Page 57 of 432
SWITCHES
39
REAR WINDOW AND OUTSIDEREAR VIEW MIRRORDEFOGGER SWITCH
To turn the electric rear window defogger on, push the
switch.
The ignition key must be in the ºONº position.
The thin heater wires on the inside of the rear window and the
heater panels in the outside rear view mirrors will quickly
clear the surface. An indicator light is on when the defogger
is operating.
The system will automatically shut off when the defogger has
operated about 15 minutes.
Page 58 of 432
SWITCHES
40
CAUTION
Since the mirror surfaces can get hot, keep your hands off
them when the switch is on.
If further defrosting or defogging is desired, simply actuate
the switch again. When the surface has cleared, push the
switch once again to turn the defogger off. Continuous use
may cause the battery to discharge, especially during
stop±and±go driving. The defogger is not designed to dry rain
water or to melt snow.
If the outside rear view mirrors are heavily coated with ice,
use a spray de±icer before operating the switch.
NOTICE
When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires.
To prevent the battery from being discharged, do not
operate the defogger continuously longer than
necessary.
POWER WINDOW SWITCHES
Page 59 of 432
SWITCHES
41
To raise or lower the windows, use the switch on each door.
The passenger's window can also be controlled by the
switch on the driver's door.
The power windows work when the ignition key is in the
ºONº position.
Key off operation: Even if the ignition key is turned to the
ºACCº or ºLOCKº position, the window can be operated
until any of the doors is opened (or for about 60 seconds).
Page 60 of 432
SWITCHES
42
Operating the driver's switch
To raise or lower the windows, pull the switch halfway up
or push it halfway down.
Automatic operation: To fully lower the window
automatically, push the switch fully down.
To stop the window partway, lightly pull the switch in the
opposite direction and then release it.
Page 61 of 432
SWITCHES
43
Operating the passenger's switch
To lower the window, push the switch down. Pull it up to
raise the window. The window moves as long as the switch
is operated.
With the ºWINDOW LOCKº switch pressed in, only the
driver's window can be raised or lowered.
The indicator lights on the switch tell you which of the
switches can be operated.
Page 62 of 432
SWITCHES
44
CAUTION
To avoid serious personal injury, you must do the following.
Always make sure the head, hands and other parts of the
body of all occupants are kept completely inside the vehicle
before you close the power windows. If someone's neck,
head or hands gets caught in a closing window, it could
result in a serious injury. When anyone closes the power
windows, be sure that they operate the windows safely.
When small children are in the vehicle, never let
them use the power window switches without
supervision. Use the ºWINDOW LOCKº switch to
prevent them from making unexpected use of the
switches.
Never leave small children alone in the vehicle,
especially with the ignition key still inserted. They
could use the power window switches and get
trapped in a window. Unattended children can
become involved in serious accidents.EMERGENCY FLASHER
SWITCH
Page 63 of 432
SWITCHES
45
To turn on the emergency flashers, push the switch.
All the turn signal lights will flash. The emergency flashers
will work with the engine running or off and with or without
the ignition key.
Turn on the emergency flashers to warn other drivers if you
must stop your vehicle where it might be a traffic hazard.
Always pull your vehicle as far off the road as possible.
The turn signal light switch will not work when the
emergency flashers are in operation.
NOTICE
To prevent the battery from being discharged, do not leave
the switch on longer than necessary when the engine is
not running.
SEAT HEATER SWITCHES
Page 64 of 432
SWITCHES
46
The seat heater has two switches. Push these switches on
the left side to turn the respective seat heater on, and push
the switches on the right side to turn them off.
The ignition key must be in the ºONº position.