening torque
(mm) m.daN
G 3.5
1.5 ± 0.3
H 6.35
J 10 2.5 ± 0.5

Downloaded from www.Manualslib.com manuals search engine HYDRAULIC
SYSTEM
SPECIFICATION - IDENTIFICATION : SUSPENSION SPHERES
Special features
Identification.
- Fitting of new slimline spheres with multilayer membranes, stone grey in colour.
- It is forbidden to recharge or overhaul this type of sphere.
- The number marked on the suspension sphere is the reference no. of the component and not the Part No.
- The two-figure number marked on the suspension sphere indicates the initial inflation pressure value.
Example :
- The pressure value of this type of suspension sphere is given merely as a guide.
- When checking, the value read could be higher than the nominal value.
NOTE : Suspension cylinders on the same axle should be equipped with the same type of membranes.
Tightening torques for these spheres : 2,7 ± 0,5 m.daN.
238
Suspension
sphere marking
96 420 906 80 AG2 066 0 13h59 57Batch of steel Day
of manufactureYea r
of manufactureTime
of manufacturePressure rating
(Bars)

Downloaded from www.Manualslib.com manuals search engine 245
AIR
CONDITIONING
SPECIAL FEATURES : AIR CONDITIONING SYSTEM (R 134.a)
Tightening torques (m.daN).
Unions
Steel / Steel
Aluminium / Steel Ø Pipes
1.7 ± 3
1.3 ± 3 M 06
3.8 ± 3
2 ± 2 M 08
4 ± 3
2.5 ± 3 M 10
NOTE :For operations concerning draining, drying (empty), checking and refilling of a system: refer to BRE 0290.
WARNING : For R 134.a quantities : (see table on page: 250). NOTE : : Tighten the unions to the recommended torques using a retaining spanner whenever possible

Downloaded from www.Manualslib.com manuals search engine C5HP16EC
SPECIAL FEATURES : AIR CONDITIONING SYSTEM (R 134.a)
Condenser with integral reservoir (continued)
WARNING :The reservoir (6)contains a drying agent. As soon as the black protection is removed, the reser-
voir must be mounted in the base (8), otherwise there is a risk of damaging the air conditioning circuit.
Screwing the reservoir (6) into the base (8).
- Screw the reservoir(6)manually, until the neck of the reservoir(6) is in contact with the bottom of the
base (8).
- Tighten with a torque spanner and tool [2]at(2)to 1.3 ± 0.1 m.daN.
Fitting the plastic bracket. (New, from the replacement parts kit).
Proceed in the opposite order to removal, tighten the screw(3)to 0.15 m.daN.
AIR
CONDITIONING
249