1999 TOYOTA CAMRY a541e

SS0BM±01
± SERVICE SPECIFICATIONSAUTOMATIC TRANSAXLE (A541E)
SS±57
220 Author: Date:
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
Front engine front mounting insulator x Front frame assemblyTMC:
TMMK:
Green color bolt
Silver color bolt80

66
44820

670
45059

48
32
Rear engine mounting insulator x Front frame assembly8082059
LH transaxle mounting insulator x Transaxle6465047
Engine mounting absorber x Front frame assembly4849035
Transaxle x Engine 17 mm bolt6667048
Transaxle x Engine 12 mm bolt4849035
Torque converter clutch x Drive plate4142030
Valve body x Transaxle case1111 08
Oil strainer x Valve body1111 08
Oil pan x Transaxle case7.88069 in.´lbf
Oil pan drain plug4950036
Park/Neutral position switch x Transaxle case (bolt)5.45548 in.´lbf
Park/Neutral position switch (nut)6.97061 in.´lbf
B3 apply pipe retainer1111 08
Connector clamp1111 08
Manual valve body x Transaxle case1111 08
Detent spring x Manual valve body1111 08
Oil pipe bracket101007
Steering gear housing x Front suspension member1811,850134
Stabilizer bar bracket1919514
Vehicle speed sensor x Transaxle case4.95043 in.´lbf
Direct clutch speed sensor x Transaxle case1111 08
Transfer lubrication apply pipe retainer1111 08
Exhaust manifold bracket x Transaxle case Except California
California20
34200
35014
25
Exhaust manifold plate Except California
California20
34200
35014
25
Front frame x Body 19 mm1811,850134
Front frame x Body 14 mm3233024
Front frame x Body Nut3637027
Exhaust front pipe x Exhaust center pipe5657041
Exhaust manifold x Exhaust front pipe6263046
Exhaust front pipe support stay x Exhaust front pipe support bracket3333024
Exhaust pipe support x Front frame3333024
Starter x Torque converter clutch housing3940029
Transaxle control shaft lever x Park/neutral position switch1515011
Throttle cable adjusting nut1515011
Drive plate x Crankshaft8385061
Shift control cable x Transaxle control shaft lever1515011
Throttle cable retaining plate set bolt5.45548 in.´lbf
Shift solenoid valve No.1, No.2, SL, SLN x Valve body6.66758 in.´lbf

SS±58
± SERVICE SPECIFICATIONSAUTOMATIC TRANSAXLE (A541E)
221 Author: Date:
Front wheel nut1031,05076
Exhaust front pipe support bracket x Body2121015
PS reseroir pipe x Front frame101007
Engine hood x Hood hinge2626519

SR06K±01
W03335
Ignition Key
W03336
SR±14
± STEERINGTILT STEERING COLUMN
2109 Author: Date:
INSPECTION
1. INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.
2. IF NECESSARY, REPLACE KEY CYLINDER
(a) Place the ignition key at the ACC position.
(b) Push down the stop pin with a screwdriver, and pull out
the cylinder.
(c) Install a new cylinder.
HINT:
Make sure the key is at the ACC position.
3. INSPECT IGNITION SWITCH
(See page BE±14)
4. IF NECESSARY, REPLACE IGNITION SWITCH
(a) Remove the 2 screws.
(b) Install a new switch with the 2 screws.
5. INSPECT KEY UNLOCK WARNING SWITCH
(See page BE±14)
6. IF NECESSARY, REPLACE KEY UNLOCK WARNING
SWITCH
(a) Slide out the switch.
(b) Install a new switch.
7. A/T:
INSPECT KEY INTERLOCK SOLENOID
(A140E: See page AX±13)
(A541E: See page AX±17)
8. A/T:
IF NECESSARY, REPLACE KEY INTERLOCK SOLE-
NOID
(a) Remove the 2 screws.
(b) Install a new solenoid with the 2 screws.
9. w/ ENGINE IMMOBILISER SYSTEM:
INSPECT TRANSPONDER KEY COIL
(See page BE±128)
10. w/ ENGINE IMMOBILISER SYSTEM:
IF NECESSARY, REPLACE TRANSPONDER KEY
COIL
11. w/ ENGINE IMMOBILISER SYSTEM:
IF NECESSARY, REPLACE TRANSPONDER KEY AM-
PLIFIER
(a) Remove the 2 screws.
(b) Install a new key amplifier with the 2 screws.

Toyota Supports ASE CertificationPage 1 of 1
TC001-02Title:
AUTOMATIC TRANSMISSION FLUID
REQUIREMENTS
Models:
All '00 ± '02 Models & '03 Corolla & Matrix
Technical Service
BULLETIN
May 24, 2002

Please refer to the following table for correct application of Dexron
III (Dexron II) and
Toyota Type T±IV Automatic Transmission Fluids or equivalent.
MODEL2000200120022003
AvalonA541EA541EA541EN/A
CamryA140E, A541EA140E, A541EU140E, U241EN/A
CelicaU240E, U341EU240E, U341EU240E, U341EN/A
CorollaA131L, A245EA131L, A245EA131L, A245EA245E
ECHOU340EU340EU340EN/A
HighlanderN/AU140E, U140F,
U241EU140E, U140F,
U241EN/A
Land CruiserA343FA343FA343FN/A
RAV4A247EA540HU140F, U241EU140F, U241EN/A
SequoiaN/AA340E, A340FA340E, A340FN/A
SiennaA540EA541EA541EN/A
SolaraA140E, A541EA140E, A541EA140EU241EN/A
TacomaA340E, A340F, A43DA340E, A340F, A44DA340E, A340F, A44DN/A
TundraA340E, A340FA340E, A340FA340E, A340FN/A
4RunnerA340E, A340FA340E, A340FA340E, A340FN/A
MatrixN/AN/AN/AA246E
MatrixN/AN/AN/AU240E
MatrixN/AN/AN/AU341F
PriusN/AP111P111N/A
LEGEND
Type T±IV Fluid
Dexron III (Dexron II)
PART NUMBERPART NAME
08886±81015ATF Type T±IV
00718±ATF00Dexron III (Dexron II)
OP CODEDESCRIPTIONTIMEOPNT1T2
N/ANot Applicable to Warranty±±±±
TRANSMISSION & CLUTCH
Introduction
Parts
Information
Warranty
Information

TSB
IntroductionTo prevent overheating of the transmission when towing a weight of more than 1,000
pounds, a transmission oil cooler should be installed. The transmission oil cooler and
required hardware for installation are available through normal parts supply.
TowingUp to 2,000 pounds (with transmission cooler installed).
Capacity
Affected1997 Camrys with A541E Automatic Transmissions.
Vehicles
Parts
Information
Warranty
Information
TRANSMISSION & CLUTCH
October 17, 1997
Title:
TRANSMISSION OIL COOLER INSTALLATION
Models:
'97 CAMRY WITH A541E ATM
Page 1 of 6
TC003±97
Clip
Hose
Clamp
Oil Cooler Assembly
Front Suspension Member
Oil Cooler Tube No. 1Oil Cooler Tube No. 2
Side Member
PART NUMBER PART NAME QTY
32910±33040 Oil Cooler Assembly 1
32907±33050 Oil Cooler Tube No. 2 1
32907±33090 Oil Cooler Tube No. 1 1
90445±17101 180 mm (7.09º) Oil Cooler Hose 1
90445±17069 190 mm (7.48º) Oil Cooler Hose 1
90445±17139 130 mm (5.12º) Oil Cooler Hose 3
90445±17151 140 mm (5.51º) Oil Cooler Hose 1
90119±06518 Bolt 3
91611±60816 Bolt 2
90467±16013 Hose Clamp with installation clip 12
90179±06058 Nut 1
OPCODE DESCRIPTION TIME OPN T1 T2
N/A Not applicable to warranty ± ± ± ±
Fig. 1
Toyota Supports ASE Certification

AUTOMATIC TRANSMISSION SERIAL NUMBERSPage 2 of 3
* Exception: 1991 ± K, 1992 (January±March) ± M, 1992 (April±December) ± B
NOTE: Remanufactured transmissions also have an additional serial number.
TRANSMISSION TRANSMISSION
LOCATION
MODEL SERIAL NUMBER
6 A 00001
50001
5-Digit Serial No.
Manufacturing Month:
A thru M (ªIº not used)
Last Digit of
Manufacturing Year:
1996
D 01 00001
5-Digit Serial No.
Manufacturing Month:
Manufacturing Year:
A541E:
`93-A, `94-B, `95-C
A540E, A540H:
`90-A, `91-B, `92-C
6 A 00001
5-Digit Serial No.
Manufacturing Month:
A thru M (ªIº not used)
Last Digit of
Manufacturing Year:
1996
A140#
A130L
A131L
(TMC Product)
A132#
A54#E
A540H
A44##
F A 50001
5-Digit Serial No.
Manufacturing Month:
A thru M (ªIº not used)
*Manufacturing Year:
`93-C, `94-D, `95-E
6 01 00001
5-Digit Serial No.
Manufacturing Month:
Last 2 Digits of
Manufacturing Year:
1996