STEERING – Power Steering Gear Box37A-13
2. Cover rack serrations with special tool.
3. Apply the specified fluid on the special tool.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
4. Match the oil seal centre with rack to prevent retainer
spring from slipping and slowly insert rack from power
cylinder side.
EOIL SEAL / RACK BUSHING INSTALLATION
1. Apply the specified fluid to the outer surface of the oil
seal. Press-fit the oil seal using the special tool until it
is flush with the bushing end face.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
2. Apply the specified fluid to the oil seal inner surface and
the O-ring.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
3. Wrap the rack end with plastic tape, and push the rack
bushing onto the rack.
FCIRCLIP INSTALLATION
Insert the circlip to the rack stopper hole through the cylinder
hole. Turn the rack stopper clockwise and insert the circlip
firmly.
Caution
Insert the circlip to the rack stopper hole while turning
the rack stopper clockwise.
GOIL SEAL / BALL BEARING INSTALLATION
1. Apply a coating of the specified fluid to the outside of
the oil seal. Using the special tools, press the oil seal
into the valve housing.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
MB991214
Oil seal
Oil seal
MB990927
Rack
bushingO-ring
Rack bushingPlastic tape
Circlip
SlotCirclip
Slot
Oil sealMB990938
MB991203
STEERING – Power Steering Gear Box37A-14
2. Apply a coating of the specified fluid to the outside of
the ball bearing. Using the special tools, press the ball
bearing into the valve housing.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
HSEAL RING INSTALLATION
1. Kneed the seal ring to soften it.
2. Apply the specified fluid to the seal ring, and install to
the rack groove.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
3. Insert the tapered side of the special tool from the pinion
gear side, and compress the seal ring.
IOIL SEAL INSTALLATION
Use the special tool to press the oil seal into the valve housing.
The upper surface of the oil seal should project outwards
approx. 1 mm from the housing edge surface.
Caution
If the oil seal is flush with or lower than the housing
edge, it will cause oil leaks and require reassembly.
JEND PLUG INSTALLATION
1. Apply the specified sealant to the threaded part of the
end plug.
Specified sealant:
3M ATD Part No.8661 or equivalent
2. Secure the threaded portion of the end plug at two places
by using a punch.
KTOTAL PINION TORQUE ADJUSTMENT
1. Position the rack at its centre. Tighten the rack support
cover to 15 Nm.
2. In neutral position, rotate the pinion shaft clockwise one
turn/4 – 6 seconds with the special tool. Return the rack
support cover 30 – 60 and adjust torque to the standard
value.
Ball bearingMB990938
MB991203
Pinion gearMB991317
Tapered side
Approx. 1 mmMB990941
End plug
SealantEnd plug
MB991006
