1999 SUBARU LEGACY specifications

[x] Cancel search: specifications

Page 36 of 1456

SUBARU LEGACY 1999  Service Repair Manual CAUTION:
Never rotate idle adjusting screw. If idle speed
is out of specifications, refer to General On-
board Diagnosis Table under ª2-7 On-Board
Diagnostics II Systemº.
<Ref. to 2-7 [T6A0].>4. Eng

Page 37 of 1456

SUBARU LEGACY 1999  Service Repair Manual CAUTION:
Never rotate idle adjusting screw. If idle speed
is out of specifications, refer to General On-
board Diagnosis Table under ª2-7 On-Board
Diagnostics II Systemº.
<Ref. to 2-7 [T6A0].>4. Eng

Page 54 of 1456

SUBARU LEGACY 1999  Service Repair Manual 7) Turn crankshaft pulley clockwise until arrow
mark on camshaft sprocket is set to position shown
in figure.
B2M1233A
8) Ensure that #1 cylinder intake valve and #3 cyl-
inder exhaust valve are adjus

Page 55 of 1456

SUBARU LEGACY 1999  Service Repair Manual 1. Engine
A: SPECIFICATIONS
EngineModel2200 cc
TypeHorizontally opposed, liquid cooled, 4-cylinder, 4-stroke
gasoline engine
Valve arrangement Belt driven, single over-head camshaft, 4-valve/cylinder

Page 56 of 1456

SUBARU LEGACY 1999  Service Repair Manual Cylinder
headSurface warpage limit 0.05 mm (0.0020 in)
Surface grinding limit 0.3 mm (0.012 in)
Standard height 97.5 mm (3.839 in)
Valve
setRefacing angle 90É
Contacting widthIntakeSTD 1.0 mm (0.039

Page 57 of 1456

SUBARU LEGACY 1999  Service Repair Manual Piston
ringPiston ring gapTop ringSTD 0.20 Ð 0.35 mm (0.0079 Ð 0.0138 in)
Limit 1.0 mm (0.039 in)
Second ringSTD 0.37 Ð 0.52 mm (0.0146 Ð 0.0205 in)
Limit 1.0 mm (0.039 in)
Oil ringSTD 0.20 Ð 0.5

Page 58 of 1456

SUBARU LEGACY 1999  Service Repair Manual Crank-
shaftBend limit 0.035 mm (0.0014 in)
Crankpin and crank journalOut-of-roundness 0.030 mm (0.0012 in) or less
Grinding limit 0.250 mm (0.0098 in)
Crankpin outer diameterSTD 51.984 Ð 52.000 mm (

Page 72 of 1456

SUBARU LEGACY 1999  Service Repair Manual IPress-in the push adjuster rod gradually tak-
ing more than three minutes.
IDo not allow press pressure to exceed 9,807
N (1,000 kg, 2,205 lb).
IPress the adjuster rod as far as the end sur-
face of
Page:   1-8 9-16 17-24 25-32 33-40 ... 136 next >