Downloaded from www.Manualslib.com manuals search engine SPECIFICATIONS OF POWER-ASSISTED STEERING
222
Engines : 6FZ - RFN - RLZ - XFX - RHY - RHZ - 4HX
AXLES
SUSPENSION
STEERING
B3EP127D
Engines
Engines
6FZ RFR RJX
RHY RHZ 4HX
XFXZF
SAGINAWFalling
Constant100 bars 129 mm Supplier Flow type Adjustment pressure Pulley diameter Steering rack
travel
(mm)Pinion RackNumber of
turns of the
wheelSteering
ratio
Inner OuterAngle of lock Number of teeth
6FZ RFR
RJX RHY RHZ2x83
XFX 4HX2x74 3 34.29° 31.58°50.4/139.74° 35.65°
9333.3
Tightening torques m.daN
Engines EW-DW ES9J4
(12) Vis(13) Vis
(14) Vis2.2 ± 0.3 2.5 ± 0.6
Engine XFX : A converter, integral with the valve,
modulates the assistance according to the vehicle
speed.
Length of steering rods (Adjustment)
between ball-joints =362 mm.
Power-assisted steering hydraulic circuit.
The oil supplies both the steering circuit and the
suspension circuit. Petrol engine : A power-assisted steering pressure switch
is installed on the hydraulic piping, between the high
pressure pump and the steering valve.
Downloaded from www.Manualslib.com manuals search engine AIR
CONDITIONING
250
ESSENTIAL: The compressor lubricant is extremely hygroscopic; always use FRESH oil.
SPECIAL FEATURES : AIR CONDITIONING SYSTEM (R 134.a)
Compressor lubricant.
Checking the compressor oil level.
There are three specific cases :
- 1/Repairs to a system without leaks.
- 2/Slow leak.
- 3/Fast leak.
1/ Repairing a system without leaks..
a) - Using draining/recovery equipment not fitted with an oil decanter.
- Drain the system as slowly as possible via the LOW PRESSURE valve, so as not to lose any oil.
- No more oil should be added when filling the system with R 134.a fluid.
b) - Using draining/filling equipment fitted with an oil decanter.
- Drain the R 134.a fluid from the system in accordance with the instructions in the equipment handbook.
- Measure the amount of oil recovered.
- Add the same amount of NEW oil when filling the system with R 134.a fluid.
c) - Replacing a compressor.
- Remove the old compressor, drain it and measure the oil quantity.
- Drain the new compressor (supplied full), so that the same amount of NEW oil is left in the compressor as was in the old compressor.
- No more oil should be added when filling the system with R 134.a fluid.
