F03716
N·m (kgf·cm, ft·lbf): Specified torque
Non–reusable partPressure Port Union
Shorter Straight Pin
O–Ring Snap Ring O–Ring
Longer Straight PinSide Front Plate
Flow Control Valve
Spring
Oil Seal
Front HousingSuction Port UnionVane Pump
Shaft
Power steering fluid
69 (700, 51)
13 (130, 9)
O–Ring
O–Ring
O–Ring Snap Ring
Cam Ring
Rear Housing
Wave Washer O–Ring
Side Rear Plate Vane Pump RotorVane Plate
x10
– STEERINGPOWER STEERING VANE PUMP (2C–T, 2C–TE,
1CD–FTV)SR–7
F01315
Round End
F01316
F03722
Press
– STEERINGPOWER STEERING VANE PUMP (2C–T, 2C–TE,
1CD–FTV)SR–15
7. INSTALL VANE PLATES
Install the 10 plates with the round end facing outward.
8. INSTALL SIDE REAR PLATE
(a) Coat a new O–ring with power steering fluid and install it
to the side rear plate.
(b) Align the holes of the plate and 2 straight pins, and install
the plate.
9. INSTALL WAVE WASHER
Install the washer so that its protrusions fit into the slots in the
side rear plate.
10. INSTALL REAR HOUSING
(a) Coat a new O–ring with power steering fluid and install it
to the rear housing.
(b) Install the housing and use a press to push down on the
wave washer hard enough to compress it.
NOTICE:
Do not apply too much pressure.
Be careful not to damage the O–ring.
(c) Install a new snap ring.
11. INSTALL SPRING AND FLOW CONTROL VALVE
Install the valve facing the correct direction
(See page SR–6).
12. INSTALL PRESSURE PORT UNION
(a) Coat a new O–ring with power steering fluid and install it
to the pressure pore union.
(b) Install the union.
Torque: 69 N·m (700 kgf·cm, 51 ft·lbf)
13. INSTALL SUCTION PORT UNION
(a) Coat a new O–ring with power steering fluid and install it
to the suction port union.
(b) Install the bolt.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
14. MEASURE PS VANE PUMP ROTATING TORQUE
(See page SR–9)
